immobilizer JEEP COMMANDER 2008 1.G Owners Manual
[x] Cancel search | Manufacturer: JEEP, Model Year: 2008, Model line: COMMANDER, Model: JEEP COMMANDER 2008 1.GPages: 478, PDF Size: 6.97 MB
Page 17 of 478
CAUTION!
An unlocked car is an invitation to thieves. Always
remove key from the ignition and lock all doors
when leaving the vehicle unattended.
Key-In-Ignition Reminder
If you open the driver's door and the key is in the
ignition, a chime will sound to remind you to remove the
key.
NOTE:The Key-In-Ignition reminder only sounds
when the ignition key is placed in the LOCK or ACC
position.
SENTRY KEY
The Sentry Key Immobilizer System prevents unautho-
rized vehicle operation by disabling the engine. The
system does not need to be armed or activated. Operation
is automatic, regardless of whether the vehicle is locked
or unlocked.
The system uses the factory-mated Fob with Integrated
Key and Wireless Ignition Node (WIN) to prevent unau-
thorized vehicle operation. Therefore, only Fobs that are
programmed to the vehicle can be used to start and
operate the vehicle. The system will shut the engine off in
two (2) seconds if someone uses an invalid Fob to start
the engine.
After turning the ignition switch to the ON position, the
Vehicle Security Alarm Indicator Light will turn on for
three (3) seconds for a bulb check. If the light remains on
after the bulb check, it indicates that there is a problem
with the electronics. In addition, if the light begins to
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 17
2
Page 18 of 478
flash after the bulb check, it indicates that someone used
an invalid Fob to start the engine. Either of these condi-
tions will result in the engine being shut off after two (2)
seconds.
If the Vehicle Security Alarm Indicator Light turns on
during normal vehicle operation (vehicle running for
longer than 10 seconds), it indicates that there is a fault in
the electronics. Should this occur, have the vehicle ser-
viced as soon as possible.
NOTE:
²The Sentry Key Immobilizer System is not compatible
with aftermarket remote starting systems. Use of these
systems may result in vehicle starting problems and
loss of security protection.
²Exxon/Mobil Speed Pass,Ÿ additional Fobs, or any
other transponder-equipped components on the same
key chain willnotcause a fault unless the additional
part isphysically held against the Fobbeing used tostart the vehicle. Cell phones, pagers, or other RF
electronics will not cause interference with this system.
All of the Fobs provided with your new vehicle have
been programmed to the vehicle electronics.
Replacement Keys
NOTE:Only Fobs that are programmed to the vehicle
electronics can be used to start and operate the vehicle.
Once a Fob is programmed to a vehicle, it cannot be
programmed to any other vehicle.
CAUTION!
Always remove Sentry Keys from the vehicle and
lock all doors when leaving the vehicle unattended.
At the time of purchase, the original owner is provided
with a four-digit PIN number. Keep the PIN in a secure
18 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
Page 19 of 478
location. This number is required for dealer replacement
of Fobs. Duplication of Fobs may be performed at an
authorized dealer or by using the Customer Key Pro-
gramming procedure. This procedure consists of pro-
gramming a blank Fob to the vehicle electronics. A blank
Fob is one, which has never been programmed.
NOTE: When having the Sentry Key Immobilizer
System serviced, bring all vehicle Fobs with you to the
dealer.
Customer Key (Fob) Programming
If you have two valid sentry keys, you can program new
sentry keys to the system by performing the following
procedure:
1. Insert the first valid key into the ignition switch and
turn the ignition switch ON for at least 3 seconds but no
longer than 15 seconds. Turn the ignition switch OFF and
remove the first key.2. Insert the second valid key and turn the ignition
switch ON within 15 seconds. After ten seconds, a chime
will sound and the Vehicle Security Alarm Indicator
Light will begin to flash. Turn the ignition switch OFF
and remove the second key.
3. Insert a blank Sentry Key into the ignition switch and
turn the ignition switch ON within 60 seconds. After 10
seconds, a single chime will sound and the Vehicle
Security Alarm Indicator Light will stop flashing, turn on
again for 3 seconds, and then turn off.
The new Sentry Key is programmed.The Keyless Entry
Transmitter will also be programmed during this pro-
cedure.
