garage door opener JEEP GRAND CHEROKEE 2017 WK2 / 4.G Owners Manual
[x] Cancel search | Manufacturer: JEEP, Model Year: 2017, Model line: GRAND CHEROKEE, Model: JEEP GRAND CHEROKEE 2017 WK2 / 4.GPages: 633, PDF Size: 6.6 MB
Page 21 of 633
GARAGE DOOR OPENER — IF EQUIPPED . . . .109
▫ Before You Begin Programming HomeLink .....109
▫ Canadian/Gate Operator Programming .......112
▫ Using HomeLink .......................113
▫ Security ..............................113
▫ Troubleshooting Tips ....................113
▫ General Information .....................114
INTERNAL EQUIPMENT ..................115
▫ Storage ..............................115
▫ Cupholders ......................... .121
▫ Sun Visor “Slide-On-Rod” Feature —
If Equipped ......................... .122
▫ Electrical Power Outlets ..................122
▫ Power Inverter — If Equipped .............126
ROOF LUGGAGE RACK — IF EQUIPPED ......126
3
GETTING TO KNOW YOUR VEHICLE 19
Page 111 of 633
GARAGE DOOR OPENER — IF EQUIPPED
HomeLink replaces up to three hand-held transmitters that
operate devices such as garage door openers, motorized
gates, lighting or home security systems. The HomeLink
unit is powered by your vehicle’s 12 Volt battery.
The HomeLink buttons, located on the overhead console,
designate the three different HomeLink channels. The
HomeLink indicator is located above the center button.
NOTE:HomeLink is disabled when the Vehicle Security
Alarm is active.
Before You Begin Programming HomeLink
Be sure that your vehicle is parked outside of the garage
before you begin programming.
For more efficient programming and accurate transmission
of the radio-frequency signal it is recommended that a new
battery be placed in the hand-held transmitter of the device
that is being programmed to the HomeLink system.
To erase the channels place the ignition in the ON/RUN
position and push and hold the two outside HomeLink
buttons (I and III) for up to 20 seconds or until the orange
indicator flashes.
NOTE:
• Erasing all channels should only be performed when
programming HomeLink for the first time. Do not erase
channels when programming additional buttons.
• If you have any problems, or require assistance, please
call toll-free 1-800-355-3515 or, on the Internet at
HomeLink.com for information or assistance.
HomeLink Buttons/Overhead Console
3
GETTING TO KNOW YOUR VEHICLE 109
Page 112 of 633
Programming A Rolling Code
For programming garage door openers that were manufac-
tured after 1995. These garage door openers can be identi-
fied by the “LEARN” or “TRAIN” button located where
the hanging antenna is attached to the garage door opener.
NOTE:It is NOT the button that is normally used to open
and close the door. The name and color of the button may
vary by manufacturer. 1. Place the ignition in the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm)
away from the HomeLink button you wish to program
while keeping the HomeLink indicator light in view.
3. Push and hold the HomeLink button you want to program while you push and hold the hand-held trans-
mitter button.
4. Continue to hold both buttons and observe the indicator light. The HomeLink indicator will flash slowly and
then rapidly after HomeLink has received the frequency
signal from the hand-held transmitter. Release both
buttons after the indicator light changes from slow to
rapid.
5. At the garage door opener motor (in the garage), locate the “LEARN” or “TRAINING” button. This can usually
be found where the hanging antenna wire is attached to
the garage door opener/device motor. Firmly push and
release the “LEARN” or “TRAINING” button. On some
garage door openers/devices there may be a light that
blinks when the garage door opener/device is in the
LEARN/TRAIN mode.
NOTE: You have 30 seconds in which to initiate the next
step after the LEARN button has been pushed.
Training The Garage Door Opener
1 — Door Opener
2 — Training Button 110 GETTING TO KNOW YOUR VEHICLE
Page 113 of 633
6. Return to the vehicle and push the programmedHomeLink button twice (holding the button for two
seconds each time). If the garage door opener/device
activates, programming is complete.
NOTE: If the garage door opener/device does not activate,
push the button a third time (for two seconds) to complete
the training.
To program the remaining two HomeLink buttons, repeat
each step for each remaining button. DO NOT erase the
channels.
Reprogramming A Single HomeLink Button (Rolling
Code)
To reprogram a channel that has been previously trained,
follow these steps:
1. Cycle the ignition to the ON/RUN position.
2. Push and hold the desired HomeLink button until the indicator light begins to flash after 20 seconds. Do not
release the button.
3. Without releasing the button proceed with “Program- ming A Rolling Code” step 2 and follow all remaining
steps.Programming A Non-Rolling Code
For programming Garage Door Openers manufactured
before 1995.
