light KIA CADENZA 2011 Owners Manual
[x] Cancel search | Manufacturer: KIA, Model Year: 2011, Model line: CADENZA, Model: KIA CADENZA 2011Pages: 352, PDF Size: 28.17 MB
Page 322 of 352

757
Maintenance
✽✽NOTICE
HID lamps have superior performance
vs. halogen bulbs. HID lamps are esti-
mated by the manufacturer to last twice
as long or longer than halogen bulbs
depending on their frequency of use.
They will probably require replacement
at some point in the life of the vehicle.
Cycling the headlamps on and off more
than typical use will shorten HID lamps
life. HID lamps do not fail in the same
manner as halogen incandescent lamps.
If a headlamp goes out after a period of
operation but will immediately relight
when the headlamp switch is cycled it is
likely the HID lamp needs to be
replaced. HID lighting components are
more complex than conventional halo-
gen bulbs thus have higher replacement
cost.
Headlight (bulb type)
1. Open the hood.
2. Remove the headlight bulb cover by turning it counterclockwise.
3. Disconnect the headlight bulb socket- connector.
4. Remove the bulb from the headlight assembly.
5. Install a new headlight bulb.
6. Connect the headlight bulb socket- connector.
7. Install the headlight bulb cover by turn- ing it clockwise.
✽✽ NOTICE
If the headlight aiming adjustment is
necessary after the headlight assembly is
reinstalled, consult an authorized KIA
dealer.
OEN076051
Page 323 of 352

Maintenance
58
7
Turn signal light
1. Remove the socket from the assembly
by turning the socket counterclockwise
until the tabs on the socket align with
the slots on the assembly.
2. Remove the bulb from the socket by pressing it in and rotating it counter-
clockwise until the tabs on the bulb
align with the slots in the socket. Pull
the bulb out of the socket
3. Insert a new bulb by inserting it into the socket and rotating it until it locks
into place.
4. Install the socket in the assembly by aligning the tabs on the socket with the
slots in the assembly. Push the socket
into the assembly and turn the socket
clockwise.
Position and front fog light
If the light bulb does not operate, have
the vehicle checked by an authorized KIA
dealer. Side repeater light bulb replace- ment
Type A
If the light bulb does not operate, have
the vehicle checked by an authorized KIA
dealer.
Type B
1. Remove the light assembly from the
vehicle by prying the lens and pulling
the assembly out.
2. Disconnect the bulb electrical connec- tor.
3. Separate the socket and the lens parts by turning the socket counterclockwise
until the tabs on the socket align with
the slots on the lens part.
4. Remove the bulb by pulling it straight out.
5. Insert a new bulb in the socket.
6. Reassemble the socket and the lens part.
7. Connect the bulb electrical connector.
8. Reinstall the light assembly to the body of the vehicle.
OVG079028OYF079044
Page 324 of 352

759
Maintenance
Rear combination light bulb replacement (1) Stop and tail light
(2) Rear turn signal light
(3) Back-up light
(4) Rear fog light (if equipped)Rear turn signal light
1. Open the trunk lid.
2. Open the service cover.3. Remove the socket from the assembly
by turning the socket counterclockwise
until the tabs on the socket align with
the slots on the assembly.
4. Remove the bulb from the socket by pressing it in and rotating it counter-
clockwise until the tabs on the bulb
align with the slots in the socket. Pull
the bulb out of the socket.
5. Insert a new bulb by inserting it into the socket and rotating it until it locks
into place.
6. Install the socket in the assembly by aligning the tabs on the socket with the
slots in the assembly. Push the socket
into the assembly and turn the socket
clockwise.
7. Install the service cover by putting it into the service hole.
OVG079029OVG079030OVG079031
Page 325 of 352

