warning KIA K900 2017 Features and Functions Guide

31
(Button located on center panel below the gear shift)
www.KuTechVideos.com/kh13/2017
SURROUND VIEW
MONITOR ING (SVM)
SYSTEM VIDEO
To view a video on your
mobile device, snap this
QR Code or visit the listed
website. Refer to page 2
for more information.
REMINDER: The SVM camera is equipped with
an optical lens to provide a wider range of vision
and may appear different from the actual distance.
The Surround View Monitoring system is only a
supplemental device. Drivers should not rely solely
on the SVM information when parking and backing
up. Drivers should always pay attention and directly
check the left /right and rear.
Surround View Monitoring (SVM) System*
The Surround View Monitoring (SVM) System is a parking
support system that shows the areas around the front, rear, left
and right sides of the vehicle via four cameras displayed onto
the navigation screen.
Press
A to turn the SVM system ON/OFF.
§
When OFF: The camera view will automatically display
on the navigation screen when the vehicle is shifted into
Reverse. The camera view will turn off when the vehicle is
shifted out of Reverse
§
When ON: The camera view will display on the navigation
screen in both Drive and Reverse. In Drive, the camera
view will continue to display until the vehicle is traveling
at speeds above approximately 13 mph. If you keep the
SVM system on, the camera view will reappear on the
navigation screen whenever the vehicle speed drops below
approximately 13 mph
When in Drive & Neutral: When in Reverse:
A
Displays the front side and SVM images
simultaneously on the screen
Displays the front side image on the screen
Displays the front side and left side images
simultaneously on the screen
Displays the front side and right side images
simultaneously on the screen
Displays the rear view and AVM images
simultaneously on the screen
Displays the rear side image on the screen
Displays the rear and left side images
simultaneously on the screen
Displays the rear and right side images
simultaneously on the screen
Camera View Modes – To change camera view modes, use the touch screen or rotate the controller and
push to select the mode.
CENTER PANEL
*IF EQUIPPED
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLE TE OPER ATING INFORMATION AND SAFE T Y WARNINGS.

33
(Button located on center panel below the gear shift)
The rear and side window curtains offer passenger protection
from direct sunlight.
While the ENGINE START/STOP button is in the ACC/ON position,
press the power rear curtain button
A to raise/lower curtain.
REMINDER: Raising or lowering the rear curtain by hand may cause motor failure .
Power Rear Curtain
POWER REAR
CURTAIN & REAR
SIDE-WINDOW
CURTAINS VIDEO
To view a video on
your mobile device,
snap this QR Code or
visit the listed website.
Refer to page 2 for
more information.
Quick Tips
- The power rear curtain will lower automatically
when the gear shift is moved into the R (Reverse)
position and raise automatically when the gear
shift is moved from R (Reverse) into P (Park)
- When the gear shift is moved into D (Drive)
and the vehicle is traveling at speeds greater
t han 12 mph, the power rear curtain will unfold
automatically
A
(Button located on rear passenger’s control system)
A
www.KuTechVideos.com/kh13/2017
CENTER PANEL
*IF EQUIPPED
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLE TE OPER ATING INFORMATION AND SAFE T Y WARNINGS.

35
Move/press controls to adjust headrest, seat forward/backward position, seat cushion length, seatback
angle or lumbar support.
Headrest Height Adjustment*: Move button
A up/down to adjust headrest height
Seatback Angle Adjustment: Move button
B forward/backward to adjust seatback angle
Seat Sliding, Seat Height and Cushion Length* Adjustments:
§
Move button C forward/backward to slide seat
§
Move front part of button D up/down to raise/lower front part of seat
§
Move back part of button E up/down to raise/lower back part of seat
§
Move button F forward/backward to increase/decrease cushion length*
Lumbar Support Adjustment:
§
Press G to increase support
§
Press H to decrease support
§
Press I to move lumbar support up/down
Power Adjustable Driver’s Seat
A
B
ED
F
C
GH
I
I
(Buttons located on left side of seat cushion)
(Controls located on door panel)
Power Height Adjustment* – To adjust the height, move
the seat control button A up/down.
Manual Tilt Adjustment – To adjust the headrest forward/
backward, tilt the lower part of the headrest at a slight angle.
Power Front Seat Headrest Adjustment*
S E AT I N G
*IF EQUIPPED
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLE TE OPER ATING INFORMATION AND SAFE T Y WARNINGS.

