reset JEEP PATRIOT 2008 1.G User Guide

By pressing the SEEK button when the PTY icon is
displayed, the radio will be tuned to the next frequency
station with the same selected PTY name. The PTY
function only operates when in the FM mode.
If a preset button is activated while in the PTY (Program
Type) mode, the PTY mode will be exited and the radio
will tune to the preset station.
SET/DIR Button (Radio Mode) — To Set the
Pushbutton Memory
When you are receiving a station that you wish to
commit to pushbutton memory, press the SET/DIR but-
ton. The symbol SET 1 will now show in the display
window. Select the button (1-6) you wish to lock onto this
station and press and release that button. If a button is
not selected within five seconds after pressing the SET/
DIR button, the station will continue to play but will not
be stored into pushbutton memory.You may add a second station to each pushbutton by
repeating the above procedure with this exception: Press
the SET/DIR button twice and SET 2 will show in the
display window. Each button can be set for SET 1 and
SET 2 in both AM and FM. This allows a total of 12 AM,
12 FM and 12 Satellite (if equipped) stations to be stored
into pushbutton memory. The stations stored in SET 2
memory can be selected by pressing the pushbutton
twice.
Every time a preset button is used, a corresponding
button number will be displayed.
Buttons1-6(Radio Mode)
These buttons tune the Radio to the stations that you
commit to pushbutton memory, 12AM, 12 FM, and 12
Satellite (if equipped) stations.
208 UNDERSTANDING YOUR INSTRUMENT PANEL

Storing And Selecting Preset Channels
In addition to the 12 AM and 12 FM preset stations, you
may also commit 12 satellite stations to pushbutton
memory. These satellite channel preset stations will not
erase any AM or FM preset memory stations. Follow the
memory preset procedures that apply to your radio.
Using The PTY (Program Type) Button — If
Equipped
Follow the PTY button instructions that apply to your
radio.
PTY Button SCAN
When the desired program type is obtained, press the
SCAN button within five seconds. The radio will play
seven seconds of the selected channel before moving to
the next channel of the selected program type. Press the
SCAN button a second time to stop the search.NOTE:Pressing the SEEK or SCAN button, while
performing a music type scan, will change the channel by
one and stop the search. Pressing a preset memory button
during a music type scan will call up the memory
channel and stop the search.
PTY Button SEEK
When the desired program is obtained, press the SEEK
button within five seconds. The channel will change to
the next channel that matches the program type selected.
Satellite Antenna
To ensure optimum reception on vehicles available with
a luggage rack, do not place items on the roof around the
rooftop antenna location. Metal objects placed within the
line of sight of the antenna will cause decreased perfor-
mance. Larger luggage items should be placed as far
forward as possible. Do not place items directly on or
above the antenna.
UNDERSTANDING YOUR INSTRUMENT PANEL 223
4

The left-hand control is a rocker type switch with a
pushbutton in the center. The function of the left-hand
control is different depending on which mode you are in.
The following describes the left-hand control operation in
each mode.
Radio Operation
Press the top of the switch to SEEK up to the next
listenable station.
Press the bottom of the switch to SEEK down to the next
listenable station.
The button located in the center of the left-hand control
will tune to the next preset station that you have pro-
grammed in the radio preset pushbuttons.
CD Player
Press the top of the switch once to go to the next track on
the CD.
Press the bottom of the switch once to go to the beginning
of the current track or to the beginning of the previous
track, if it is within one second after the current track
begins to play.
If you press the switch up or down twice it plays the
second track, three times, it will play the third, etc.
The button in the center of the left-hand switch changes
CDs on the 6-disc in-dash CD changer radio. This button
does not function for all other radios.
UNDERSTANDING YOUR INSTRUMENT PANEL 225
4

WARNING!
•Never have any smoking materials lit in or near
the vehicle when the gas cap is removed or the
tank filled.
•Never add fuel when the engine is running. This is
in violation of most state and Federal fire regula-
tions and will cause the Malfunction Indicator
Light (MIL) to turn on.
NOTE:Tighten the gas cap about 1/4 turn until you
hear one click. This is an indication that cap is properly
tightened.
If the gas cap is not tighten properly, the MIL will come
on. Be sure the gas cap is tightened every time the vehicle
is refueled.
WARNING!
A fire may result if gasoline is pumped into a
portable container that is inside of a vehicle. You
could be burned. Always place gas containers on the
ground while filling.
Loose Fuel Filler Cap Message
If the vehicle diagnostic system determines that the fuel
filler cap is loose or improperly installed, a “gASCAP”
message will be displayed in the Odometer/Trip Odom-
eter in the instrument cluster. Refer to “Instrument
Cluster Description” in Section 4 of this manual. Tighten
the fuel filler cap properly and press the odometer/trip
odometer RESET button to turn the message off. If the
problem continues, the message will appear the next time
316 STARTING AND OPERATING

