tow JEEP CHEROKEE 2014 KL / 5.G Owners Manual

ONBOARD DIAGNOSTIC SYSTEM — OBD II
Your vehicle is equipped with a sophisticated onboard
diagnostic system called OBD II. This system monitors
the performance of the emissions, engine, and automatic
transmission control systems. When these systems are
operating properly, your vehicle will provide excellent
performance and fuel economy, as well as engine emis-
sions well within current government regulations.
If any of these systems require service, the OBD II system
will turn on the “Malfunction Indicator Light (MIL).” It
will also store diagnostic codes and other information to
assist your service technician in making repairs. Al-
though your vehicle will usually be drivable and not
need towing, see your authorized dealer for service as
soon as possible.
CAUTION!
•Prolonged driving with the MIL on could cause
further damage to the emission control system. It
could also affect fuel economy and driveability.
The vehicle must be serviced before any emissions
tests can be performed.
• If the MIL is flashing while the engine is running,
severe catalytic converter damage and power loss
will soon occur. Immediate service is required.
7
MAINTAINING YOUR VEHICLE 595

3. Grab the bottom of the wiper blade and rotate itforward to unsnap the blade pivot pin from the wiper
blade holder. 4. Install the wiper blade pivot pin into the wiper blade
holder at the end of the wiper arm, and firmly press
the wiper blade until it snaps into place.
5. Lower the wiper blade and snap the pivot cap into place.
Adding Washer Fluid
The windshield and rear window washers share the same
fluid reservoir. The fluid reservoir is located in the front
of the engine compartment. Be sure to check the fluid
level in the reservoir at regular intervals. Fill the reservoir
with windshield washer solvent (not radiator antifreeze)
and operate the system for a few seconds to flush out the
residual water.
When refilling the washer fluid reservoir, take some
washer fluid and apply it to a cloth or towel and wipe
clean the wiper blades, this will help blade performance.
1—WiperBlade
2 — Blade Pivot Pin
3—WiperArm
4 — Wiper Blade Holder
7
MAINTAINING YOUR VEHICLE 609

NOTE:Intentional tampering with emissions control
systems can result in civil penalties being assessed
against you.
In unusual situations involving grossly malfunctioning
engine operation, a scorching odor may suggest severe
and abnormal catalyst overheating. If this occurs, stop
the vehicle, turn off the engine and allow it to cool.
Service, including a tune-up to manufacturer’s specifica-
tions, should be obtained immediately.
To minimize the possibility of catalytic converter damage:
• Do not shut off the engine or interrupt the ignition,
when the transmission is in gear and the vehicle is in
motion.
• Do not try to start the engine by pushing or towing the
vehicle. •
Do not idle the engine with any spark plug wires
disconnected or removed, such as when diagnostic
testing, or for prolonged periods during very rough
idle or malfunctioning operating conditions.
Cooling System
WARNING!
You or others can be badly burned by hot engine
coolant (antifreeze) or steam from your radiator. If
you see or hear steam coming from under the hood,
do not open the hood until the radiator has had time
to cool. Never try to open a cooling system pressure
cap when the radiator or coolant bottle is hot.
612 MAINTAINING YOUR VEHICLE

Stain Repel Fabric Cleaning Procedure —
If Equipped
Stain Repel seats may be cleaned in the following man-
ner:
•Remove as much of the stain as possible by blotting
with a clean, dry towel.
• Blot any remaining stain with a clean, damp towel.
• For tough stains, apply MOPAR® Total Clean, or a
mild soap solution to a clean, damp cloth and remove
stain. Use a fresh, damp towel to remove soap residue.
• For grease stains, apply MOPAR® Multi-Purpose
Cleaner to a clean, damp cloth and remove stain. Use
a fresh, damp towel to remove soap residue.
• Do not use any harsh solvents or any other form of
protectants on Stain Repel products.
Interior Care
Instrument Panel Cover
The instrument panel cover has a low glare surface,
which minimizes reflections in the windshield. Do not
use protectants or other products, which may cause
undesirable reflections. Use soap and warm water to
restore the low glare surface.
Cleaning Interior Trim
Clean interior trim with a damp cloth and MOPAR®
Total Clean or equivalent, and if necessary, follow with
MOPAR® Spot & Stain Remover or equivalent. Do not
use harsh cleaners or Armor All®. Use MOPAR® Total
Clean or equivalent to clean vinyl upholstery.
Cleaning Leather Upholstery
MOPAR® Total Clean or equivalent is specifically recom-
mended for leather upholstery.
626 MAINTAINING YOUR VEHICLE