Maintenance
60
7
Backup light
1. Open the trunk.
2. Loosen the retaining screw of the trunk
lid cover and then remove the cover.
3. Remove the socket from the assembly by turning the socket counter clock-
wise until the tabs on the socket align
with the slots on the assembly. 4. Remove the bulb by pulling it straight
out.
5. Insert a new bulb by inserting it into the socket and rotating it until it locks
into place.
6. Install the socket into the assembly by aligning the tabs on the socket with the
slots in the assembly. Push the socket
into the assembly and turn the socket
clockwise.
7. Reinstall the trunk lid cover by pushing in the screw.
Rear fog light, Stop and tail light
If the light does not operate, have the
vehicle checked by an authorized KIA
dealer.
OVG079032OVG079033
Page 326 of 352

761
Maintenance
High mounted stop light replacement
If the light does not operate, have the
vehicle checked by an authorized KIA
dealer.License plate light bulb replace- ment
1. Open the trunk.
2. Loosen the retaining screws of the trunklid cover and then remove the cover.
3. Remove the bulb by pulling it straight out.
4. Install a new bulb.
5. Reinstall the trunk lid cover by pushing in the screw.
Interior light bulb replacement
1. Using a flat-blade screwdriver, gently pry the lens from the interior light housing.
2. Remove the bulb by pulling it straight out.
OVG079036
Map lamp (Type A)
OVG079037
Room lamp (Type A)OVG079032
OVG079035
OVG079034
Page 327 of 352

Maintenance
62
7
3. Install a new bulb in the socket.
4. Align the lens tabs with the interior
light housing notches and snap the
lens into place.
5. If the map lamp and room lamp (Type B) does not operate, have the vehicle
checked by an authorized KIA dealer.
CAUTION
Use care not to dirty or damage
lens, lens tab, and plastic housings.
Vanity mirror lamp
OVG079040Trunk lamp
WARNING
Prior to working on the Interior
Lights, ensure that the “OFF” but-
ton is depressed to avoid burning
your fingers or receiving an electric
shock.
OVG079038
OVG079039
Glove box lamp
Page 328 of 352

763
Maintenance
Exterior care
Exterior general caution
It is very important to follow the label
directions when using any chemical
cleaner or polish. Read all warning andcaution statements that appear on thelabel.
Finish maintenance
Washing
To help protect your vehicle’s finish from
rust and deterioration, wash it thoroughlyand frequently at least once a month with
lukewarm or cold water.
If you use your vehicle for off-road driv-
ing, you should wash it after each off-
road trip. Pay special attention to the
removal of any accumulation of salt, dirt,
mud, and other foreign materials. Make
sure the drain holes in the lower edges of
the doors and rocker panels are keptclear and clean.
Insects, tar, tree sap, bird droppings,
industrial pollution and similar deposits
can damage your vehicle’s finish if not
removed immediately.
Even prompt washing with plain water
may not completely remove all these
deposits. A mild soap, safe for use on
painted surfaces, may be used.
After washing, rinse the vehicle thor-
oughly with lukewarm or cold water. Do
not allow soap to dry on the finish.
APPEARANCE CARECAUTION
Do not use strong soap, chemical
detergents or hot water, and do
not wash the vehicle in direct sunlight or when the body of thevehicle is warm.
Be careful when washing the side windows of your vehicle.Especially, with high-pressurewater, water may leak through the windows and wet the interior.
To prevent damage to the plastic parts, do not clean with chemicalsolvents or strong detergents.
WARNING - Wet brakes
After washing the vehicle, test the
brakes while driving slowly to see if
they have been affected by water. If
braking performance is impaired,
dry the brakes by applying them
lightly while maintaining a slow for-
ward speed.
Page 330 of 352