Repeat this procedure to program up to 8 keys. If you do
not have a programmed sentry key, contact your dealer
for details.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 19
2
Page 465 of 478
GVWR............................... 344
Hands-Free Phone (UConnectŸ).............. 82
Hard Drive (HDD)....................... 239
Hazard Warning Flasher................... 366
Head Restraints......................... 110
Head Rests............................ 110
Headlights............................ 125
Bulb Replacement...................... 428
Cleaning............................ 418
On With Wipers....................... 126
Replacing............................ 428
Heated Mirrors.......................... 81
Heated Seats........................... 111
Heater, Engine Block..................... 280
High Beam Indicator..................... 187
High Beam/Low Beam Select (Dimmer) Switch . . 129
Hill Descent Control..................... 150
Hill Start Assist......................... 148Hitches
Trailer Towing........................ 350
Holder, Cup........................... 172
HomeLinkt(Garage Door Opener) Transmitter . . . 159
Hood Release.......................... 123
Hoses................................ 406
Ignition............................... 16
Cables (Spark Plug Wires)................ 392
Key ...............................14,16
Wiring System (Spark Plug Wires).......... 392
Ignition Key Removal..................... 16
Illuminated Entry........................ 21
Immobilizer (Sentry Key)................... 17
Infant Restraint........................60,61
Inflation Pressure Tires.................... 316
Information Center, Vehicle................. 195
Inside Rearview Mirror.................... 78
Instrument Cluster....................186,187
INDEX 465
10
Page 466 of 478
Instrument Panel and Controls.............. 185
Instrument Panel Lens Cleaning............. 418
Integrated Power Module (Fuses)............ 425
Interior Appearance Care.................. 417
Interior Fuses.......................... 419
Interior Lighting........................ 130
Interior Lights.......................127,130
Intermittent Wipers (Delay Wipers)........... 132
Introduction............................. 4
Inverter, Power......................... 170
Jack Location........................... 368
Jack Operation.......................368,371
Jacking Instructions...................... 371
Jump Starting.......................... 374
Key, Programming........................ 19
Key, Replacement........................ 18
Key, Sentry (Immobilizer)................... 17Key-In Reminder......................... 17
Keyless Entry System...................... 21
Keys................................. 14
Lap/Shoulder Belts....................... 39
LATCH (Lower Anchors and Tether for
CHildren)............................64,65
Lead Free Gasoline...................... 333
Leaks, Fluid............................ 72
Life of Tires............................ 320
Liftgate................................ 34
Liftgate Flipper Glass...................... 35
Liftgate Window Wiper/Washer............. 176
Lights..............................72,124
Airbag............................57,188
Alarm............................... 71
Anti-Lock........................... 188
Automatic Headlights................... 126
Back-Up............................. 432
466 INDEX
Page 473 of 478
Rear Folding....................... 113,117
Reclining............................ 108
Seatback Release....................... 117
Security Alarm (Theft Alarm).............20,189
Selection of Oil......................... 390
Sentry Key (Immobilizer)................... 17
Sentry Key Programming................... 19
Sentry Key Replacement................... 18
Service Assistance....................... 448
Service Contract......................... 450
Service Engine Soon Light (Malfunction
Indicator)............................. 187
Service Manuals........................ 452
Setting the Clock................213,229,240,243
Settings, Personal........................ 205
Shift Lock Manual Override................ 281
Shifting............................... 281
Automatic Transmission................. 281
Shoulder Belts........................... 39Signals, Turn...................129,187,430,432
Skylights, Command View................. 168
SmartBeams........................... 126
Snow Chains (Tire Chains)................. 322
Snow Plow............................ 363
Sound Systems (Radio).................... 239
Spare Tire............................. 369
Spark Plug Wires (Ignition Cables/Wires)...... 392
Spark Plugs............................ 392
Specifications
Fuel (Gasoline)........................ 333
Oil ................................ 390
Speed Control (Cruise Control).............. 136
Speedometer........................... 187
Starting............................... 277
Automatic Transmission................. 277
Cold Weather......................278,280
Engine Block Heater.................... 280
Engine Fails to Start.................... 279
INDEX 473
10