RESET button to turn off the message. If the problem
persists, the message will appear the next time the
vehicle is started. This might indicate a damaged cap. If
the problem is detected twice in a row, the system will
turn on the MIL. Resolving the problem will turn the MIL
light off.
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of this vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.
For states that require an Inspection and Mainte-
nance (I/M), this check verifies the Malfunction
Indicator Light (MIL) is functioning and is not on
when the engine is running, and that the OBD II system
is ready for testing.Normally, the OBD II system will be ready. The OBD II
system maynotbe ready if the vehicle was recently
serviced, recently had a dead battery, or a battery replace-
ment. If the OBD II system should be determined not
ready for the I/M test, the vehicle may fail the test.
This vehicle has a simple ignition key-actuated test,
which you can use prior to going to the test station. To
check if this vehicle’s OBD II system is ready, you must
do the following:
1. Insert the ignition key into the ignition switch.
2. Turn the ignition to the ON position, but do not crank
or start the engine.
3. If you crank or start the engine, you will have to start
this test over.
4. As soon as you turn the ignition key to the ON
position, you will see the MIL symbol come on as part of
a normal bulb check.
350 MAINTAINING YOUR VEHICLE

NOTE:
•The oil change indicator message will not monitor the
time since the last oil change. Change your vehicles oil
if it has been six months since your last oil change and
even if the oil change indicator message is NOT
illuminated.
•Change your engine oil more often if you drive your
vehicle off-road for an extended period of time.
•Under no circumstances should oil change intervals
exceed 6,000 mi (10 000 km) or six months, whichever
comes first.
Your authorized dealer will reset the oil change indicator
message after completing the scheduled oil change. If this
scheduled oil change is performed by someone otherthan your authorized dealer, the message can be reset by
referring to the steps described under “Oil Change
Required” in “Use Factory Settings” of the EVIC section
in this manual or under “Odometer/Trip Odometer” in
the Instrument Cluster Descriptions section of this
manual.
At Each Stop for Fuel
•Check the engine oil level about five minutes after a
fully warmed engine is shut off. Checking the oil level
while the vehicle is on level ground will improve the
accuracy of the oil level reading. Add oil only when
the level is at or below the ADD or MIN mark.
•Check the windshield washer solvent and add if
required.
MAINTENANCE SCHEDULES 401
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Malfunction Indicator Light (Check Engine) . . 181,350
Manual, Service......................... 414
Manual Transaxle..................239,242,374
Downshifting......................... 243
Fluid Level Check...................374,375
Frequency of Fluid Change............375,376
Lubricant Selection..................374,375
Map/Reading Lights..................... 120
Master Cylinder (Brakes).................. 372
Mirrors ................................ 78
Electric Powered....................... 80
Exterior Folding........................ 80
Outside.............................. 79
Rearview............................. 78
Vanity ............................... 82
Modifications/Alterations, Vehicle............. 8
Monitor, Tire Pressure System............... 301
Mopar Parts.........................351,413
Multi-Function Control Lever............... 121Navigation Radio........................ 217
Navigation System....................... 217
New Vehicle Break-In Period................ 69
Occupant Restraints....................... 35
Octane Rating, Gasoline (Fuel).............. 311
Odometer............................. 179
Trip .............................177,179
Off-Pavement Driving (Off-Road)............ 252
Off-Road Driving (Off-Pavement)............ 252
Oil Change Indicator..................... 184
Oil Change Indicator, Reset................. 184
Oil, Engine.........................352,395
Capacity............................ 395
Change Interval....................... 354
Checking............................ 352
Disposal............................ 355
Filter ............................... 355
Identification Logo..................... 354
INDEX 427
10

Guide .............................. 321
Recreational.......................... 329
Weight .............................. 321
Towing Assistance........................ 95
Traction.............................. 276
TrailerTowing .......................... 317
Cooling System Tips.................... 328
Hitches............................. 320
Minimum Requirements................. 323
Trailer and Tongue Weight................ 322
Wiring .............................. 326
TrailerTowingGuide ..................... 321
TrailerWeight .......................... 321
Transaxle............................. 244
Automatic.................... 13,239,244,373
Autostick............................ 249
Manual........................ 12,239,242
Operation........................... 244
Overdrive........................... 248Selection of Lubricant................... 373
Transmission
Range Indicator....................... 177
Transmitter Battery Service
(Remote Keyless Entry).................... 24
Transmitter, Garage Door Opener
(HomeLink) ........................... 142
Transmitter Programming
(Remote Keyless Entry).................... 22
Transporting Pets........................ 68
Tread Wear Indicators.................... 297
Trip Odometer.......................... 179
Trip Odometer Reset Button................ 177
Turn Signals......................123,173,389
UConnect(Hands-Free Phone).............. 82
Understanding Your Instrument Panel......... 170
Uniform Tire Quality Grades................ 415
Universal Transmitter..................... 142
INDEX 433
10