KIA Optima 2006 2.G Repair Manual

TRUNK LID• To open the trunk, insert the key into
the lock and turn it clockwise until an
audible “click” is heard.
• To close the trunk, use both hands to
push the trunk lid down until the lock
“snaps” shut.• Do not slam the trunk lid.
• Pull up on the trunk lid to make sure
it is securely latched.
To prevent premature wear or damage
to the trunk lid lift cylinders and
attaching hardware, the trunk lid must
be fully closed before you drive your
vehicle.
If you must drive with the trunk lid open,
keep the air vents open so that additional
outside air comes into the vehicle.
KNOWING YOUR VEHICLE
3-52
MMSA3043
WARNING - Exhaust
Fumes
If you drive with the trunk lid
open, you will draw dangerous
exhaust fumes into your
vehicle.
MS-CNA-Eng 3.QXD 7/25/2005 5:17 PM Page 52

3-53
EMERGENCY TRUNK
SAFETY RELEASE
(IF EQUIPPED)Your vehicle is equipped with an
emergency trunk release cable located
inside the trunk. When pulled, this cable
will release the trunk latch mechanism
and open the trunk.
REMOTE TRUNK LID
RELEASETo open the trunk, pull the release switch
towards the middle of the vehicle.
MMSA3044A Pull to open the
trunk
MMSA3045
WARNING
No one should be allowed to
occupy the trunk of the vehicle
at any time. If the trunk is
partially or totally closed and
the person is unable to get out,
severe injury or death could
occur due to lack of ventilation,
fumes and rapid heat build-up,
or because of exposure due to
cold weather conditions. The
trunk is also a highly
dangerous location in the event
of a crash because it is not a
protected occupant space. In
fact, it is part of the vehicle’s
crush zone.
MS-CNA-Eng 3.QXD 7/25/2005 5:17 PM Page 53

KNOWING YOUR VEHICLE
3-54TRUNK LID KNOB LOCKThe trunk lid lock knob (located near the
latch) is in the “LOCK” position when
the trunk lid is closed, it will not be
possible to open the trunk lid by using
the remote release. In this instance, use
the master key to unlock and open the
trunk lid. To allow the trunk lid to be
opened with the remote release, push the
trunk lid lock knob down, then to the
opposite direction of the “LOCK”
position.
HOODOPENING THE HOOD1. Inside the vehicle, pull the hood
release handle located at the bottom
left corner of the instrument panel.
MMSA3047
Release
handle
MMSA3046A
with the remote
release
✻
NOTICE :
• If a person is locked in the trunk
by choice, by accident or by
another person, the trunk lid
can be opened by pushing the lid
lock knob down.
• While unattended, vehicles
should be locked and the keys
kept out of the reach of children.
Children should be taught about
the dangers of playing in a
vehicle trunk.
MS-CNA-Eng 3.QXD 7/25/2005 5:17 PM Page 54

3-55
2. Go to the front of the vehicle, raise
the hood until the secondary latch
catches then all the secondary latch
up (located under the hood at the
center of the grille).
3. Raise the hood. It will raise
completely by itself after it has been
raised halfway.
CLOSING THE HOOD:• Check the area under the hood to
make certain all filler caps are in
place and that all loose items have
been removed.
• Lower the hood then push down to
properly lock in place.
• Check to make sure the hood is
closed.
FUEL FILLER LIDREMOTE FUEL FILLER
LID RELEASETo open the fuel filler lid, press the
release switch.
MMSA3074
WARNING
 Before closing the hood,
make sure that all engine
parts and tools have been
removed from the engine
area and that no one’s hands
are near the hood opening.
 Do not leave gloves, rags or
any other combustible
material in the engine
compartment. Doing so may
cause a heat-induced fire.
MMSA3048
MS-CNA-Eng 3.QXD 7/25/2005 5:17 PM Page 55

