tow JAGUAR X TYPE 2004 1.G MAF Sensor Cleaning Manual

X-Type Jaguar Information
With the engine cover
removed you can see and
easily access the MAF sensor
in the middle of the engine
bay at the top of the air
ducts. (Arrowed)
Locate the MAF sensor on the large black
plastic pipe from the rear of the air filter
housing – it is rectangular and has a
wiring connector attached. There are two
retaining screws visible and accessible
from the top (Arrowed).
Top Tip: Check the connector carefully as
there have been reports of wires coming
adrift from the plug – it is possible to split
the plug open to restore the wires but
they are very short with little free play.
Remove the wiring connector to the MAFS by pressing down on
the lever to release the tang (Arrowed in picture above), and
carefully pull and jiggle the connector until free, set it aside
away from any danger of shorting.
Be careful not to pull or strain the wires as they are short and
there is not much room to manoeuvre.
Diesel MAF Sensor Wiring Sequence:
(looking from front of car toward windscreen)
White / GreenBrown / Blue Brown / Blue White / Blue