37
Rear Passenger’s Control System
The rear passenger’s control system lets users adjust the rear
and front seat controls, rear audio control and climate control.
Rear Seat Adjustment
To activate or deactivate the system, press the RE AR LOCK
button
A on the rear armrest console.
To control the rear seat lumbar support*, press the L (left
seat)
B or R (right seat) C button.
To adjust the lumbar support, move the lever
D:
§ To the LEFT to increase
§ To the RIGHT to decrease
§
UP to move the support position higher
§ DOWN to move lower
Quick Tip
Users can also activate/deactivate the rear passenger control system through the navigation
system. Press the CLIMATE button on the center
panel and deselect the Rear Climate option. If
the rear climate controls have been deactivated
through navigation system, they must be activated
the same way.
DF
E
G
C
B
A
Front Passenger Seat Adjustment
To adjust the angle of the front passenger’s seat from the
rear seat control system or the buttons on front seatback,
press the top/bottom of button
F to angle the front
seatback forward/backward.
To adjust the position of front passenger’s seat from
the rear seat control system or the buttons on the front
seatback, press the top/bottom of button
G to move the
seat forward/backward.
REMINDER: The front passenger seat adjustments F G only operate when seat is not occupied.
Easy Access (AUTO) – When opening the rear door, the rear seats will automatically move rearward to
provide easier access for passengers.
Press the AUTO button
E on the door panel to turn the system ON (LED is lit) or OFF (LED not lit).
(Buttons located on left side of
front passenger seatback)
F
G
S E AT I N G
*IF EQUIPPED
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLE TE OPER ATING INFORMATION AND SAFE T Y WARNINGS.

39
P o w e r Tr u n k
The Power Trunk can be operated from several controls to
either open, close or lock the trunk. The Power Trunk Lock
button will close the trunk, lock all doors and trunk and then
arm the vehicle.
To turn the Power Trunk features ON, press the Power Trunk
Lid Control button to ON, located inside the glove box.
Driver’s Panel Power Trunk Main Control Lever – Located
to the left of the steering wheel, below the main button panel.
To open, pull the Power Trunk Main Control lever
A.
To close, press and hold the Power Trunk Main Control lever
A.
Power Trunk Close/Lock Buttons – Located underneath
the inside of the trunk lid.
To close trunk – Press the Trunk Close button
B.
To close trunk and lock and arm all doors/trunk, press the
Trunk Lock button
C.
Exterior Power Trunk Open Button – Located underneath
the outside of the trunk lid. To open, press the soft-touch
Power Trunk Open button.
Quick Tips
- The trunk must be unlocked before it can be
opened by the Trunk Release button
- The trunk unlocks automatically and then can be
opened manually when the Smart Key is within
close proximity to the vehicle
BC
www.KuTechVideos.com/kh13/2017
POWER TRUNK VIDEO
To view a video on your
mobile device, snap
this QR Code or visit the
listed website. Refer
to page 2 for more
information.
A
(Button located under driver’s
panel, left of the steering wheel)
REMINDERS:
- Power Trunk may be damaged if attempting to
open or close manually
- When not in use, keep the Trunk Lid Control
button in the OFF position
- If going through a car wash, remind the attendant
to keep the vehicle in Neutral (N) and keep the
engine running. Also, disable the Power Trunk
lid control using the button inside the glove
compartment, turn off the auto rain-sensing
wipers and fold in the mirrors
- Ensure all obstacles are out of the way of the
trunk lid when operating the Power Trunk
Smart Power Trunk (Continued)
OTHER KEY FEATURES
*IF EQUIPPED
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLE TE OPER ATING INFORMATION AND SAFE T Y WARNINGS.

41
Mechanical Key F:
§
Use to unlock driver’s door:
1. Remove door handle keyhole cover with mechanical key by pressing up into slot as shown
I
2. Insert mechanical key J and turn right to unlock driver’s door
3. Insert mechanical key J and turn left to lock driver’s door
§
Use to lock glove box
IJ
H
Smart Key (Continued)
Driver’s Door Lock/Unlock Button H:
To unlock door(s):
§
Press button once to unlock driver’s door
§
Press again within 4 seconds to unlock all doors
To lock all doors:
§
Press again to lock all doors
OTHER KEY FEATURES
*IF EQUIPPED
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLE TE OPER ATING INFORMATION AND SAFE T Y WARNINGS.

43
Panoramic Sunroof Operation
The sunroof and sunshade operation is controlled by a multi-
directional switch/lever A. The ignition needs to be in the
ON position to operate the sunroof/sunshade.
Slide the sunshade and sunroof:
Auto Open – Slide lever backward to the farthest position
and release.
Auto Close – Slide the lever forward to the farthest position
and release.
Slide the sunshade:
Auto Open – Slide the lever backward to the first detent position.
Auto Close – Slide the lever forward to the farthest position.
Slide the sunroof (with sunshade open):
Auto Open – Slide the lever backward and release.
Auto Close – Slide the lever forward to the first detent
position or pull the lever downward.
Tilt the sunroof:
Raise – Press lever upward.
Lower – Pull lever downward.
Auto-close sunroof and sunshade:
Slide the lever forward to the farthest position.
REMINDER: Sunshade must remain OPEN while
sunroof is open and vehicle is moving. Quick Tip
To stop the sunroof/sunshade at any position, press
or pull the sunroof control lever in any direction .
A
OTHER KEY FEATURES
*IF EQUIPPED
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLE TE OPER ATING INFORMATION AND SAFE T Y WARNINGS.