cleaner. Use caution when cleaning the inside rear win-
dow equipped with electric defrosters or the right rear
quarter window equipped with the radio antenna. Do
not use scrapers or other sharp instrument that may
scratch the elements.
When cleaning the rear view mirror, spray cleaner on the
towel or rag that you are using. Do not spray cleaner
directly on the mirror.
Cleaning Plastic Instrument Cluster Lenses
The lenses in front of the instruments in this vehicle are
molded in clear plastic. When cleaning the lenses, care
must be taken to avoid scratching the plastic.
1. Clean with a wet soft rag. A mild soap solution may beused, but do not use high alcohol content or abrasive
cleaners. If soap is used, wipe clean with a clean damp
rag.
2. Dry with a soft cloth.
Seat Belt Maintenance
Do not bleach, dye or clean the belts with chemical
solvents or abrasive cleaners. This will weaken the fabric.
Sun damage can also weaken the fabric.
If the belts need cleaning, use a mild soap solution or
lukewarm water. Do not remove the belts from the car to
wash them. Dry with a soft cloth.
Replace the belts if they appear frayed or worn or if the
buckles do not work properly.
WARNING!
A frayed or torn belt could rip apart in a collision and
leave you with no protection. Inspect the belt system
periodically, checking for cuts, frays, or loose parts.
Damaged parts must be replaced immediately. Do
not disassemble or modify the system. Seat belt
(Continued)
628 MAINTAINING YOUR VEHICLE

CavityBlade Fuse Cartridge Fuse Description
F33 —30 Amp Pink Driver Door Module (DDM) - If Equipped
F34 —30 Amp Pink Body Controller Module (BCM) - Feed 3
F35 — —Not Used
F36 — —Not Used
F37 —50 Amp Red Voltage Stabilization Module (VSM) -
If Equipped With Stop/Start Engine Option
F38 —50 Amp Red Radiator Fan
F38 —60 Amp Yellow Glow Plugs - Diesel Only - If Equipped
F39 —40 Amp Green HVAC Blower Motor
F40 —20 Amp Blue Trailer Tow Park Light - If Equipped
F41 —60 Amp Yellow Body Controller Module (BCM) - Feed 2
F42 —30 Amp Pink Electric Park Brake (EPB) - Left
F43 20 Amp Yellow —Trailer Tow Left Stop/Turn Light -
If Equipped
7
MAINTAINING YOUR VEHICLE 633

CavityBlade Fuse Cartridge Fuse Description
F44 —30 Amp Pink Trailer Tow / 7-Way Connector - If Equipped
F45 —30 Amp Pink Passenger Door Module (PDM) - If Equipped
F46 —25 Amp Clear Sunroof - If Equipped
F47 —30 Amp Pink Drivetrain Control Module (DTCM)
F48 — —Not Used
F49 —30 Amp Pink Power Inverter (115V A/C) - If Equipped
F50 —30 Amp Pink Power Liftgate - If Equipped
F51 — —Not Used
F52 — —Not Used
F53 —30 Amp Pink BSM-ECU & Valves
F54 —30 Amp Pink Urea Heater Control Unit - If Equipped With
Diesel Engine
F55 10 Amp Red —
Blind Spot Sensors / Compass / Rearview
Camera If Equipped / Rear Seat Heater
Switches / Trunk Lamp W/ Flashlamp Charger
634 MAINTAINING YOUR VEHICLE

CavityBlade Fuse Cartridge Fuse Description
F66 10 Amp Red —
In Car Temperature Sensor / Humidity
Sensor / Driver Assist System Module
(DASM) / Park Assist (PAM)
F67— —Not Used
F68 — —Not Used
F69 10 Amp Red —Power Transfer Unit Switch (TSBM) / Active
Grill Shutter (AGS) - If Equipped
F70 — —Not Used
F71 20 Amp Yellow —Windshield De-Icer - If Equipped
F72 5 Amp Tan —Intelligent Battery Sensor (IBS) If Equipped
With Stop/Start Engine Option
F72 20 Amp Yellow —Trailer Tow RT Stop / Turn Lights -
If Equipped
F73 —30 Amp Pink Rear Defroster / Defogger
636 MAINTAINING YOUR VEHICLE

CavityBlade Fuse Cartridge Fuse Description
F83 —30 Amp Pink Headlamp Washer Pump - If Equipped
F84 —40 Amp Green Brake System Module (BSM) - Pump Motor
If Equipped With Diesel Engine
F84 —20 Amp Blue Trailer Tow Backup Lights - If Equipped With
Gasoline Engine
F85 — —Not Used
F86 — —Not Used
F87 — —Not Used
F88 15 Amp Blue —Collision Mitigation Module (CMM) /
Electrochromatic Mirror / Smart Camera
Module - If Equipped
F89 10 Amp Red —Headlamp Leveling - If Equipped
F90 — —Not Used
638 MAINTAINING YOUR VEHICLE

CavityBlade Fuse Cartridge Fuse Description
F91 — —Not Used
F92 20 Amp Yellow —Rear Power Outlet
F93 —40 Amp Green Brake System Module (BSM) - Pump Motor -
If Equipped With Gasoline Engine
F94 —30 Amp Pink Electric Park Brake (EPB) - Right
F95 10 Amp Red —Electrochromatic Mirror / Rain Sensor /
Sunroof - If Equipped
F96 10 Amp Red —Occupant Restraint Controller (ORC)
F97 10 Amp Red —Occupant Restraint Controller (ORC)
F98 25 Amp Clear —Audio Amplifier - If Equipped
F99 —30 Amp Pink Trailer Tow Module - If Equipped With
Gasoline Engine
F100 — —Not Used
7
MAINTAINING YOUR VEHICLE 639