reset INFINITI QX60 HYBRID 2014 Quick Reference Guide

23
24
26
25
292827
17181920
21
121315
22
*See your Owner’s Manual for information.
01 INSTRUMENT BRIGHTNESS
CONTROL SWITCHES*
02 BACKUP COLLISION INTERVENTION
(BCI) SWITCH*
03 TWIN TRIP ODOMETER RESET SWITCH*
04 VEHICLE INFORMATION DISPLAy
05 HEADLIGHT AND TURN SIGNAL SWITCH
06 EV INDICATOR LIGHT
07 LOW TIRE PRESSURE WARNING LIGHT
08 WINDSHIELD WIPER AND
WASHER SWITCH
09 VEHICLE INFORMATION
DISPLAy SWITCH
10 STEERING WHEEL SWITCHES FOR
AUDIO*/BLUETOOTH®/NAVIGATION
11 INTELLIGENT CRUISE CONTROL
12 VEHICLE DyNAMIC CONTROL
(VDC) OFF SWITCH*
13 POWER LIFTGATE SWITCH
14 POWER LIFTGATE MAIN SWITCH

01
04
070605
09
08
02
03
15 DyNAMIC DRIVER ASSISTANCE
CONTROL SWITCH*
16 TILT/TELESCOPIC STEERING
WHEEL SWITCH*
17 HEADLIGHT AIMING
CONTROL SWITCH*
18 WARNING SySTEMS SWITCH
19 HEATED STEERING WHEEL SWITCH*
20 POWER INVERTER SWITCH
21 HOOD RELEASE*
22 CONTROL PANEL DISPLAy SCREEN*
23 CLIMATE CONTROL SySTEM
24 AUDIO SySTEM
25 FRONT PASSENGER AIR BAG
STATUS LIGHT*
26 POWER OUTLET
27 DRIVER’S CLIMATE CONTROLLED
SEAT SWITCH*
28 INFINITI DRIVE MODE SELECTOR*
29 PASSENGER’S CLIMATE
CONTROLLED SEAT SWITCH*
1110
Behind
steering wheel
Behind
steering wheel Behind
steering wheel
16
14
1591600_14b_Infiniti_QX60_HEV_QRG_092413.indd 39/24/13 11:43 AM

8
Accessing the Front Cup Holders
To open the cup holders, push the lid 01 down
and release.
For more information, refer to the “Instruments and controls (section 2)” of
your Owner’s Manual.
01
essential information
Loose Fuel Cap
A LOOSE FUEL CAP warning message will appear
in the vehicle information display

01 when the
fuel-filler cap is not tightened correctly.

To tighten, turn the cap clockwise until a single
click is heard.

The warning message will disappear when the vehicle
detects the fuel-filler cap is properly tightened and the
reset button

02 is pressed for about 1 second.
If the cap is not properly tightened, the Malfunction Indicator Light
may illuminate.
For more information, refer to the “Instruments and controls (section 2)” and the “Pre-driving checks and adjustments
(section 3)” of your Owner’s Manual.
01
02

When the low tire pressure warning light flashes for approximately 1 min\
ute and then remains
on, the TPMS is not functioning properly. Have the system checked by an \
INFINITI retailer.

Tire pressure rises and falls depending on the heat caused by the vehicl\
e’s operation and the
outside temperature. Low outside temperature can lower the temperature o\
f the air inside
the tire, which can cause a lower tire inflation pressure. This may caus\
e the low tire pressure
warning light to illuminate. If the warning light illuminates, check the\
tire pressure in your tires.
• Check the tire pressure (including the spare tire) often and always pr\
ior to long distance trips.

