engine overheat JEEP RENEGADE 2017 1.G User Guide
[x] Cancel search | Manufacturer: JEEP, Model Year: 2017, Model line: RENEGADE, Model: JEEP RENEGADE 2017 1.GPages: 516, PDF Size: 5.73 MB
Page 369 of 516

and hold the lock button on the gear selector. Then shift
back and forth between DRIVE and REVERSE (with auto-
matic transmission) or SECOND GEAR and REVERSE
(with manual transmission), while gently pressing the
accelerator.
Use the least amount of accelerator pedal pressure that will
maintain the rocking motion without spinning the wheels
or racing the engine.
For Vehicles With Automatic Transmission:
Shifts between DRIVE and REVERSE can only be achieved
at wheel speeds of 5 mph (8 km/h) or less. Whenever the
transmission remains in NEUTRAL for more than two
seconds, you must press the brake pedal to engage DRIVE
or REVERSE.
NOTE:Push the ESC Off switch (if necessary), to place
the Electronic Stability Control (ESC) system in Partial Off
mode, before rocking the vehicle. Refer to “Electronic
Brake Control” in “Safety” for further information. Once
the vehicle has been freed, push the ESC Offswitch again
to restore ESC Onmode.WARNING!
Fast spinning tires can be dangerous. Forces generated
by excessive wheel speeds may cause damage, or even
failure, of the axle and tires. A tire could explode and
injure someone. Do not spin your vehicle’s wheels
faster than 30 mph (48 km/h) or for longer than 30
seconds continuously without stopping when you are
stuck and do not let anyone near a spinning wheel, no
matter what the speed.
CAUTION!
•Racing the engine or spinning the wheels may lead
to transmission overheating and failure. Allow the
engine to idle with the transmission in NEUTRAL
for at least one minute after every five rocking-
motion cycles. This will minimize overheating and
reduce the risk of clutch or transmission failure
during prolonged efforts to free a stuck vehicle.
• When “rocking” a stuck vehicle by shifting between
DRIVE/ SECOND gear and REVERSE, do not spin
the wheels faster than 15 mph (24 km/h), or drive-
train damage may result.
(Continued)
7
IN CASE OF EMERGENCY 367
Page 370 of 516

CAUTION!(Continued)
•Revving the engine or spinning the wheels too fast
may lead to transmission overheating and failure. It
can also damage the tires. Do not spin the wheels
above 30 mph (48 km/h) while in gear (no transmis-
sion shifting occurring).
TOWING A DISABLED VEHICLE
This section describes procedures for towing a disabled
vehicle using a commercial towing service.
Towing Condition Wheels OFF The Ground FWD MODELS
FOUR WHEEL DRIVE
Flat Tow NONE NOT ALLOWED NOT ALLOWED
Wheel Lift Or Dolly Tow Rear
NOT ALLOWED NOT ALLOWED
Front OK NOT ALLOWED
Flatbed ALLBEST METHOD OK
368 IN CASE OF EMERGENCY
Page 395 of 516

CAUTION!(Continued)
the event of engine malfunction, particularly involv-
ing engine misfire or other apparent loss of perfor-
mance, have your vehicle serviced promptly. Contin-
ued operation of your vehicle with a severe
malfunction could cause the converter to overheat,
resulting in possible damage to the converter and
vehicle.
Under normal operating conditions, the catalytic converter
will not require maintenance. However, it is important to
keep the engine properly tuned to assure proper catalyst
operation and prevent possible catalyst damage.
NOTE: Intentional tampering with emissions control sys-
tems can result in civil penalties being assessed against
you.
In unusual situations involving grossly malfunctioning
engine operation, a scorching odor may suggest severe and
abnormal catalyst overheating. If this occurs, stop the
vehicle, turn off the engine and allow it to cool. Service,
including a tune-up to manufacturer’s specifications,
should be obtained immediately. To minimize the possibility of catalytic converter damage:
•
Do not interrupt the ignition when the transmission is in
gear and the vehicle is in motion.
• Do not try to start the vehicle by pushing or towing the
vehicle.
• Do not idle the engine with any ignition components
disconnected or removed, such as when diagnostic
testing, or for prolonged periods during very rough idle
or malfunctioning operating conditions.
Cooling System
WARNING!
• Turn vehicle off and disconnect the fan motor lead
before working near the radiator cooling fan.
• You or others can be badly burned by hot engine
coolant (antifreeze) or steam from your radiator. If
you see or hear steam coming from under the hood,
do not open the hood until the radiator has had time
to cool. Never open a cooling system pressure cap
when the radiator or coolant bottle is hot.
(Continued)
8
SERVICING AND MAINTENANCE 393
Page 398 of 516