765
Maintenance
Bright-metal maintenance
To remove road tar and insects, use atar remover, not a scraper or other
sharp object.
To protect the surfaces of bright-metal parts from corrosion, apply a coating of
wax or chrome preservative and rub to
a high luster.
During winter weather or in coastal areas, cover the bright metal parts with
a heavier coating of wax or preserva-
tive. If necessary, coat the parts with
non-corrosive petroleum jelly or other
protective compound.
Underbody maintenance
Corrosive materials used for ice and
snow removal and dust control may col-
lect on the underbody. If these materials
are not removed, accelerated rusting can
occur on underbody parts such as the
fuel lines, frame, floor pan and exhaust
system, even though they have been
treated with rust protection.
Thoroughly flush the vehicle underbody
and wheel openings with lukewarm or
cold water once a month, after off-road
driving and at the end of each winter. Payspecial attention to these areas because
it is difficult to see all the mud and dirt. It
will do more harm than good to wet down
the road grime without removing it. The
lower edges of doors, rocker panels, and
frame members have drain holes that
should not be allowed to clog with dirt;
trapped water in these areas can cause
rusting.WARNING
After washing the vehicle, test the
brakes while driving slowly to see if
they have been affected by water. If
braking performance is impaired,
dry the brakes by applying them
lightly while maintaining a slow for-
ward speed.
Page 338 of 352

Specifications & Consumer information
2
8
DIMENSIONS BULB WATTAGE
* : If equipped
*
1
: with R16 tire
* 2
: with R17 tire Item mm (in)
Overall length 4965 (195.5) Overall width 1850 (72.8)
Overall height 1475 (58.1) Front tread 1613 (63.5)* 1
/ 1602 (63.1)* 2
Rear tread 1611 (63.4)* 1
/ 1601 (63.0)* 2
Wheelbase 2845 (112.0)
Light Bulb Wattage
Headlights (High) 55
Headlights (Low) 55 or 35 (HID)
Front turn signal lights 21
Position lights LED
Side repeater lights* 5
Side repeater lights (Outside mirror)* LED
Front fog lights 27
Stop and tail lights* LED
Rear turn signal lights 21
Back-up lights 18
Rear fog lights* 21
High mounted stop light LED
License plate lights 5
Map lamps/Room lamps (Type A)* 10
Map lamps/Room lamps/Mood lamp (Type B)* LED
Trunk lamp 5
Glove box lamp 5
Vanity mirror lamps 5
Page 345 of 352

Index
2
I
Air bags··········································································3-31
Air bag warning label················································3-50
Air bag warning light ················································3-34
Curtain air bag···························································3-40
Driver's and passenger's front air bag ·······················3-37
Side impact air bag····················································3-39
Air cleaner ·····································································7-24
Alarm system ·································································4-12
Antenna (Glass) ···························································4-120
Anti-lock brake system (ABS) ······································5-20
Appearance care·····························································7-63 Exterior care ······························································7-63
Interior care ·······························································7-68
Armrest ··········································································3-12
Ashtray ·········································································4-113
Audio system ·······························································4-120 Glass antenna ··························································4-120
Steering wheel audio control ··································4-121
Auto defogging system ················································4-110
Automatic climate control system ·································4-10 Air conditioning ······················································4-106
Automatic heating and air conditioning··················4-101
Manual heating and air conditioning ······················4-102
Automatic transaxle ·······················································5-13 Ignition key interlock system ····································5-16
Shift lock system ·······················································5-15
Sports mode·······························································5-14 Aux, USB and iPod ·····················································4-121
Base curb weight ···························································5-42
Battery············································································7-30
Battery replacement (Remote keyless entry) ···················4-8
Battery saver function ····················································4-76
Before driving ··································································5-3
Bottle holders, see cup holders ····································4-114
Brake system··································································5-18
Anti-lock brake system (ABS) ··································5-20
Electronic stability program (ESP) ···························5-23
Parking brake·····························································5-19
Power brakes ·····························································5-18
Brake fluid ·····································································7-21
Bulb replacement ···························································7-55
Bulb wattage ····································································8-2
Button start/stop, see engine start/stop button ·················5-7
Capacities (Lubricants) ····················································8-4 Care Exterior care ······························································7-63
Interior care ·······························································7-68
Tire care·····································································7-33
Cargo weight ··································································5-42
A
B
C