1. Cycle the ignition to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm)away from the HomeLink button you wish to program
while keeping the HomeLink indicator light in view.
3. Push and hold the Homelink button you want to program while you push and hold the hand-held trans-
mitter button.
4. Continue to hold both buttons and observe the indicator light. The Homelink indicator will flash slowly and then
rapidly after HomeLink has received the frequency
signal from the hand-held transmitter. Release both
buttons after the indicator light changes from slow to
rapid.
5. Push and hold the programmed HomeLink button and observe the indicator light.
• If the indicator light stays on constantly, programming
is complete and the garage door/device should acti-
vate when the HomeLink button is pushed.
3
GETTING TO KNOW YOUR VEHICLE 111
Page 115 of 633
NOTE:•If the indicator light stays on constantly, programming
is complete and the garage door/device should acti-
vate when the HomeLink button is pushed.
• To program the two remaining HomeLink buttons,
repeat each step for each remaining button. DO NOT
erase the channels.
If you unplugged the garage door opener/device for
programming, plug it back in at this time.
Reprogramming A Single HomeLink Button (Canadian/
Gate Operator)
To reprogram a channel that has been previously trained,
follow these steps:
1. Cycle the ignition to the ON/RUN position.
2. Push and hold the desired HomeLink button until the indicator light begins to flash after 20 seconds. Do not
release the button.
3. Without releasing the button proceed with “Canadian/ Gate Operator Programming” step 2 and follow all
remaining steps.Using HomeLink
To operate, push and release the programmed HomeLink
button. Activation will now occur for the programmed
device (i.e. garage door opener, gate operator, security
system, entry door lock, home/office lighting, etc.) The
hand-held transmitter of the device may also be used at
any time.
Security
It is advised to erase all channels before you sell or turn in
your vehicle.
To do this, push and hold the two outside buttons for 20
seconds until the orange indicator flashes. Note that all
channels will be erased. Individual channels cannot be
erased.
The HomeLink Universal Transceiver is disabled when the
Vehicle Security Alarm is active.
Troubleshooting Tips
If you are having trouble programming HomeLink, here
are some of the most common solutions:
•Replace the battery in the Garage Door Opener hand-
held transmitter.
3
GETTING TO KNOW YOUR VEHICLE 113
Page 116 of 633
•Push the LEARN button on the Garage Door Opener to
complete the training for a Rolling Code.
• Did you unplug the device for programming and re-
member to plug it back in?
If you have any problems, or require assistance, please call
toll-free 1-800-355-3515 or, on the Internet at
HomeLink.com for information or assistance.
WARNING!
• Vehicle exhaust contains carbon monoxide, a danger-
ous gas. Do not run your vehicle in the garage while
programming the transceiver. Exhaust gas can cause
serious injury or death.
• Your motorized door or gate will open and close
while you are programming the universal trans-
ceiver. Do not program the transceiver if people, pets
or other objects are in the path of the door or gate.
Only use this transceiver with a garage door opener
that has a “stop and reverse” feature as required by
Federal safety standards. This includes most garage
door opener models manufactured after 1982. Do not
(Continued)
WARNING! (Continued)
use a garage door opener without these safety fea-
tures. Call toll-free 1-800-355-3515 or, on the Internet
at HomeLink.com for safety information or assis-
tance.
General Information
This device complies with FCC rules Part 15 and Industry
Canada RSS-210. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference that may be
received including interference that may cause unde-
sired operation.
NOTE:
• The transmitter has been tested and it complies with
FCC and IC rules. Changes or modifications not ex-
pressly approved by the party responsible for compli-
ance could void the user ’s authority to operate the
device.
114 GETTING TO KNOW YOUR VEHICLE
Page 120 of 633
Your vehicle may have an optional CD or DVD player
located in the center console.
WARNING!
Do not operate this vehicle with a console compart-
ment lid in the open position. Driving with the console
compartment lid open may result in injury in a colli-
sion.
Overhead Console
The overhead console contains courtesy/reading lights
and storage for sunglasses. Universal Garage Door Opener
(HomeLink), power liftgate and power sunroof switches
may also be included, if equipped.
