ignition ISUZU TROOPER 1998 Service Repair Manual

RESTRAINT CONTROL SYSTEM 9J1±64
DTC 52 Deployment Event Commanded
WARNING:DURING SERVICE PROCEDURES. BE VERY CAREFUL WHEN HANDLING A SENSING AND
DIAGNOSTIC MODULE (SDM). NEVER STRIKE OR JAR THE SDM. NEVER POWER UP THE PRETENSIONER
WHEN THE SDM IS NOT RIGIDLY ATTACHED TO THE VEHICLE. ALL SDM AND MOUNTING BRACKET
FASTENERS MUST BE CAREFULLY TORQUED AND THE ARROW MUST BE POINTING TOWARD THE FRONT
OF THE VEHICLE TO ENSURE PROPER OPERATION OF THE PRETENSIONER. THE SDM COULD BE
ACTIVATED WHEN POWERED WHILE NOT RIGIDLY ATTACHED TO THE VEHICLE WHICH COULD CAUSE
DEPLOYMENT AND RESULT IN PERSONAL INJURY.
Step
ActionYe sNo
1Was the ªSRS Diagnostic System Checkº performed?
Go to Step 2.
Go to the ªSRS
Diagnostic
System Checkº
2Ignition switch ªOFF.º
Have pretensioner assemblies deployed?Replace
components and
perform
inspections as
directed in
ªrepairs and
inspections
required after an
accidentº in this
section
clear diagnostic
trouble codes
Repeat ªSRS
Diagnostic
System Checkº
Go to Step 3
3Inspect front of vehicle and undercarriage for sings of impact.
Were signs of impact found?Replace
components and
perform
inspections as
directed in
ªRepairs and
Inspections
Required After An
Accidentº in this
section
Clear diagnostic
trouble codes
Repeat ªSRS
Diagnostic
System Checkº
Ignition switch
ªOFFº
Replace SDM
Reconnect all
SRS system
components,
ensure all
components are
properly mounted
Repeat ªSRS
Diagnostic
System Checkº

PAGE BACK PAGE NEXT
THIS MALUAL INCLUDES THE FOLLOWING SECTIONS:
6VD1/6VE1
SECTION No. CONTRNTS
6A ENGINE MECHANICAL
6B ENGINE COOLING
6C ENGINE FUEL
6D1 ENGINE ELECTRICAL
6D2 IGNITION SYSTEM
6D3 STARTING AND CHARGING SYSTEM
6E ENGINE DRIVEABILITY AND EMISSIONS
6F ENGINE EXHAUST
6G ENGINE LUBRICATION
6H ENGINE SPEED CONTROL SYSTEM
6J INDUCTION