brake light INFINITI QX80 2014 Quick Reference Guide

4
Around View® Monitor with Moving Object Detection (MOD)
Moving Object Detection (MOD) operates only with
the Around View® Monitor activated.



•


To temporarily turn the system on or off select

the “MOD” key on the bottom of the control
panel display.
When the CAMERA button is pressed and the vehicle
speed is less than 6 MPH (10 km/h) or the shift lever
is moved to the R (REVERSE) position, the Information
Display Screen will automatically change to view the area surrounding th\
e vehicle.
With the Around View® Monitor displayed, the corner sonar system can detect objects
near the vehicle and warn the driver by sounding a tone and showing an i\
ndicator in
the display screen.
For more information, refer to the “Monitor, climate, audio, phone and voice recognition systems (section 4\
)” of your
Owner’s Manual.
new system features
Lane Departure Prevention (LDP) System
(if so equipped)
This system will help you return the vehicle to the
center direction of the traveling lane by applying
brake control to the left or right wheels individually
(for a short period of time).
For more information, refer to the “Starting and driving (section 5)” of your
Owner’s Manual.
Blind Spot Warning (BSW) and Blind Spot Intervention™ (BSI)
(if so equipped)
The Blind Spot Warning (BSW) system alerts the
driver when another vehicle moves into the vehicle’s
blind spot area.
An indicator light near the outside mirror will
illuminate if the radar sensors detect a vehicle in the
detection zone.
The Blind Spot Intervention™ (BSI) system can assist
the driver in returning the vehicle to the center of the
traveling lane by applying individual brake pressure
to the left or right wheels for a short period of time.
The indicator light will first illuminate in orange and
then turn green before turning off. This indicates
that the Blind Spot Warning (BSW) and Blind Spot
Intervention (BSI) systems are operational.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
1591592_14b_Infiniti_QX80_QRG_093013.indd 49/30/13 9:35 AM

5
Tire Pressure Monitoring System (TPMS) with Tire Inflation Indicator
A CHECK TIRE PRESSURE warning message will appear
in the vehicle information display
01 and the low tire
pressure warning light 02 will illuminate when one or
more tires are low on pressure and air is needed.



•


The tire pressures should be

checked when the tires are cold.
The tires are considered cold after
the vehicle has been parked for 3
hours or more or driven less than 1
mi (1.6 km) at moderate speeds.
When adding air to an under-inflated tire, the TPMS
with Tire Inflation Indicator provides visual and
audible signals to help you inflate the tires to the
recommended COLD tire pressure.
To use the Tire Inflation Indicator:



1.

Move the shift lever to the
P (PARK) position and
apply the parking brake.



2.

Place the ignition switch in the
ON position. Do not start the engine.



3.

Add air to the under-inflated tire and within a few seconds, the hazard \
warning lights

will start flashing.



4.

When the designated tire pressure is reached, the horn will beep once an\
d the hazard

warning flashers will stop.



5.

Repeat this procedure for any additional under-inflated tires.
After tire pressures are adjusted, drive the vehicle at s peeds above 16 MPH (25 km/h). The
CHECK TIRE PRESSURE warning message and low tire pressure warning light will disappear.
When the low tire pressure warning light flashes for approximately 1 min\
ute and then remains
on, the TPMS is not functioning properly. Have the system checked by an \
INFINITI retailer.
Tire pressure rises and falls depending on the heat caused by the vehicl\
e’s operation and
the outside temperature. Low outside temperature can lower the temperature of the ai\
r inside
the tire, which can cause a lower tire inflation pressure. This may caus\
e the low tire pressure
warning light to illuminate. If the warning light illuminates, check the\
tire pressure in your tires.
•

Check the tire pressure (including the spare tire) often and always pr\
ior to long distance trips.
The Tire and Loading Information label contains valuable information. Pl\
ease refer to section 9,
“Technical and consumer information” in your Owner’s Manual for\
the location of the
Tire and Loading Information label.
For more information, refer to the “Instruments and controls (section 2)” , “Starting and driving (section 5)” and the “Maintenance and
do-it-yourself (section 8)” of your Owner’s Manual.
02
01
essential information
1591592_14b_Infiniti_QX80_QRG_093013.indd 59/30/13 9:35 AM

