garage door opener KIA K900 2020 Features and Functions Guide

OTHER KEY FEATURES
49ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLE TE OPERATING INFORMATION AND SAFETY WARNINGS.†LEG AL DISCL AIMERS ON BACK INSIDE COVER
ABC
Auto-Dimming Rearview Mirror
The Auto-Dimming Rearview Mirror is designed to help reduce
glare from a vehicle’s headlights located in the rear and also
connect up to three electronic transmitters in one location.
REMINDER: Mirror indicator light will illuminate when automatic dimming is ON.
HomeLink® Setup - How to Sync Transmitter
If programming for the first time, begin with Step 1 (repeating this step will delete all information).
To program non-rolling and rolling code garage door openers and other devices:
1. Press and hold the A and C buttons simultaneously until the indicator light begins
to flash (to reprogram buttons, skip this step)
2. Press and hold the desired button A, B or C and hold the button on the transmitter while it is
approximately 1 to 3 inches away from the mirror. The HomeLink® Indicator light will flash
rapidly once the frequency signal has been successfully programmed
To finish programming rolling code garage door openers, complete these steps:
3. Locate the “learn” or “smart” button on the garage door’s motor head unit. Press and release the button
and complete Step 4 within 30 seconds
4. Firmly press and release the programmed HomeLink® button up to three times
5. Press and release the Homelink button just programmed. The Homelink indicator on the mirror will
illuminate
6. To program the remaining two Homelink buttons, follow
steps 1-4 for other Rolling Code devices, or steps 2-5 to
program standard devices
For some older garage doors, see Owner’s Manual for information on how to do Two-Way Communication Programming.
Operating HomeLink®:
Press one of the programmed HomeLink® buttons.
Erasing programmed buttons:
Press and hold the A and C buttons simultaneously for
approximately 20 seconds, and then release both buttons
within 30 seconds.
HomeLink® with Auto-Dimming Rearview Mirror† 13
A HomeLink® button
B HomeLink® button
C HomeLink® button
If your garage door opener was manufactured in 2011 or later, and you’re unable to program your vehicle’s HomeLink® system, you may need to purchase a HomeLink Repeater Kit. For more information, go to www.HomeLink.com or call (800) 355-3515.
For illustration purposes only. Your system buttons may vary. See the Owner’s Manual for more information.
Quick Tips
§ You can reprogram a single HomeLink® button by repeating Step 2
§ Erasing programmed buttons will delete all trained transmitters
HOMELINK REARVIEW MIRROR SETUP VIDEO
To view a video on your mobile device, snap this QR Code or visit the listed website. Refer to page 2 for more information.www.youtube.com/KiaFeatureVideos