lock JEEP COMMANDER 2009 1.G Owners Manual

WARNING!
Raising the vehicle higher than necessary can make
the vehicle less stable. It could slip off the jack and
hurt someone near it. Raise the vehicle only enough
to remove the tire.
6. Remove the lug nuts and wheel.
7. Position the spare wheel/tire on the vehicle and install
the lug nuts with the cone-shaped end toward the wheel.
Lightly tighten the nuts. To avoid the risk of forcing the
vehicle off the jack, do not tighten the nuts fully until the
vehicle has been lowered.
8. Lower the vehicle by turning the jack screw counter-
clockwise, and remove the jack and wheel blocks.
9. Finish tightening the lug nuts. Push down on the
wrench while tightening for increased leverage. Alternate
nuts until each nut has been tightened twice. Correctwheel nut tightness is 95 ft lbs (130 N·m). If in doubt
about the correct tightness, have them checked with a
torque wrench by your authorized dealer or at a service
station.
10. Lower the jack to it’s fully closed position.
WARNING!
A loose tire or jack, thrown forward in a collision or
hard stop could endanger the occupants of the ve-
hicle. Always stow the jack parts and the spare tire in
the places provided.
11. Secure the tire, jack, and tools in their proper loca-
tions.
NOTE:Tire should be stowed with the “beauty” side
up. Storing the tire upside down may result in scratching
or damage to the wheel face. Continue winching up the
tire until you hear the winch “ratchet” three times.
408 WHAT TO DO IN EMERGENCIES

WARNING! (Continued)
•The air conditioning system contains refrigerant
under high pressure. To avoid risk of personal
injury or damage to the system, adding refrigerant
or any repair requiring lines to be disconnected
should be done by an experienced repairman.
NOTE:Use only manufacturer approved A/C System
Sealers, Stop Leak Products, Seal Conditioners, Compres-
sor Oil, and Refrigerants.
Refrigerant Recovery and Recycling
R-134a Air Conditioning Refrigerant is a hydrofluoro-
carbon (HFC) that is endorsed by the Environmental
Protection Agency (EPA) and is an ozone-saving product.
However, the manufacturer recommends that air condi-
tioning service be performed by authorized dealers or
other service facilities using recovery and recycling
equipment.
Body Lubrication
Locks and all body pivot points, including such items as
seat tracks, door hinge pivot points and rollers, liftgate,
tailgate, sliding doors and hood hinges, should be lubri-
cated periodically with a lithium based grease such as
MOPARSpray White Lube to assure quiet, easy opera-
tion and to protect against rust and wear. Prior to the
application of any lubricant, the parts concerned should
be wiped clean to remove dust and grit; after lubricating
excess oil and grease should be removed. Particular
attention should also be given to hood latching compo-
nents to insure proper function. When performing other
underhood services, the hood latch, release mechanism
and safety catch should be cleaned and lubricated.
The external lock cylinders should be lubricated twice a
year, preferably in the Fall and Spring. Apply a small
amount of a high quality lubricant such as MOPAR
Lock Cylinder Lubricant directly into the lock cylinder.
MAINTAINING YOUR VEHICLE 427
7

FUSES
Interior Fuses
The fuse panel is on the lower instrument panel just to
the left of the steering column.
CavityCartridge
FuseMini-Fuse Description
1 30 Amp
GreenAudio Amp (B+)
2 15 Amp
BlueSunroof (B+)
3 10 Amp
RedHtd Mirror (EBL)
4 20 Amp
YellowRr Pwr Out (B+)
5 10 Amp
RedRr HVAC (R/O)
(Commander Only)
6 Spare (B+)
7 20 Amp
YellowDoor Locks (B+)
Fuse Panel
MAINTAINING YOUR VEHICLE 449
7

3. Disconnect the electrical connector.
4. Turn the low or high beam bulb 1/4 turn counterclock-
wise to unlock it from the housing.5. Pull the bulb and base straight out from the opening in
the reflector.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with any oily surface, clean the
bulb with rubbing alcohol.
1 — Low Beam Bulb
2 — High Beam Bulb
3 — Front Park/Turn Signal BulbMAINTAINING YOUR VEHICLE 459
7

4. Turn the socket on the bottom of the front lamp unit
housing 1/4 turn counterclockwise to unlock it.
5. Pull the socket and bulb straight out from the opening
in the housing.
6. Disconnect the electrical connector.
7. Pull the base of the bulb straight out of the socket.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with any oily surface, clean the
bulb with rubbing alcohol.
Front Fog Light
1. Turn the steering wheel all the way to the left or right.2. Reach into the front wheel house ahead of the front
wheel to unsnap and lift the cover over the access hole in
the front of the wheel house splash shield. Access to the
bulb can be gained through the wheel liner hole.
3. Reach through the access hole to access the back of the
front fog light housing on the back of the front fascia.
4. Disconnect the electrical connector.
MAINTAINING YOUR VEHICLE 461
7

