battery JEEP CHEROKEE 2016 KL / 5.G Workshop Manual

Replacement.......................... .563
Rotation ............................. .567
Safety ........................... .541, 552
Sizes ............................... .542
Snow Tires ........................... .557
Spare Tire ..................... .558, 559, 560
Spinning ............................ .561
Trailer Towing ........................ .599
Tread Wear Indicators ....................561
Tire Safety Information .....................541
Tire Service Kit . . . .620, 621, 622, 625, 626, 628, 629, 630
Tongue Weight/Trailer Weight ................596
To Open Hood .......................... .164
Torque Converter Clutch ....................494
Towing ......................... .591, 595, 652
Disabled Vehicle ....................... .652
Recreational .......................... .604
Towing Vehicle Behind A Motorhome ...........604
Traction Control ......................... .526Trailer Sway Control (TSC)
..................532
Trailer Towing .......................... .591
Cooling System Tips .....................603
Hitches ............................. .594
Minimum Requirements ..................597
Trailer And Tongue Weight .............595, 596
Wiring .............................. .601
Trailer Towing Guide ...................... .595
Trailer Weight ........................... .595
Transaxle .............................. .483
Automatic ........................... .483
Operation ............................ .483
Transfer Case Fluid ............................... .728
Transmission ........................... .485
Automatic ........................ .485, 698
Fluid ............................... .728
Maintenance .......................... .698
T

ransmitter Battery Service (Remote Keyless Entry) . .26
764 INDEX

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.