8
first drive features
INFINITI Intelligent Key System
The INFINITI Intelligent Key system allows you to lock
or unlock your vehicle, open your liftgate and start the
engine. It is important to make sure the Intelligent Key
is with you (that is, in your pocket or purse).
REMOTE ENGINE START*
The remote engine start system must be enabled in
the vehicle settings within the vehicle information display.
The remote engine start operating range is approximately
200 ft (60 m) from the vehicle. The effective operating range
may be shorter due to environmental conditions or obstacles
between you and the vehicle.
For the remote engine start to function, the vehicle must be
in the P (PARK) position with the ignition off, and all the doors
closed and locked.
To start your vehicle remotely:



1.

Press the button
02
2. Within 5 seconds press and hold the remote engine start

button
06 for at least 2 seconds.

The engine will start and the parking lights will turn on.
Automatic climate control will begin heating or cooling the vehicle depe\
nding on the
last used mode.
The engine will run for 10 minutes and then turn off.
Repeat steps 1 and 2 to extend the time for an additional 10 minute peri\
od.
•


After two remote starts the ignition switch must be cycled before the re\
mote start can


be used again.
To start driving depress the brake pedal and push the ignition switch START/STOP button.
To lock the vehicle, push either door handle request switch 01 once or press the button
02 on the key fob.
To unlock the vehicle, perform one of the following procedures:



•

Push either door handle request switch 01 once; the corresponding door will unlock. Push
the door handle request switch
01 again within 1 minute; all other doors will unlock, or



•


Press the button 03 on the key fob to unlock the driver’s side door. Press the button
again; all other doors will unlock.
To open the liftgate, press the button 04 for more than 1 second.
The Intelligent Key can also be used to activate the panic alarm by pres\
sing and holding
the
button 05 for more than 1 second. Once activated, the panic alarm and headlights
will stay on for a period of time.
01
06
02
03
04
05
1591592_14b_Infiniti_QX80_QRG_093013.indd 89/30/13 9:35 AM

19
Conventional (Fixed Speed) Cruise Control
The cruise control system enables you to set a
constant cruising speed once the vehicle has reached
25 MPH (40 km/h).
The system will automatically maintain the set speed
until you tap the brake pedal, accelerate, cancel or
turn the system off.
To activate the cruise control, push the ON/OFF
switch
01. The CRUISE indicator light in the
instrument panel will illuminate.
To set cruising speed, accelerate the vehicle to the desired speed, push\
the COAST/SET
switch
02 and release. Take your foot off the accelerator pedal. Your vehicle wil\
l maintain
the set speed.
To reset at a faster cruising speed, push and hold the ACCEL/RES switch
03. When the
vehicle attains the desired speed, release the switch.
To reset at a slower cruising speed, push and hold the COAST/SET switch 02. Release
the switch when the vehicle slows to the desired speed.
To cancel the preset speed, push the CANCEL switch
04.
To turn off cruise control, push the ON/OFF switch 01. The CRUISE indicator light in the
instrument panel will turn off.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
04
03
02
01
To rewind or fast forward a track on a CD, press and hold the SEEK·CAT button
or the TRACK
button.
03 TUNE/FOLDER/AUDIO CONTROL KNOB
To manually tune the radio, turn the TUNE/FOLDER/AUDIO knob left or right.
04 STATION PRESET BUTTONS
Twelve stations can be set for the FM band, six for the AM band and eigh\
teen for



SiriusXM Satellite Radio.
To store a station in a preset you must first select a radio band by pre\
ssing the



FM•AM 05 or
XM
06 button, then tune to the desired FM, AM or SiriusXM Satellite

Radio station.
Then press and hold the desired station preset button (1-6) until the preset number is



updated on the display and the sound is briefly muted. The channel indic\
ator will then




display and the sound will resume. Programming is now complete.
To retrieve a previously set station, select the radio band where the pr\
eset was stored



then press the corresponding station select button
(1-6).
*SiriusXM Satellite Radio is only available on vehicles equipped with op\
tional SiriusXM Satellite Radio subscription service.
For more information, refer to the “Monitor, climate, audio, phone and voice recognition systems (secti\
on 4)” of your
Owner’s Manual.
1591592_14b_Infiniti_QX80_QRG_093013.indd 199/30/13 9:36 AM