5. Turn the socket on the back of the housing 1/4 turn
counterclockwise to unlock it.
6. Pull the socket and bulb straight out from the opening
in the housing.
7. Pull the base of the bulb straight out of the socket.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with any oily surface, clean the
bulb with rubbing alcohol.
Rear Tail, Stop, Turn Signal, and Backup Lights
1. Raise the liftgate.
2. Remove the two push-pins that secure the rear lamp
unit to the side of the liftgate opening.3. Pull the outboard side of the rear lamp unit rearward
far enough to unsnap the two ball studs on the outboard
side of the lamp housing from the two plastic grommets
in the quarter outer panel. Pull the lamp unit rearward
far enough away to access the bulbs.
462 MAINTAINING YOUR VEHICLE

4. Firmly grasp the appropriate bulb socket on the back
of the rear lamp unit housing, and turn 1/4 turn coun-
terclockwise to unlock it.5. Disconnect the electrical connector.
6. Pull the socket and bulb straight out from the opening
in the housing.
7. Pull the base of the bulb straight out of the socket.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with any oily surface, clean the
bulb with rubbing alcohol.
1 — Rear Backup Lamp Bulb
2 — Rear Park/Stop Lamp Bulb
3 — Rear Park/Turn Signal Bulb
4 — Rear Side Marker Lamp BulbMAINTAINING YOUR VEHICLE 463
7

ABS (Anti-Lock Brake System).............. 320
Adding Fuel........................... 375
Adjustable Pedals....................... 152
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . 424
Air Conditioner Maintenance............... 426
Air Conditioning........................ 274
Air Conditioning, Operating Tips............ 283
Air Conditioning, Rear Zone................ 281
Air Conditioning Refrigerant............... 427
Air Conditioning System.................. 274
Air Filter.............................. 424
Air Pressure, Tires....................... 347
Airbag................................ 52
Airbag Deployment....................... 59
Airbag Light.......................61,75,193
Airbag Maintenance....................... 61
Alarm, Panic............................ 24
Alarm (Security Alarm).................20,194
Alterations/Modifications, Vehicle............. 9Antenna, Satellite Radio................... 264
Antifreeze (Engine Coolant)................ 465
Anti-Lock Brake System (ABS)............320,323
Anti-Lock Warning Light.................. 193
Anti-Theft System....................... 194
Appearance Care........................ 444
Arming Theft System (Security Alarm)......... 20
Assist, Hill Start........................ 332
Assistance Towing....................... 102
Auto Down Power Windows................ 35
Automatic Dimming Mirror................. 84
Automatic Door Locks..................... 30
Automatic Headlights.................... 141
Automatic Temperature Control (ATC)......... 274
Automatic Transmission................299,440
Adding Fluid......................... 442
Fluid and Filter Changes................. 440
Fluid Level Check..................... 441
Fluid Type........................... 440
496 INDEX

Special Additives...................... 440
Torque Converter...................... 305
Autostick............................. 301
Auxiliary Electrical Outlet (Power Outlet)...... 173
Auxiliary Power Outlet................... 173
Battery............................... 425
Emergency Starting..................... 409
Keyless Transmitter Replacement (RKE)....... 25
Saving Feature (Protection)............... 145
Belts, Seat.............................. 43
Body Mechanism Lubrication............... 427
B-Pillar Location........................ 342
Brake Assist System...................... 324
Brake Control System, Electronic............. 323
Brake Fluid............................ 437
Brake System........................... 437
Anti-Lock (ABS)....................320,323
Fluid Check.......................... 437Master Cylinder....................... 437
Parking............................. 318
Warning Light........................ 191
Brake/Transmission Interlock............... 297
Break-In Recommendations, New Vehicle........ 73
Bulb Replacement.....................457,458
Calibration, Compass..................... 210
Camera, Rear........................... 160
Capacities, Fluid........................ 465
Caps, Filler
Fuel............................... 375
Power Steering........................ 317
Radiator (Coolant Pressure)............... 434
Car Washes............................ 444
Carbon Monoxide Warning...............74,371
Cargo Area Features...................... 178
Cargo Compartment...................... 178
Luggage Carrier....................... 181
INDEX 497
10

Cargo Load Floor........................ 178
Cargo (Vehicle Loading)................... 378
Cellular Phone........................88,270
Center High Mounted Stop Light............ 464
Certification Label....................... 378
Chains, Tire............................ 354
Changing A Flat Tire..................... 401
Chart, Tire Sizing........................ 339
Check Engine Light
(Malfunction Indicator Light)............... 419
Checks, Safety........................... 75
Child Restraint....................64,65,69,71
Child Restraint Tether Anchors.............68,69
Child Safety Locks........................ 33
Climate Control......................... 271
Clock........................220,234,237,247
Cold Weather Operation................... 294
Command View Skylights.................. 172
Compact Disc (CD) Maintenance............. 270Compact Spare Tire...................... 349
Compass.............................. 210
Compass Calibration..................... 210
Compass Variance....................... 211
Computer, Trip/Travel.................... 206
Connector
UCI ................................ 257
Universal Consumer Interface (UCI)......... 257
Console, Overhead....................... 162
Contract, Service........................ 489
Cooling System......................... 431
Adding Coolant (Antifreeze).............. 433
Coolant Capacity...................... 465
Coolant Level......................... 435
Disposal of Used Coolant................ 435
Drain, Flush, and Refill.................. 432
Inspection........................... 431
Points to Remember.................... 436
Pressure Cap......................... 434
498 INDEX