instrument panel JEEP RENEGADE 2017 1.G User Guide

IconDescription
Blower Control Knob
Blower control is used to regulate the amount of air forced through the climate system. Adjust-
ing the blower will cause the automatic mode to change to manual operation. The speeds can be
selected by rotating the Blower Control adjustment knob.
Windshield Mode
Windshield Mode
Air comes from the outlets directed at the windshield meant for defrosting, and side window
demisting. This setting works best in cold or snowy conditions that require extra heat to the
windshield.
Panel Mode
Panel Mode
Air comes from the outlets in the instrument panel. Each of these outlets can be individually
adjusted to direct the flow of air. The air vanes of the center outlets and outboard outlets can be
moved up and down or side to side to regulate airflow direction. There is a shut off wheel lo-
cated below the air vanes to shut off or adjust the amount of airflow from these outlets.
Floor Mode
Floor Mode
Air comes from the floor outlets. A slight amount of air is directed through the defrost and side
window demister outlets.
3
GETTING TO KNOW YOUR VEHICLE 75

IconDescription
Bi-Level Mode
Bi-Level Mode
Bi-Level Mode is obtained by pressing both the Panel Mode button and the Floor Mode button,
activating them both. Air comes from the instrument panel outlets and floor outlets. A slight
amount of air is directed through the defrost and side window demister outlets.
NOTE: Bi-Level Mode is designed under comfort conditions to provide cooler air out of the
panel outlets and warmer air from the floor outlets.
Mix Mode
Mix Mode
Mix Mode is obtained by pressing both the Windshield Mode button and the Floor Mode but-
ton, activating them both. Air is directed through the floor, defrost, and side window demister
outlets. This setting works best in cold or snowy conditions that require extra heat to the wind-
shield. This setting is good for maintaining comfort while reducing moisture on the windshield.
Climate Control Power Button
Press and release this button to turn the Climate Control on/off.
Driver Temperature Knob
Provides the driver with independent temperature control. Rotate the adjustment knob to set
desired temperature shown in the Temperature Display. Rotate fully counterclockwise for maxi-
mum A/C (LO). The set temperature is shown on the display. Turning the control knob com-
pletely in one direction or the other activates the HI (maximum heating) or LO (maximum cool-
ing) functions shown in the display, respectively. To deactivate these functions, turn the
temperature knob to the desired temperature.
76 GETTING TO KNOW YOUR VEHICLE

•Turns air recirculation off.
• Sets blower fan to the maximum speed.
• Directs air flow to windshield and front side window
diffusers.
• Activates the heated rear window defrost.
• Activates the heated windshield (if equipped).
• Displays the fan speed (Blower Control Indicator LED
illuminated).
When the function is activated, the AUTO button LED
turns off. With the function activated, the only possible
manual adjustments are pushing the A/C control button,
adjusting the fan speed and turning the heated rear win-
dow off.
When the Recirculation Control or AUTO buttons are
pushed, the Climate Control system will deactivate the
Front Defrost (MAX-DEF) function.
Selecting the footwell/windshield or only windshield dis-
tribution activates the Climate Control system compressor
and the air recirculation is set to outside air intake.
This logic guarantees optimum visibility at the windows.
Max-defrost is also available in manual mode. Rear Window Defrosting
Push and release the rear window defrost button to turn
the function on/off.
Activation of this function is indicated by the rear defrost
indicator light on the instrument panel turning on. The
function is automatically deactivated after 20 minutes. If
equipped, push the rear defrost button to activate the
defrosting of door mirrors and heated rear window.
CAUTION!
To avoid causing damage to the rear window defroster
heating filaments do not affix stickers or other objects
to the inside of the rear glass.
Turning Off The Climate Control System
Push the ON/OFF button.
With the Climate Control system off:
• Air recirculation is on, isolating the passenger compart-
ment from the outside.
• The A/C compressor is off.
• The blower is off.
• The heated rear window can be activated/deactivated.
78 GETTING TO KNOW YOUR VEHICLE

