lights KIA CARNIVAL 2022 Features and Functions Guide

*IF EQUIPPED54CARNIVAL FEATURES & FUNCTIONS GUIDE
OTHER KEY FEATURES
OTHER KEY FEATURES
HOLD
HOLDHOLD
HOLD
HOLDHOLD
HOLD
HOLDHOLD
HOLD
HOLD
HOLDHOLD
HOLD
HOLDHOLD
HOLD
(But tons located on panel to the left of steering wheel)
HOLD
HOLDPOWER
DOOR OFFHOLD
HOLDHOLDPOWER
DOOR OFFHOLD
#VU UPOT
MPDBUFE
PO
DFOUFS
QJMMBST

Power Sliding Doors
Using the driver ’s panel controls, press the left/right Power Sliding Door buttons A, on the driver ’s panel controls, on the center pillars B or on the key fob C to automatically open/close the sliding doors.
REMINDER: If the POWER DOOR OFF but ton F is depressed, the Smar t Power Liftgate* will not operate.
Smart Key Auto Open/Close*: To automatically open and close the Power Liftgate / Sliding Doors, press and hold buttons D (close) and E (open) for more than 3 seconds.
Power Door OFF Button: When button F is ON (not depressed), the power sliding doors and power liftgate can be controlled with the buttons on the center pillar trim B or liftgate. Also, the doors will open/close automatically when pulling the handles from the inside or outside.
Smart Sliding Door with Auto Open
The sliding doors can be opened hands-free if the Smart Key is detected within the system range. The hazard warning lights will flash and a chime will sound two times and the door nearest the Smart Key will open. To activate the Smart Sliding Door with Auto Open, on some models, go the User Settings in
the Instrument Cluster and select Smart Liftgate. On other models, press the SETUP key on the audio head unit. Then press VEHICLE, DOOR and SMART SLIDING DOOR.
Passenger View* / Passenger Talk*
Passenger View, an in-cabin camera, helps the front passenger talk with rear passengers while viewing them on the audio head unit screen. On the head unit screen, press the Passenger View icon G.
Passenger Talk: Press the button H located on the overhead console to use the Passenger Talk, cabin intercom, function.
REMINDER: The system will not operate when the Smar t Key is detected continuously near the vehicle after the doors are locked, or when a door is not locked or closed.
Refer to section 4 in the Owner ’s Manual for more information.
Passenger
View
PassengerView
AAFBB
C
D
E
H
G
Refer to the inside front cover for more information on QR codes.www.youtube.com/KiaFeatureVideos
Carnival Power/Smart Liftgate & Sliding Doors Video
QR CODE

REMINDERS:
•The Sunvisor may not shield all direct light
•The Sunvisor may impair visibilit y if not adjusted properly
•
Be aware of the seating position when adjusting or swinging Sunvisor around to or from the front or side windows
•Do not operate the vehicle if the Sunvisor is impairing your visibilit y
•When the doors are unlocked by the Smar t Key*, the lamp turns ON for approximately 30 seconds
•If your vehicle is equipped with the theft alarm system, the interior lights automatically turn off approximately 3 seconds after the system is in the armed stage
•Using interior lights for an extended period of time may cause bat ter y discharge
QUICK TIPS
REMINDER: When the Room Lamp lens is pressed ON it will remain ON, even when the Map Lamp switch is in the OFF position.
†LEGAL DISCL AIMERS ON BACK INSIDE COVER | *IF EQUIPPEDALWAYS CHECK THE OWNER ’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS. 55
Refer to section 4 in the Owner ’s Manual for more information.
Refer to section 4 in the Owner ’s Manual for more information.
FRONTREARFRONTREAR
REARREAR
FRONTREARFRONTREAR
REARREAR
(Lamp controls located in the overhead consoles). Type A shown.
Rear
Front
Map/Room Lamps
Automatic turn off function*
The interior lights automatically turn off approximately 30 seconds after the Engine Start/Stop button is OFF.
Map/Room Lamp Operation
Press the buttons A to turn the Map Lamps ON/OFF. This light produces a spot beam for convenient use as a map lamp or as a personal lamp for the driver or the front passenger.
When the button C is pressed, the following occurs:
•When any door or the liftgate is opened, the Map and Room Lamps turn ON
•When doors are unlocked from the Smart Key or key removed from ignition, the Map and Room Lamps turn ON for approximately 30 seconds or until a door is opened
•When doors are closed, the lamps will gradually turn OFF after approximately 30 seconds
•When all doors are locked or the ignition is turned ON, the Map Lamp will turn OFF immediately
When the button B is pressed, the lamps stay ON continuously.
Room Lamp – Press the lens D to turn the Room Lamp ON/OFF.
Sunvisor†2 4
Use the Sunvisor to shield direct light through the front or side windows. Slide the Sunvisor out and adjust as needed.
OTHER KEY FEATURES
OTHER KEY FEATURES
C
AADD
B

CA
D
E
F
G
•You can reprogram a single HomeLink® but ton by repeating Step 2
•Erasing the programmed but tons will delete all trained transmit ters
QUICK TIPS
Refer to the inside front cover for more information on QR codes.www.youtube.com/KiaFeatureVideos
Homelink® Support Video
QR CODE
B
†LEGAL DISCL AIMERS ON BACK INSIDE COVER | *IF EQUIPPEDALWAYS CHECK THE OWNER ’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS. 59
OTHER KEY FEATURES
How to Sync Transmitter with HomeLink®*
If programming for the first time, begin with Step 1 (repeating this step will delete all information).
To program non-rolling and rolling code garage door openers and other devices:
1. Press and hold the left A and center C buttons simultaneously until the indicator light G begins to flash (to reprogram buttons, skip this step)
2. Press and hold the desired button A B C and hold the button on the transmitter while it is approximately 1 to 3 inches away from the mirror. The HomeLink®
Indicator light E will flash rapidly once the frequency signal has been successfully programmed
To finish programming rolling code garage door openers, complete these steps:
3. Locate the “learn” or “smart ” button on the garage door ’s motor head unit. Press and release the button and complete Step 4 within 30 seconds
4. Firmly press and release the programmed HomeLink® button up to three times
Operating HomeLink®:
Press one of the programmed HomeLink® buttons.
Erasing programmed buttons:
Press and hold the A and C buttons simultaneously for approximately 20 seconds, and then release both buttons within 30 seconds.
The HomeLink® / Auto-Dimming Rearview Mirror* is designed to reduce glare from a vehicle’s headlights located in the rear and also connect up to three electronic transmitters into one location.
HomeLink®†1 2 with Auto-Dimming Rearview Mirror*
A HomeLink® Channel 1
B HomeLink® Channel 2
C HomeLink® Channel 3
D Garage Door Opener Status Indicator: Closing or Closed
E HomeLink® Operation Indicator
F Garage Door Opener Status Indicator: Opening or Open
G HomeLink® User Interface Indicator
If your garage door opener was manufactured in 2011 or later, and you’re unable to program your vehicle’s HomeLink® system, you may need to purchase a HomeLink Repeater Kit. For more information, go to w w w.HomeLink.com or call (800) 355-3515.
OTHER KEY FEATURES