battery ISUZU TFR SERIES 1997 Workshop Manual

21
Program Diesel Cutoff Solenoid
NOTE:
Perform this function only when the Immobilizer C/U is replaced.
1. Select "Body" and "Immobilizer".
2. Select engine type.
3. See Immobilizer status on the display of Tech 2.
4. Enter the security code.
5. See ECM or PCM status.
6. Select "F3: Program Diesel Cutoff Solenoid".
Programming
F0: Program Immobilizer Function
F1: Program Transponder-Keys
F2: Program Mechanical Key Number
F3: Program Diesel Cutoff Solenoid
7. Confirm the following screen shows up.
Program Diesel Cutoff Solenoid
See Checking Procedure Before
Programming!
(1) 2001 (TF) LUV
Electronic System: Immobilizer
Confirm
8. Confirm the following screen shows up.
Program Diesel Cutoff Solenoid
If Battery Voltage Is Low Disconnect
Fuse For Glow Plugs!
(1) 2001 (TF) LUV
Electronic System: Immobilizer
Confirm

26
Diagnostic procedure
System guidance
Engine does not run when any Diagnostic Trouble Code (DTC) is flagged, starting from 01MY TFR/S.
Once the cause of DTC is repaired or gone, engine can be operated normally, and present DTC becomes
history code.
History code is canceled by no repeat failure on 25 consequence ignition key On afterward.
History code cannot be canceled by battery connector disconnected, starting from 01MY
Diagnostic Trouble Code (DTC) list
Code
(BCD)Item Detecting Condition
B0011 TRANSPONDER
KEY PROBLEMTransponder code unsuccessfully read 5 consecutive time.
(Not completely read in 500ms transponder code)
B0012 WRONG
TRANSPONDER
KEYTransponder code read from the ignition key does not match the
transponder code stored in the control unit.
B0013 IMMOBILIZER NOT
PROGRAMMEDImmobilizer program no executed.
B0014 NO TRANSPONDER
KEY PROGRAMMEDProcessing to save the transponder key in the control unit not
executed.
B0015 VEHICLE SPEED
SIGNAL Lo (Gas)
FREQUENCY
SIGNAL Lo (Diesel)Lo level (2.5v or less) input during the Hi level was being output
in the immobilizer signal. (Gas)
Lo level (2.5v or less) input during the Hi level was being output to the
communication line. (Diesel)
B0016 VEHICLE SPEED
SIGNAL Hi (Gas)
FREQUENCY
SIGNAL Hi (Diesel)Hi level (more than 2.5v) input during the Lo level was being output in
the immobilizer signal. (Gas)
Hi level (more than 2.5v) input during the Lo level was being output to
the communication line. (Diesel)
B0017 NO ENGINE
REQUEST
RECEIVEDNo request signal received from the engine control unit in a second
after the ignition key has been placed at ON.
(Gas engine only)
B0023 ANTENNA COIL
OPENAntenna coil not connected.
B0024 WRONG
TRANSPONDER
RESPONSETransponder response signal with the challenge is wrong.
B0025 WRONG ENGINE
REQUESTThe challenge signal from the engine control unit is invalid.
(Gas engine only)
B0055 EEPROM ERROR Write and read cannot be correctly made to and from the EEPROM in
the control unit.