•Use only high purity water such as distilled or deionized
water when mixing the water/engine coolant (anti-
freeze) solution. The use of lower quality water will
reduce the amount of corrosion protection in the engine
cooling system.
NOTE:
• It is the owner’s responsibility to maintain the proper
level of protection against freezing according to the
temperatures occurring in the area where the vehicle is
operated.
• Some vehicles require special tools to add coolant prop-
erly. Failure to fill these systems properly could lead to
severe internal engine damage. If any coolant is needed
to be added to the system, please contact your local
authorized dealer.
• Mixing engine coolant (antifreeze) types is not recom-
mended and can result in cooling system damage. If
HOAT and OAT coolant are mixed in an emergency,
have a authorized dealer drain, flush, and refill with
OAT coolant (conforming to MS.90032) as soon as pos-
sible.Cooling System Pressure Cap
The cap must be fully tightened to prevent loss of engine
coolant (antifreeze), and to ensure that engine coolant
(antifreeze) will return to the radiator from the coolant
recovery tank.
The cap should be inspected and cleaned if there is any
accumulation of foreign material on the sealing surfaces.
WARNING!
• Do not open hot engine cooling system. Never add
engine coolant (antifreeze) when the engine is over-
heated. Do not loosen or remove the cap to cool an
overheated engine. Heat causes pressure to build up
in the cooling system. To prevent scalding or injury,
do not remove the pressure cap while the system is
hot or under pressure.
• Do not use a pressure cap other than the one speci-
fied for your vehicle. Personal injury or engine
damage may result.
396 SERVICING AND MAINTENANCE
Page 439 of 516

have these additives will help improve fuel economy,
reduce emissions, and maintain vehicle performance.Designated TOP TIER Detergent Gaso-
line contains a higher level of detergents
to further aide in minimizing engine
and fuel system deposits. When avail-
able, the usage of Top Tier Detergent
gasoline is recommended. Visit
www.toptiergas.com for a list of TOP
TIER Detergent Gasoline Retailers.
Indiscriminate use of fuel system cleaning agents should be
avoided. Many of these materials intended for gum and varnish
removal may contain active solvents or similar ingredients.
These can harm fuel system gasket and diaphragm materials.
Fuel System Cautions
CAUTION!
Follow these guidelines to maintain your vehicle’s
performance:
• The use of leaded gasoline is prohibited by Federal
law. Using leaded gasoline can impair engine perfor-
mance and damage the emissions control system.
(Continued)
CAUTION! (Continued)
•An out-of-tune engine or certain fuel or ignition
malfunctions can cause the catalytic converter to
overheat. If you notice a pungent burning odor or
some light smoke, your engine may be out of tune or
malfunctioning and may require immediate service.
Contact your authorized dealer for service assistance.
• The use of fuel additives, which are now being sold
as octane enhancers, is not recommended. Most of
these products contain high concentrations of metha-
nol. Fuel system damage or vehicle performance
problems resulting from the use of such fuels or
additives is not the responsibility of the manufac-
turer and may void or not be covered under the New
Vehicle Limited Warranty.
NOTE: Intentional tampering with the emissions control
system can result in civil penalties being assessed against
you.
9
TECHNICAL SPECIFICATIONS 437
Page 505 of 516

