mirror ISUZU AXIOM 2002 Service Owner's Manual

EXTERIOR/INTERIOR TRIM8J±13
4. Remove the luggage room light.

Remove the luggage room light lens (1) and the
fixing screw.

Disconnect the luggage room light connector.
825R200030
5. Remove the overhead console/sunroof switch (With
sunroof).

Refer to
Overhead Console in this section.
6. Remove the overhead console (without sunroof).
7. Remove the sunvisors.

Remove the fixing screws and pull out the sunvisor
holder (1) to remove it.

Disconnect the vanity mirror illumination connector.
743R200003
8. Remove the sunroof finisher (With sunroof).
9. Remove the headlining.

Remove the four headlining fixing clips.
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Install the headlining so that the fixing clips will not
come off.
2. To install the sunroof finisher (1), first fit it in at one
place with the headlining (3) close to the sunroof
frame (2), then install the entire finisher tightly by
hitting it with a plastic hammer, not allowing it to move
up.
665RW003

8J±14EXTERIOR/INTERIOR TRIM
Overhead Console
Parts Location (W/O Sunroof)
743R200005
Legend
(1) Overhead Console Bracket
(2) Harness Connector
(3) Head Lining(4) Room Mirror
(5) Overhead Console Assembly
(6) Front Door Finisher
(7) Front Assist Grip
Removal
1. Disconnect the battery ground cable.
2. Remove the overhead console assembly.

Open the lid and remove the two screws.

Disconnect the harness connector.
3. Remove the sunvisor and sunvisor holder. (right and
left)
4. Remove the front assist grip. (right and left)
5. Remove the front piller trim cover.6. Remove the front door finisher.

Remove the upper side of door finisher.
7. Remove the interior mirror.

Refer to
Interior Mirror in this section.
8. Remove the overhead console bracket.

Remove the two screws.
Installation
To install, follow the removal steps in the reverse order.

8J±20EXTERIOR/INTERIOR TRIM
Power Door Mirror System
General Description
The system consists of the starter switch, door mirror
switch, rear defogger/mirror defogger switch and door
mirrors on both sides.
When the door mirror switch is operated with the starter
switch at either ªACCº or ªONº position, the motor in the
door mirror (on either side) rotates to allow the horizontal
and vertical adjustment of mirror angles.
When the rear defogger/mirror defogger switch is turned
ªONº with the starter switch ªONº, the heater of the left
and right mirrors and the tailgate glass are activated.
Door Mirror Switch
Removal
1. Disconnect the battery ground cable.
2. Remove the instrument panel lower cover (2).
Refer to the
Instrument Panel Assembly in Body
Structure section.
3. Remove the door mirror switch (1).
825RW094
Rear Defogger/Mirror Defogger Switch
Refer to the Rear Defogger/Mirror switch removal and
installation steps in Lighting System section.
Door Mirrors
Refer to Door Mirror Assembly in this section.