immobilizer JEEP COMPASS 2011 1.G Owners Manual

CAUTION!
An unlocked car is an invitation to thieves. Always
remove the key from the ignition and lock all the
doors when leaving the vehicle unattended.
Locking Doors With A Key
You can insert the key with either side up. To lock the
door, turn the key to the right. To unlock the door, turn
the key to the left. Refer to “Maintenance Procedures” in
“Maintaining Your Vehicle” for further information.
Key-In-Ignition Reminder
Opening the driver’s door when the key is in the ignition
and the ignition position is LOCK or ACC, sounds a
signal to remind you to remove the key.
NOTE:With the driver’s door open and the key in the
ignition, the power door locks will not lock and Remote
Keyless Entry (RKE) transmitter will not function.
SENTRY KEY
The Sentry Key Immobilizer System prevents unauthor-
ized vehicle operation by disabling the engine. The
system does not need to be armed or activated. Operation
is automatic, regardless of whether the vehicle is locked
or unlocked.
The system uses ignition keys that have an embedded
electronic chip (transponder) to prevent unauthorized
vehicle operation. Therefore, only keys that are pro-
grammed to the vehicle can be used to start and operate
the vehicle. The system will shut the engine off in two
seconds if someone uses an invalid key to try to start the
engine.
NOTE: A key that has not been programmed is also
considered an invalid key, even if it is cut to fit the
ignition switch lock cylinder for that vehicle.
During normal operation, after turning on the ignition
switch, the Vehicle Security Light will turn on for three
14 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

seconds for a bulb check. If the light remains on after the
bulb check, it indicates that there is a problem with the
electronics. In addition, if the Vehicle Security Light
begins to flash after the bulb check, it indicates that
someone used an invalid key to try to start the engine.
Either of these conditions will result in the engine being
shut off after two seconds.
If the Vehicle Security Light turns on during normal
vehicle operation (vehicle running for longer than 10 sec-
onds), it indicates that there is a fault in the electronics.
Should this occur, have the vehicle serviced as soon as
possible by an authorized dealer.
CAUTION!
The Sentry KeyImmobilizer system is not compat-
ible with some after-market remote starting systems.
Use of these systems may result in vehicle starting
problems and loss of security protection. All of the keys provided with your new vehicle have
been programmed to the vehicle electronics.
Replacement Keys
NOTE:
Only keys that are programmed to the vehicle
electronics can be used to start and operate the vehicle.
Once a Sentry Key is programmed to a vehicle, it cannot
be programmed to any other vehicle.
CAUTION!
Always remove the Sentry Keys from the vehicle
and lock all doors when leaving the vehicle unat-
tended.
At the time of purchase, the original owner is provided
with a four-digit Personal Identification Number (PIN).
Keep the PIN in a secure location. This number is
required for authorized dealer replacement of keys. Du-
plication of keys may be performed at an authorized
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 15

dealer or by following the customer key programming
procedure. This procedure consists of programming a
blank key to the vehicle electronics. A blank key is one
that has never been programmed.
NOTE:When having the Sentry Key Immobilizer
System serviced, bring all vehicle keys with you to an
authorized dealer.
Customer Key Programming
If you have two valid Sentry Keys , you can program
new Sentry Keys to the system by performing the
following procedure:
1. Cut the additional Sentry Key Transponder blank(s)
to match the ignition switch lock cylinder key code.
2. Insert the first valid key into the ignition switch. Turn
the ignition switch to the ON/RUN position for at least
three seconds, but no longer than 15 seconds. Then, turn
the ignition switch to the LOCK position and remove the
first key. 3. Insert the second valid key into the ignition switch.
Turn the ignition switch to the ON/RUN position within
15 seconds. After 10 seconds, a chime will sound. In
addition, the Vehicle Security Light will begin to flash.
Turn the ignition switch to the LOCK position and
remove the second key.
4. Insert a blank Sentry Key
into the ignition switch.
Turn the ignition switch to the ON/RUN position within
60 seconds. After 10 seconds, a single chime will sound.
In addition, the Vehicle Security Light will stop flashing.
To indicate that programming is complete, the Vehicle
Security Light will turn on again for three seconds and
then turn off.
The new Sentry Key is programmed.The Remote
Keyless Entry (RKE) transmitter will also be pro-
grammed during this procedure.
16 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

Hood Release.......................... 145
Ignition ............................... 12
Key ............................... 12
Ignition Key Removal ..................... 12
Immobilizer (Sentry Key) ................... 14
Infant Restraint .......................... 75
Information Center, Vehicle ................. 207
Inside Rearview Mirror .................... 93
Instrument Cluster ....................... 192
Instrument Panel and Controls .............. 190
Instrument Panel Cover ................... 429
Instrument Panel Lens Cleaning ............. 429
Integrated Power Module (Fuses) ............ 430
Interior Appearance Care .................. 427
Intermittent Wipers (Delay Wipers) ........... 153
Introduction ............................. 4 Jack Location
........................... 376
Jack Operation ....................... 376,378
Jacking Instructions ...................... 378
Jump Starting .......................... 384
Key-In Reminder ......................... 14
Key, Programming ........................ 16
Key, Replacement ........................ 15
Key, Sentry (Immobilizer) ................... 14
Keyless Entry System (Sedan) ................ 19
Keys ................................. 12
Knee Bolster ............................ 60
Lane Change and Turn Signals .............. 436
Lap/Shoulder Belts ....................... 40
Latches ................................ 87
Hood ............................. 145
Lead Free Gasoline ...................... 349
Leaks, Fluid ............................ 87
10
INDEX 477

Tilting............................ 138
Security Alarm (Theft Alarm) ................ 17
Selection of Oil ......................... 404
Sentry Key (Immobilizer) ................... 14
Sentry Key Programming ................... 16
Sentry Key Replacement ................... 15
Service Assistance ....................... 461
Service Contract ......................... 463
Service Manuals ........................ 465
Setting the Clock .................. 220,238,248
Settings, Personal ........................ 213
Shift Lever Override ...................... 390
Shift Speeds, Manual Transaxle .............. 293
Shoulder Belts ........................... 40
Side Airbag ............................. 68
Side Window Demisters (Defrosters) .......... 283
Signals, Turn ...................... 87,193,436
Snow Chains (Tire Chains) ................. 337
Snow Tires ............................ 337 Spare Tire
....................... 332,333,377
Specifications Oil ............................... 404
Speed Control (Cruise Control) ...........155,198
Speedometer ........................... 193
Starting ............................... 289
Automatic Transmission ................ 289
Engine Fails to Start .................. 291
Manual Transmission .................. 289
Remote ............................ 25
Starting Procedures ...................... 289
Steering Power .......................... 301,302
Tilt Column ........................ 154
Steering Wheel Audio Controls .............. 269
Steering Wheel Mounted Sound
System Controls ......................... 269
Storage ............................ 174,434
Storage Bin ............................ 174
10
INDEX 483