Electrical Outlet, Auxiliary (Power Outlet).........111
Electric Park Brake ........................ .255
Electric Parking Brake ...................... .255
Electronic Brake Control System ................169
Anti-Lock Brake System ....................168
Electronic Roll Mitigation (ERM) ................177
Electronic Speed Control (Cruise Control) .........272
Electronic Stability Control (ESC) ...............171
Electronic Throttle Control Warning Light .........143
Electronic Vehicle Information Center (EVIC) .......285
Emergency, In Case Of Hazard Warning Flasher ...................313
Jacking ........................... .350, 402
Jump Starting .......................... .361
Overheating ........................... .364
Tow Hooks ............................ .370
Towing ............................... .368
Emission Control System Maintenance ............165
Engine ................................. .382
Air Cleaner ............................ .388
Break-In Recommendations .................254
Checking Oil Level ....................383, 386
Compartment .......................... .382
Coolant (Antifreeze) ..................... .439
Cooling ........................... .384, 393Exhaust Gas Caution
...................244, 438
Fails To Start ........................... .252
Flooded, Starting ........................ .252
Fuel Requirements ....................... .434
Jump Starting .......................... .361
Oil ........................... .386, 438, 439
Oil Filler Cap .....................382, 387, 388
Oil Filter .............................. .388
Oil Selection ........................ .387, 438
Overheating ........................... .364
Starting .............................. .251
Engine
Oil Viscosity ........................ .388
Engine Oil Viscosity Chart ....................388
Enhanced Accident Response Feature ............372
Ethanol ................................. .435
Exhaust Gas Caution .....................244, 438
Exhaust System ....................... .244, 392
Exterior Lighting ............................52
Exterior Lights ......................... .52, 247
Filters Air Cleaner ............................ .388
Air Conditioning ..................... .81, 390
Engine Oil ......................... .388, 439
Engine Oil Disposal ...................... .388
12
INDEX 503
Page 509 of 516

Power Door.............................31
Low Tire Pressure System .....................195
Lubrication, Body ......................... .390
Luggage Carrier ...........................118
Lug Nuts ............................... .433
Maintenance Free Battery .....................385
Maintenance Schedule ...................... .375
Malfunction Indicator Light (Check Engine) . . . .151, 165
Manual, Service ........................... .497
Manual Transmission ....................260, 400
Fluid Level Check ....................... .400
Frequency Of Fluid Change .................400
Lubricant Selection ...................... .400
Shift Speeds ........................... .261
Master Cylinder (Brakes) .....................398
Methanol ............................... .435
Mirrors Heated .................................51
Outside ................................50
Rearview ........................... .49, 313
Vanity .................................60
Modifications/Alterations, Vehicle ................7
Monitor, Tire Pressure System ..................195
Mopar Parts ............................. .497MTBE/ETBE
............................. .435
New Vehicle Break-In Period ..................254
Occupant Restraints ........................ .203
Octane Rating, Gasoline (Fuel) ..............434, 439
Oil, Engine ........................... .386, 439
Capacity .............................. .438
Change Interval ........................ .387
Checking .......................... .383, 386
Disposal .............................. .388
Filter ............................. .388, 439
Filter Disposal .......................... .388
Materials Added To ...................... .388
Pressure Warning Light .................138, 139
Recommendation .....................387,
438
Viscosity ....................... .387, 388, 438
Oil Filter, Change ......................... .388
Oil Filter, Selection ......................... .388
Oil Pressure Light ...................... .138, 139
Onboard Diagnostic System ...................164
Operating Precautions ...................... .164
Operator Manual (Owner’s Manual) ...............5
Outside Rearview Mirrors .....................50
Overheating, Engine ....................... .364
12
INDEX 507