instrument panel JEEP WRANGLER 2011 User Guide

4
UNDERSTANDING YOUR INSTRUMENT PANEL 333

4
UNDERSTANDING YOUR INSTRUMENT PANEL 353

4
UNDERSTANDING YOUR INSTRUMENT PANEL 357

4
UNDERSTANDING YOUR INSTRUMENT PANEL 359

4
UNDERSTANDING YOUR INSTRUMENT PANEL 363

WARNING!
On vehicles equipped with a limited-slip differen-
tial, never run the engine with one rear wheel off the
ground. The vehicle may drive through the rear
wheel remaining on the ground and cause you to lose
control of your vehicle.
AXLE LOCK (TRU–LOK) — RUBICON MODELS
The AXLE LOCK switch is located on the instrument
panel (to the left of the steering column).
This feature will only activate when the following con-
ditions are met:
•Key in ignition, vehicle in 4L (Low) range.
•Vehicle speed should be 10 mph (16 km/h) or less.

This system is controlled by the SWAY BAR switch
located on the instrument panel (to the left of the steering
column).
Press the SWAY BAR switch to activate the system. Press
the switch again to deactivate the system. The “Sway Bar
Indicator Light” (located in the instrument cluster) will
illuminate when the bar is disconnected. The “Sway BarIndicator Light” will flash during activation transition, or
when activation conditions are not met. The stabilizer/
sway bar should remain in on-road mode during normal
driving conditions.