trip computer ISUZU AXIOM 2002 Service Repair Manual
[x] Cancel search | Manufacturer: ISUZU, Model Year: 2002, Model line: AXIOM, Model: ISUZU AXIOM 2002Pages: 2100, PDF Size: 19.35 MB
Page 1462 of 2100
6E±495
6VE1 3.5L ENGINE DRIVEABILITY AND EMISSIONS
Diagnostic Trouble Code (DTC) P1625 PCM Unexpected Reset
Circuit Description
The powertrain control module (PCM) monitors
unexpected PCM reset. This will not turn on MIL light on,
only record code DTC P1625.
Conditions for Setting the DTC
Clock or COP (Computer Operating Properly) reset.
Action Taken When the DTC Sets
The PCM will not illuminate the malfunction indicator
lamp (MIL).
The PCM will store conditions which were present
when the DTC was set as Failure Records only. This
information will not be stored as Freeze Frame data.
Conditions for Clearing the MIL/DTC
The PCM will turn the MIL ªOFFº on the third
consecutive trip cycle during which the diagnostic has
been run and the fault condition is no longer present.
A history DTC P1625 will clear after 40 consecutive
warm-up cycles have occurred without a fault.
DTC P1625 can be cleared by using the Tech 2 ªClear
Infoº function or by disconnecting the PCM battery
feed.
Diagnostic Aids
Check for the following conditions:
P1625 stored alone does not need diagnosis. Clear
DTC code.
DTC P1625 ± PCM Unexpected Reset
StepActionValue(s)Ye sNo
1Was the ªOn-Board Diagnostic (OBD) System Checkº
performed?
ÐGo to Step 2
Go to OBD
System
Check
21. Ignition is ªONº.
2. Install the Tech 2.
3. Start the engine and let it Idle.
4. On the Tech 2, select ªDTC infoº.
Does the Tech 2 indicate DTC P1625 failed?
ÐGo to Step 3
Go to
Diagnostic
Aids
31. Ignition is ªONº.
2. Clear DTC P1625 by using the Tech 2 ªClear Infoº.
3. Start the engine and let it Idle.
4. On the Tech 2, select ªDTC infoº.
Does the Tech 2 indicate DTC P1625 failed?
ÐGo to Step 4
Go to
Diagnostic
Aids
41. Check for aftermarket electronics, such as
transceiver, stereos, and anti theft devices. They
may radiate EMI into the control system if they are
improperly installed. (This may cause a false sensor
reading and turn on the MIL.)
2. If a problem is found, repair as necessary.
Was a problem found?
ÐVerify repairÐ