The Tire and Loading Information label contains valuable information. Pl\
ease refer to
section 9, “Technical and consumer information” in your Owner’s\
Manual for the location
of the Tire and Loading Information label.
For more information, refer to the “Instruments and controls (section 2)”, the “Starting and driving (section 5)” and the
“Maintenance and do-it-yourself (section 8)” of your Owner’s Manual.
Front Armrest/Center Console Storage Box
To access the top storage bin, pull up on the driver’s
side lever

01.
To access the bottom storage bin, pull up on the
passenger’s side lever

02.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
0102
Fuel-filler Door
The fuel-filler door is located on the driver’s side of the vehicle.
The fuel-filler door automatically locks/unlocks
when the driver’s door is locked/unlocked.

To open the fuel-filler door, push the right side of
the fuel-filler door and release.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
1591600_14b_Infiniti_QX60_HEV_QRG_092413.indd 89/24/13 11:43 AM

first drive features
20
Conventional (Fixed Speed) Cruise Control
The cruise control system enables you to set a
constant cruising speed once the vehicle has
reached 25 MPH (40 km/h).

The system will automatically maintain the set
speed until you tap the brake pedal, accelerate,
cancel or turn the system off.

To activate the cruise control, push the
CRUISE

ON/OFF switch
01. The
CRUISE
indicator light in the instrument panel will illuminate.

To set cruising speed, accelerate the vehicle to the desired speed, push\
the COAST/SET
switch
02 and release. The
SET indicator light
in the instrument panel will illuminate. Take
your foot off the accelerator pedal. your vehicle will maintain the set speed.

To reset at a faster cruising speed, push and hold the ACCEL/RES switch 03. When the
vehicle attains the desired speed, release the switch.

To reset at a slower cruising speed, push and hold the COAST/SET switch 02. Release the
switch when the vehicle slows to the desired speed.

To cancel the preset speed, push the CANCEL switch
04.

To turn off cruise control, push the CRUISE
ON/OFF switch
01. Both the
CRUISE indicator
light and the SET indicator light in the instrument panel will turn off.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
0102
03
04
USB/iPod® Interface

The USB jack
01 is located in the center
console under the arm rest.

When a compatible USB memory device or
iPod® is plugged into the USB jack, compatible
audio and video files stored on the device can be
played through the vehicle’s audio system and
front display.
For more information, refer to the “Monitor, climate, audio, phone and voice
recognition systems (section 4)” of your Owner’s Manual.
01
04 STATION PRESET BUTTONS

Twelve stations can be set for the FM band, six for the AM band and eigh\
teen for XM
Satellite Radio.

To store a station in a preset, you must first select a radio band by pr\
essing the FM•AM

05 or XM
06 button, then tune to the desired FM, AM or XM Satellite Radio station.
Then press and hold the desired station preset button (1-6) until the preset number is
updated on the display and the sound is briefly muted. The channel indic\
ator will then
display and the sound will resume. Programming is now complete.

To retrieve a previously set station, select the radio band where the pr\
eset was stored
then press the corresponding station select button (1-6).
For more information, refer to the “Monitor, climate, audio, phone and voice recognition systems (secti\
on 4)” of your
Owner’s Manual.
1591600_14b_Infiniti_QX60_HEV_QRG_092413.indd 209/24/13 11:43 AM

21
Intelligent Cruise Control (ICC) System (if so equipped)
VEHICLE-TO-VEHICLE DISTANCE CONTROL MODE

To set Vehicle-To-Vehicle Distance Control mode,
press the CRUISE ON/OFF button
01 for less than
1.5 seconds. The CRUISE indicator light 02
will illuminate.

Accelerate to the desired speed.

Push down on the COAST/SET switch
03 and
release it. Cruise control will be set to the
desired speed.

Press the distance button 04 repeatedly to change
the set distance between long, middle, and short.

When a vehicle is not detected ahead of you in the
lane, the set distance and set vehicle speed
indicator lights will illuminate

05 in set mode.

When a vehicle is detected ahead of you in the lane,
the vehicle ahead detection, set distance, and set vehicle speed
indicator lights will illuminate
06 in set mode.

