Wiring harness JEEP WRANGLER 2012 JK / 3.G Owners Manual

3. Unplug the wiring harness connector under the instru-
ment panel by pressing the tab at the top of the connector
and pulling to disconnect.
NOTE:If the red latch on the connector is locked, push
the red latch down until you can only see the latch on one end (top) of the connector. This will unlock the connector
tab, allowing the tab to be pressed down and enabling the
harness to be disconnected.
Hinge Pin Screw
Door Strap/Harness Location
1 — Harness Connector
2 — Body Hook
3 — Door/Harness Strap
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 31

3. Slide the front seat(s) fully forward.
4. Remove the trim access door from the bottom of the
B-pillar.
5. Unplug the wiring harness connector.NOTE:
If the red latch on the connector is locked, push
the red latch to the right until you can only see the latch
on one end (right) of the connector. This will unlock the
connector tab, allowing the tab to be pressed down and
enabling the harness to be disconnected.
6. Unhook the door strap from the body hook.
Trim Access Door
Red Connector Latch
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 33

8. To remove the wiring harness press the tab and pull
downward to disconnect.9. To remove the washer hose, pinch the grips on hose
connector and pull downward.
10. Close the swing gate.
Press Tab To DisconnectPinch Grip On Hose
186 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Towing Requirements – Trailer Lights And Wiring
Whenever you pull a trailer, regardless of the trailer size,
stop lights and turn signals on the trailer are required for
motoring safety.
The Trailer Tow Package will include a four–pin wiring
harness. Use a factory-approved trailer harness and
connector.
NOTE:Do not cut or splice wiring into the vehicles
wiring harness.
The electrical connections are all complete to the vehicle
but you must mate the harness to a trailer connector.
Refer to the following illustration.
Four-Pin Connector
1 — Female Pins 4 — Park
2 — Male Pin 5 — Left Stop/Turn
3 — Ground 6 — Right Stop/Turn
482 STARTING AND OPERATING