Lower Storage Compartment CD/DVD Player — IfEquipped
Overhead Console
118 GETTING TO KNOW YOUR VEHICLE
Page 417 of 633
CavityCartridge Fuse Micro Fuse Description
F78 –10 Amp Red
Engine Control Module/Electric Power Steering
F80 –10 Amp Red Universal Garage Door Opener/Compass/
Anti-Intrusion Module
F81 –20 Amp Yellow Trailer Tow Right Turn/Stop Lights
F82 –10 Amp Red Steering Column Control Module/Cruise
Control/DTV
F83 –10 Amp Red Fuel Door
F84 –15 Amp Blue Switch Bank/Instrument Cluster
F85 –10 Amp Red Airbag Module
F86 –10 Amp Red Airbag Module
F87 –10 Amp Red Air Suspension — If Equipped/Trailer Tow/
Steering Column Control Module
F88 –15 Amp Blue Instrument Panel Cluster
F90/F91 –20 Amp Yellow Power Outlet (Rear seats) Selectable
F92 –10 Amp Red Rear Console Lamp — If Equipped
F93 –20 Amp Yellow Cigar Lighter
F94 –10 Amp Red Shifter/Transfer Case Module
F95 –10 Amp Red Rear Camera/ParkSense
F96 –10 Amp Red Rear Seat Heater Switch/Flashlamp Charger
— If Equipped
7
IN CASE OF EMERGENCY 415
Page 621 of 633
DipsticksOil (Engine) ........................... .448
Disabled Vehicle Towing .....................433
Disposal Antifreeze (Engine Coolant) .................470
Do Not Disturb ........................... .606
Door Ajar ............................... .156
Door Ajar Light ........................... .156
Door Opener, Garage ....................... .109
Driver’s Seat Back Tilt ........................41
Driving ................................. .389
DVD Player (Video Entertainment System) .........571
Economy (Fuel) Mode ...................... .274
Electrical Outlet, Auxiliary (Power Outlet) .........122
Electric Remote Mirrors .......................63
Electronic Brake Control System ................181
Anti-Lock Brake System ....................180
Electronic Roll Mitigation ...................188
Traction Control System ....................184
Electronic Speed Control (Cruise Control) . . .296, 297, 299
Electronic Stability Control (ESC) ...............185
Electronic Throttle Control Warning Light .........155
Emergency, In Case Of Freeing Vehicle When Stuck .................432 Hazard Warning Flasher
...................398
Jacking ............................... .475
Jump Starting .......................... .425
Tow Hooks ............................ .436
Emission Control System Maintenance ............177
Engine .............................. .445, 447
Air Cleaner ............................ .452
Block Heater ........................... .270
Break-In Recommendations .................270
Checking Oil Level ...................... .448
Compartment ....................445, 446, 447
Compartment Identification ..............445, 446
Coolant (Antifreeze) ..................... .512
Cooling .............................. .467
Exhaust
Gas Caution ...................256, 510
Fails To Start ........................... .267
Flooded, Starting ........................ .267
Identification ........................... .447
Jump Starting .......................... .425
Oil ........................... .450, 511, 512
Oil Filler Cap ....................... .445, 451
Oil Filter .............................. .452
Oil Selection ........................ .450, 511
Oil Synthetic ........................... .451
Overheating ........................... .428
12
INDEX 619
Page 622 of 633
Starting.............................. .265
Engine Oil Viscosity .....................450, 451
Engine Oil Viscosity Chart ....................450
Enhanced Accident Response Feature .........236, 436
Ethanol ................................. .508
Exhaust Gas Caution .....................256, 510
Exhaust System ....................... .256, 465
Exterior Lights ......................... .66, 259
Filters Air Cleaner ............................ .452
Air Conditioning ...................88, 452, 455
Engine Oil ......................... .452, 512
Engine Oil Disposal ...................... .451
Flashers ................................ .398
Hazard Warning ........................ .398
Turn Signal ..................... .171, 259, 405
Flash-To-Pass ..............................70
Flooded Engine Starting ..................... .267
Fluid, Brake ............................. .514
Fluid Capacities ............................511
Fluid Leaks .............................. .259
Fluid Level Checks Brake ................................ .471
Folding Rear Seat ...........................44 Forward Collision Warning
....................203
Four-Way Hazard Flasher .....................398
Four Wheel Drive ...................... .283, 293
Operation ............................. .283
Systems .............................. .283
Four Wheel Drive Operation ..................283
Freeing A Stuck Vehicle ..................... .432
Front Axle (Differential) ..................... .474
Fuel ................................... .506
Adding .............................. .366
Additives ............................. .507
Clean Air ............................. .507
Economy Mode ......................... .274
Ethanol .............................. .508
Gasoline .............................. .506
Light ................................ .164
Materials
Added........................ .507
Methanol ............................. .508
Octane Rating ....................... .506, 512
Specifications .......................... .512
Tank Capacity ...........................511
Fueling ................................. .366
Garage Door Opener (HomeLink) ............109, 113
Gasoline, Clean Air ........................ .507
620 INDEX