To reset at a faster cruising speed, push and hold the ACCEL/RES
switch

07. When the vehicle attains the desired speed, release the switch.

To reset at a slower cruising speed, push and hold the COAST/SET switch


03. Release the switch when the vehicle slows to the desired speed.

To cancel the preset speed, push the CANCEL switch
08 or tap the brake pedal. The set
vehicle speed indicator
05 will go out.

To turn off cruise control, press the CRUISE ON/OFF button
01. The CRUISE indicator light


02, in the instrument panel, will turn off.
To set conventional (fixed speed) cruise control mode:

While cruise control is off, press the CRUISE ON/OFF
button 01
and hold it down for more
than 1.5 seconds. The CRUISE indicator light will illuminate.

Accelerate to the desired speed.

Push down on the COAST/SET switch and release it. The SET indicator light will illuminate.
Cruise control will be set to the desired speed.
To switch between the two cruise control modes:

When one of the two cruise modes is in use, you must turn the system off,\
and then turn it
on again to select the other cruise control mode.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
01
0403
0708
0205
06
1591600_14b_Infiniti_QX60_HEV_QRG_092413.indd 219/24/13 11:43 AM

Vehicle Information Display
The vehicle information display 01 displays
such items as:

Vehicle settings

Trip computer information

Energy flow meter

Drive system warnings and settings (if so equipped)

Cruise Control System

Intelligent Cruise Control (ICC) System
(if so equipped) information

Intelligent Key operation information

Indicators and warnings

Tire pressure information
USING THE VEHICLE INFORMATION DISPLAy
The vehicle information display modes can be changed
using the
button
02 and ENTER button 03
located
on the steering wheel.
1. Press
02 to enter the vehicle information menu items.
2. Press

04 to navigate through the items in vehicle information.
4. Press ENTER

03 to change or select an item in the vehicle information display.
5. Press
05 to go back to the previous menu.
START UP DISPLAy
When the vehicle is placed in the ON or ACC position the screens that display in the vehicle
information include:

Active system status (if so equipped)

Trip computer

Tire pressure information

Fuel economy

Warnings (displays when a warning is present)
RESETTING THE TRIP COMPUTER
1. Press the
button
02 until you reach the Trip
computer mode 06.
2.
Press the
button 02 again for more than 1.5
seconds to reset average fuel consumption, average
speed, distance to empty and journey time.
01
23
system guide
03
02
04
05
06
1591600_14b_Infiniti_QX60_HEV_QRG_092413.indd 239/24/13 11:43 AM

system guide
24
Bluetooth® Hands-free Phone System
A cellular telephone should not be used while
driving so full attention may be given to
vehicle operation.*
SySTEM OPERATING TIPS

Press the or button to interrupt the voice
prompts at any time and speak a command after
the tone.

The “Help” command can be used to hear a list of
available commands at any time.

Reduce background noise as much as possible by
closing windows and pointing HVAC vents away from
the ceiling.

Speak naturally without long pauses and without
raising your voice.

When speaking Phonebook names, please be
aware some phones require the last name to be
spoken before the first name. For example,
“Michael Smith” may be spoken as “Smith Michael”.

To cancel a voice recognition session, say “Cancel” or
“Quit” or press and hold the

or
button for 5 seconds.

To go back to the previous command, say “Go back” or “Correctio\
n”.

If the Voice Recognition system does not recognize your voice commands, \
train the system
using the Speaker Adaptation Mode. See your Owner’s Manual for detail\
ed information.

For more detailed information and instructions, refer to your cellular p\
hone
Owner’s Manual and visit ww.InfinitiUSA.com/bluetooth.
*Some jurisdictions prohibit the use of cellular telephones while drivin\
g.
Bluetooth® Controls
Microphone
SETTINGS
The setting mode allows you to change the information displayed in the v\
ehicle
information display:

Driver Assistance (if so equipped)

Vehicle settings

Main Menu Selection

Body Color

Maintenance

Alarms

Language

Unit

Welcome Effects

Factory Reset
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
1591600_14b_Infiniti_QX60_HEV_QRG_092413.indd 249/24/13 11:43 AM