1. Pull the hood release lever located under the driver ’sside of the instrument panel.
2. Move to the outside of the vehicle and push the safety latch release lever toward the passenger side of the
vehicle. The hood release lever is located behind the
center front edge of the hood.
Hood Release Lever
Safety Latch
1 — Safety Latch Location
3
GETTING TO KNOW YOUR VEHICLE 97

INTERNAL EQUIPMENT
Glove Compartment
The glove compartment is located on the passenger ’s side
of the instrument panel.
To open the glove compartment proceed as follows:
1. Unlock the compartment using the vehicle emergencykey.
2. Pull the handle to open the compartment.
Once the glove compartment is open, a light will turn on to
illuminate the compartment.
NOTE:
•Do not insert objects in the glove compartment that will
not allow the compartment to fully close.
• The glove compartment should be completely closed
while the vehicle is in motion.
Opening The Glove Compartment
1 — Glove Compartment Handle
3
GETTING TO KNOW YOUR VEHICLE 109

3. Slide out the sun visor extender for even more sidecoverage toward the rear.
Power Outlets
The front power outlet is located under the center stack of
the instrument panel. It only operates with the ignition in
the RUN position. Models equipped with the optional
smoker kit,will have
a cigar lighter instead of the power outlet. Refer to “Cigar
Lighter in “Internal Equipment” for further information.
Rear Power Outlet
The rear cargo power outlet is located on the left side of the
cargo area.
The outlet only works when the ignition is in the RUN
position.
Using The Extender
12 Volt Power Outlet
3
GETTING TO KNOW YOUR VEHICLE 111

Handle Grip
The handle grip is located on the passenger side of the
instrument panel. The handle can be used to enter or exit
the vehicle or when traveling on rough terrain.
ROOF LUGGAGE RACK — IF EQUIPPED
Your vehicle may be equipped with a Roof Luggage Rack
for transporting accessories.
Crossbars should always be used whenever cargo is placed
on the Roof Luggage Rack. Check the straps frequently to
be sure that the load remains securely attached.
NOTE:Crossbars can be purchased at a authorized dealer
through Mopar parts. External racks do not increase the
total load carrying capacity of the vehicle. Be sure that the
total occupant and luggage load inside the vehicle, plus the
load on the Roof Luggage Rack, do not exceed the maxi-
mum vehicle load capacity.
The load carried on the roof, when equipped with a
luggage rack, must not exceed 150 lbs (68 kg), and it should
be uniformly distributed over the cargo area.
Do not use the retractable roof when using the crossbars.
Handle Grip
118 GETTING TO KNOW YOUR VEHICLE

GETTING TO KNOW YOUR INSTRUMENT PANEL
CONTENTS
INSTRUMENT CLUSTER ..................122
▫ Instrument Cluster Descriptions .............123
 INSTRUMENT CLUSTER DISPLAY ...........124
▫ Instrument Cluster Display Location And
Controls ............................ .125
▫ Oil Change Reset ..................... .127
▫ Instrument Cluster Display Menu Items ......127
 TRIP COMPUTER ....................... .133
 WARNING/INDICATOR LIGHTS AND
MESSAGES ........................... .134
▫ Red Telltale Lights .....................134 ▫
Yellow Telltale Lights ....................144
▫ Green Telltale Lights .....................159
▫ Blue Telltale Lights ..................... .161
▫ White Telltale Lights .....................162
▫ Gray Telltale Lights .....................163
 ONBOARD DIAGNOSTIC SYSTEM (OBD II) . . . .164
▫ Onboard Diagnostic System (OBD II)
Cybersecurity ........................ .164
 EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS .......................... .1654

INSTRUMENT CLUSTER
Base Instrument Cluster
122 GETTING TO KNOW YOUR INSTRUMENT PANEL

Instrument Cluster Descriptions
1. Tachometer•Indicates the engine speed in revolutions per minute
(RPM x 1000). 2. Temperature Gauge
•The temperature gauge shows engine coolant tem-
perature. Any reading within the normal range indi-
cates that the engine cooling system is operating
satisfactorily.
Premium Instrument Cluster
4
GETTING TO KNOW YOUR INSTRUMENT PANEL 123