hood release JEEP GRAND CHEROKEE 2006 WK / 3.G SRT Owners Manual
[x] Cancel search | Manufacturer: JEEP, Model Year: 2006, Model line: GRAND CHEROKEE, Model: JEEP GRAND CHEROKEE 2006 WK / 3.GPages: 392, PDF Size: 10.78 MB
Page 117 of 392
TO OPEN AND CLOSE THE HOOD
To open the hood, pull the release lever inside your
vehicle located below the instrument panel and in front
of the driver’s door.Then, reach under the hood, move safety latch to the left,
and lift the hood. To prevent possible damage, do not
slam the hood to close it. Use a firm downward push at
the center of the hood to ensure that both latches engage.
Hood Release LeverUnderhood Safety Latch
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 117
3
Page 311 of 392
WARNING!
Fluid level should be checked on a level surface with
the engine off to prevent injury from moving parts,
and to insure accurate fluid level reading. Do not
overfill. Use only the manufacturer’s recommended
fluid.
If necessary, add fluid to restore to the proper indicated
level. With a clean cloth, wipe any spilled fluid from all
surfaces. Refer to Fluids, Lubricants, and Genuine Parts
for correct fluid type.
NOTE:Upon initial start-up in cold weather, the power
steering pump may make noise for a short period of time.
This is due to the cold, thick fluid in the steering system.
This noise should be considered normal, and does not in
any way damage the steering system.
Body Lubrication
Locks and all body pivot points, including such items as
seat tracks, doors, trunk and hood hinges, should be
lubricated periodically to assure quiet, easy operation
and to protect against rust and wear. Prior to the appli-
cation of any lubricant, the parts concerned should be
wiped clean to remove dust and grit; after lubricating
excess oil and grease should be removed. Particular
attention should also be given to hood latching compo-
nents to insure proper function. When performing other
underhood services, the hood latch, release mechanism
and safety catch should be cleaned and lubricated.
The external lock cylinders should be lubricated twice a
year, preferably in the fall and spring. Apply a small
amount of a high quality MoparLock Cylinder Lubri-
cant or equivalent directly into the lock cylinder.
MAINTAINING YOUR VEHICLE 311
7
Page 380 of 392
Hitches
Trailer Towing........................ 277
Holder, Cup........................... 162
HomeLink(Garage Door Opener) Transmitter . . . 150
Hood Release.......................... 117
Hoses.............................319,322
Ignition
Key ................................. 12
Illuminated Entry........................ 16
Infant Restraint.......................... 59
Inflation Pressure Tires.................... 258
Information Center, Vehicle................. 183
Instrument Cluster....................175,176
Instrument Panel and Controls.............. 174
Instrument Panel Lens Cleaning............. 328
Integrated Power Module.................. 332
Interior Appearance Care.................. 327
Interior Fuses.......................... 328Interior Lighting........................ 118
Interior Lights....................... 118,123
Intermittent Wipers (Delay Wipers)........... 127
Introduction............................. 4
Jump Starting.......................... 289
Key, Programming........................ 15
Key, Replacement........................ 14
Key, Sentry (Immobilizer)................... 13
Key-In Reminder......................... 13
Keyless Entry System...................... 20
Keys................................. 12
Lap/Shoulder Belts....................... 33
LATCH
(Lower Anchors and Tether for CHildren).....63,65
Lead Free Gasoline...................... 268
Leaks, Fluid............................ 72
380 INDEX