Universal Transmitter....................... .109
Untwisting Procedure, Seat Belt ................219
Vanity Mirrors .............................65
Vehicle Identification Number (VIN) .............504
Vehicle Loading ....................... .369, 480
Vehicle Modifications/Alterations .................7
Vehicle Security Alarm (Security Alarm) ...........32
Vehicle Storage .............................88
Viscosity, Engine Oil .....................450, 451
Voice Recognition System (VR) .................588
Warning Flasher, Hazard .....................398
Warning, Roll Over ...........................6
Warnings And Cautions .......................7
Warranty Information ...................... .613
Washers, Headlight ..........................79
Washers, Windshield ..................... .74, 448
Washing Vehicle .......................... .499Wheel And Wheel Trim
..................... .492
Wheel And Wheel Trim Care ..................492
Wind Buffeting ....................... .92, 94, 98
Window Fogging ...........................88
Windows Close ..................................90
Down .................................90
Open ..................................90
Power .................................90
Up....................................90
Windshield Defroster ....................... .257
Windshield Washers ..................... .74, 448
Fluid ................................ .448
Windshield Wiper Blades .....................460
Windshield Wipers ..........................74
Wiper Blade Replacement .....................460
Wipers, Intermittent .........................75
Wipers, Rain Sensitive ........................77
12
INDEX 629
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.