45
How to Sync Transmitter with HomeLink®
If programming for the first time, begin with step 1 (repeating
this step will delete all information).
To program non-rolling and rolling code garage door openers
and other devices:
1. Press and hold the left F and center G buttons
simultaneously until the indicator light begins to flash (to
reprogram buttons, skip this step)
2. Press and hold the desired button F, G or H and hold
the button on the transmitter while it is approximately 1 to
3 inches away from the mirror. The HomeLink
® indicator
light will flash rapidly once the frequency signal has been
successfully programmed
To finish programming rolling code garage door openers,
complete these steps:
3. Locate the “learn” or “smart” button on the garage door’s
motor head unit. Press and release the button and complete
step 4 within 30 seconds
4. Firmly press and release the programmed HomeLink®
button up to three times
Quick Tips
- You can reprogram a single HomeLink® button by
repeating step 2
- Erasing programmed buttons will delete all
trained transmitters
Operating HomeLink®:
Press one of the programmed HomeLink
® buttons.
Erasing programmed buttons:
Press and hold the left
F and center H buttons
simultaneously for approximately 20 seconds, and then
release both buttons within 30 seconds.
If your garage door opener was manufactured in 2011
or later, and you are unable to program your vehicle’s
HomeLink
® system, you may need to purchase a
HomeLink® Repeater Kit. For more information, go to
www.HomeLink.com or call (800) 355-3515.
OTHER KEY FEATURES
*IF EQUIPPED
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLE TE OPER ATING INFORMATION AND SAFE T Y WARNINGS.

47
Fuel Cap / Malfunction Indicator (Check Engine Light)
Tighten until ONE CLICK to prevent malfunction indicator
from illuminating.
www.KuTechVideos.com/kh13/2017
ONE-CLICK FUEL
CAP VIDEO
To view a video on
your mobile device,
snap this QR Code or
visit the listed website.
Refer to page 2 for
more information.
REMINDER:
The fuel filler door release button is located on the driver’s panel to
the left of the steering wheel.
Child Safety Locks
Located on the rear edge of the rear passenger doors, move the Child Safety Lock to
the lock position
to disable the inner door handles from opening the rear doors.
REMINDER: Child Safety Lock is located on rear passenger door jamb.
OTHER KEY FEATURES
*IF EQUIPPED
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLE TE OPER ATING INFORMATION AND SAFE T Y WARNINGS.

48
Seat Belts
Pre-Safe Seat Belt (PSB)*
To properly fasten your safety belts:
1. Insert the belt tongue plate A into the buckle until it clicks
2. Position the lap portion of the belt across your lap as LOW
ON THE HIPS as possible. Adjust the belt to a SNUG FIT by
pulling up on the shoulder portion B
Seat Belt Retractor Locks
Retractor locks allow lap/shoulder safety belts to remain
unlocked during normal vehicle operation for freedom of
movement and in creased comfort.
During a STRONG STOP, SUDDEN TURN OR CERTAIN
COLLISIONS, seat belt retractors will automatically lock
the belts to help reduce the risk of injury.
The Pre-Safe Seat Belt (PSB) will activate and pull the seat
belt into tighter contact against the occupant’s body if a
collision is detected or during certain driving maneuvers.
The PSB system operates as below:
§
The seat belt may tighten when:
- The vehicle senses a collision
- An emergency braking situation occurs
- There’s a loss of vehicle control
For more detailed information regarding your vehicle’s
s afety belts, please refer to your Owner’s Manual
and the separate brochure titled “Understanding Your
S afety Belt & Supplemental Restraint System.”
Quick Tip
The
seat belt warning chime operates for the
driver’s seat only.
A
B
REMINDERS:
The Pre-Safe Seat Belt warning light will illuminate on LCD screen if there is a problem with the system.
Have the system checked if:
- The warning light does not turn on briefly when you turn the ENGINE START/STOP button to the
ON position
- The warning light stays on after illumination for approximately 3 seconds
- The warning light comes on while the vehicle is in motion
SAFETY FEATURES
*IF EQUIPPED
SAFETY FEATURES
*IF EQUIPPED