ECU ISUZU TF SERIES 2004 Workshop Manual

7A4-12 UNIT REPAIR (JR405E)

06CV19

5. Solenoid
6. Oil pressure switch Remove the 6 solenoids together and the 3 oil pressure
switchs.


07CV17

7. Control valve upper body
8. Control valve lower body
9. Separation plate
Remove the 17 bolts securing the control valve uppe
r
body, the control valve lower body, and the separation
plate.


08CV16



Separate the upper body, the lower body, and the
separation plate.
NOTE:
Take care not to drop or lose the parts at the inside of the
control valve.

Inspection


Inspect the separation plate for wear and other damage.

7A4-82 UNIT REPAIR (JR405E)
244L300001


21.Oil pan

Install a new gasket and the oil pan.

Tighten the bolts to the specified torque.
Torque: 8 N 


m (69 Ib 


in)

47INH-SW01

22.Inhibitor switch

Secure the inhibitor switch (1) by hand-tightening the 2
bolts.

Use the inhibitor switch set plate to align the neutral
holes (manual shaft and inhibitor switch).
Turn the inhibitor switch to adjust it.
Inhibitor switch set plate: 5-8840-2763-0
NOTE:
Inhibitor switch adjustment is very important.
If the inhibitor switch is not correctly adjusted, the
automatic transmission will not function normally.

Tighten the 2 inhibitor switch bolts to the specified
torque.