mirror JEEP RENEGADE 2016 1.G Owners Manual
[x] Cancel search | Manufacturer: JEEP, Model Year: 2016, Model line: RENEGADE, Model: JEEP RENEGADE 2016 1.GPages: 688, PDF Size: 7.09 MB
Page 22 of 688
FRONT VIEW
Front View
1 — Headlights
2 — Engine Compartment
3 — Windshield4 — Doors
5 — Exterior Mirrors
6 — Wheels 20 GRAPHICAL TABLE OF CONTENTS
Page 23 of 688
Front View (Trailhawk)
Front View (Trailhawk)
1 — Headlights
2 — Engine Compartment
3 — Windshield4 — Doors
5 — Exterior Mirrors
6 — Wheels
3
GRAPHICAL TABLE OF CONTENTS 21
Page 30 of 688
VEHICLE SECURITY ALARM..............51
▫To Arm The System....................52
▫To Disarm The System...................53
▫Disabling............................54
DOORS..............................54
▫Manual Door Locks.....................54
▫Central Lock/Unlock....................56
▫Keyless Enter-N-Go....................58
▫Child Locks..........................65
SEATS ...............................66
▫Manual Front Seats.....................67
▫Power Adjustment (Front) — If Equipped.....69
▫Heated Seats — If Equipped...............71▫Rear Seats............................72
HEAD RESTRAINTS.....................78
▫Front Head Restraints...................79
▫Rear Head Restraints....................80
STEERING WHEEL......................81
▫Tilt/Telescoping Steering Column...........81
▫Heated Steering Wheel — If Equipped.......82
MIRRORS.............................83
▫Inside Day/Night Mirror................83
▫Auto Dimming Mirror — If Equipped........84
▫Outside Mirrors.......................85
▫Heated Mirrors — If Equipped............87
28 GETTING TO KNOW YOUR VEHICLE
Page 85 of 688
WARNING!(Continued)
•Do not place anything on the steering wheel that
insulates against heat, such as a blanket or steering
wheel covers of any type and material. This may
cause the steering wheel heater to overheat.
MIRRORS
Inside Day/Night Mirror
The mirror can be adjusted up, down, left, and right. The
mirror should be adjusted to center on the view through
the rear window. Headlight glare from vehicles behind
you can be reduced by moving the lever under the mirror
to the night position (toward the rear of the vehicle). The
mirror should be adjusted while the lever under the
mirror is set in the day position (toward the windshield).NOTE:The mirror will automatically release in the event
of heavy contact with a passenger.
Mirror Adjustment
4
GETTING TO KNOW YOUR VEHICLE 83
Page 86 of 688
Auto Dimming Mirror — If Equipped
This mirror automatically adjusts for headlight glare
from vehicles behind you. You can turn the feature on or
off by pushing the button at the base of the mirror. A light
to the left of the button will illuminate to indicate when
the dimming feature is activated. The sensor to the right
of the button does not illuminate.
NOTE:This feature is disabled when the vehicle is
moving in reverse.
Dimming Mirror
84 GETTING TO KNOW YOUR VEHICLE
Page 87 of 688
Outside Mirrors
Power Adjustment Mirrors — If Equipped
The power mirror switch is located on the drivers door
panel.
To adjust the mirror, push the mirror adjustment switch
in the four directions indicated by arrows.
NOTE:
•To adjust the power mirrors, the ignition must be in
the MAR/RUN position.
•Once the mirror is adjusted, rotate the control to the
neutral position to avoid accidental movements.
Power Mirror Switch
1 — Mirror Selector Switch
2 — Mirror Adjustment Switch
4
GETTING TO KNOW YOUR VEHICLE 85
Page 88 of 688
Manual Adjustment Mirrors — If Equipped
To adjust the exterior mirrors, push the corners of the
mirrors till desired alignment is obtained.Folding Mirror
The exterior mirrors are hinged to allow the mirror to
pivot forward or rearward to help avoid damage. The
mirror has three detent positions: full forward, normal
and full rearward.
Manual Adjustment Mirror
Folding Exterior Mirror
86 GETTING TO KNOW YOUR VEHICLE
Page 89 of 688
Heated Mirrors — If Equipped
These mirrors are heated to melt frost or ice. This
feature can be activated whenever you turn on the
Rear Window Defroster.
BLIND SPOT MONITORING (BSM) — IF
EQUIPPED
The Blind Spot Monitoring (BSM) system uses two radar-
based sensors, located inside the rear bumper fascia, to
detect highway licensable vehicles (automobiles, trucks,
motorcycles, etc.) that enter the blind spot zones from the
rear/front/side of the vehicle.
When the vehicle is started, the BSM warning light will
momentarily illuminate in both outside rear view mirrors
to let the driver know that the system is operational. The
BSM system sensors operate when the vehicle is in any
forward gear or REVERSE and enters stand-by mode
when the vehicle is in PARK.
Rear Detection Zones
4
GETTING TO KNOW YOUR VEHICLE 87
Page 90 of 688
The BSM detection zone covers approximately one lane
width on both sides of the vehicle, 10 ft (3 m). The zone
length starts at the outside mirror and extends approxi-
mately 20 ft (6 m) beyond the rear bumper of the vehicle.
The BSM system monitors the detection zones on both
sides of the vehicle when the vehicle speed reaches
approximately 6 mph (10 km/h) or higher and will alert
the driver of vehicles in these areas.
NOTE:
•The BSM system does NOT alert the driver about
rapidly approaching vehicles that are outside the de-
tection zones.
•If a trailer is connected to the vehicle, it is necessary to
deactivate BSM system manually by settings menu to
avoid a misdetection. Refer to “Uconnect Settings” in
“Multimedia” for further information.The area on the rear fascia where the radar sensors are
located must remain free of snow, ice, and dirt/road
contamination so that the BSM system can function
properly. Do not block the radar sensors located on the
rear fascia with foreign objects (bumper stickers, bicycle
racks, etc.).
Rear Sensor Locations
88 GETTING TO KNOW YOUR VEHICLE
Page 91 of 688
The BSM system notifies the driver of objects in the
detection zones by illuminating the BSM warning light
located in the outside mirrors in addition to sounding an
audible (chime) alert and reducing the radio volume.
Refer to “Modes Of Operation” for further information.
The BSM system monitors the detection zone from three
different entry points (side, rear, front) while driving to
see if an alert is necessary. The BSM system will issue an
alert during these types of zone entries.
BSM Warning Light
4
GETTING TO KNOW YOUR VEHICLE 89