KNOWING YOUR VEHICLE
3-56
WARNING - Fuel Filling
Fuel may be under pressure.
Always remove the fuel cap
carefully and slowly. If the cap is
venting fuel or if a hissing sound
is heard, wait until the condition
stops before completely
removing the cap. If these
precautions are not followed,
fuel may spray out and cause
serious personal injury.
WARNING
Automotive fuels are flammable/
explosive materials. When
refueling, please note the
following guidelines carefully.
Failure to follow these
guidelines may result in severe
personal injury, severe burns or
death by fire or explosion.
 Before refueling always note
the location of the Emergency
Gasoline Shut-Off, if available,
at the gas station facility.
 Before touching the fuel
nozzle or fuel filler cap, you
should eliminate potentially
dangerous static electricity
discharge by touching
another metal part of the front
of the vehicle, a safe distance
away from the fuel filler neck,
nozzle, or other gas source.
 Do not get back into a vehicle
once you have begun
refueling. Do not touch, rub
or slide against any item or
fabric (polyester, satin, nylon,
etc.) capable of producing
static electricity. Static
electricity discharge can
ignite fuel vapors resulting in
explosion. If you must re-
enter the vehicle, you should
once again eliminate
potentially dangerous static
electricity discharge by
touching a metal part of the
vehicle, away from the fuel
filler neck, nozzle or other
gasoline source.
 When using a portable fuel
container be sure to place the
container on the ground prior
to refueling. Static electricity
discharge from the container
can ignite fuel vapors
causing a fire. Once refueling
has begun, contact with the
vehicle should be maintained
until the filling is complete.
Use only portable fuel
containers designed to carry
and store gasoline.
 Do not use cellular phones
around a gas station or while
refueling any vehicle. Electric
current and/or electronic
interference from cellular
phones can potentially ignite
fuel vapors causing a fire. If
you must use your cellular
phone, use it in a place away
from the gas station.
 When refueling always shut
the engine off. Sparks
produced by electrical
components related to the
engine can ignite fuel vapors
causing a fire.
MS-CNA-Eng 3.QXD 7/25/2005 5:17 PM Page 56

3-57
• To remove the cap, turn it coun
terclockwise.
• To install the cap, turn it clock wise
until it “clicks”.
This indicates that the cap is securely
tightened.The fuel filler neck is designed to
prevent filling the fuel tank with
anything but unleaded fuel.
Always insure that the
engine is OFF before and
during refueling. Once
refueling is complete, check
to make sure the fuel filler
cap and door are securely
closed, before starting the
engine.
 Do not light any fire around a
gas station. DO NOT use
matches or a lighter and DO
NOT SMOKE or leave a lit
cigarette in your vehicle while
at a gas station especially
during refueling. Automotive
fuel is highly flammable and
can, when ignited, result in
explosion by flames.
 If a fire breaks out during
refueling, leave the vicinity of
the vehicle, and immediately
contact the manager of the
gas station or contact the
police and local fire
department. Follow any
safety instructions they
provide.
✻
NOTICE
A loose fuel filler cap may cause the
OBD-II Malfunction Indicator
Light ( ) light in the instrument
panel to illuminate unnecessarily.
Always ensure that the fuel filler
cap is tight.
CHECK
✻
NOTICE
If the fuel filler cap requires
replacement, use only a genuine
Kia cap. An incorrect fuel filler cap
can result in a serious malfunction
of the fuel system or emission
control system. Correct
replacement caps are available at
Authorized Kia Dealers.
MMSA3049
Fuel filler cap
holderFuel filler neck Remove
Install
MS-CNA-Eng 3.QXD 7/25/2005 5:17 PM Page 57

KNOWING YOUR VEHICLE
3-58If the fuel filler lid will not open in cold
weather because the area around it is
frozen, push or lightly tap the lid.
STEERING WHEELHORNTo sound the horn, press the horn
symbol on your steering wheel.
MIRRORSOUTSIDE REARVIEW
MIRRORYour vehicle is equipped with both left-
hand and right-hand outside rearview
mirrors. The mirrors can either be
adjusted remotely with the control levers
or remote switch, depending on the type
your vehicle has. The mirror heads can
be folded rearward to prevent damage
when using an automatic car wash or
passing another vehicle in a narrow
street.
R
E
S
A
C
C
E
L
C
A
N
C
E
L
C
O
A
S
T
S
E
T
MMSA3050
CAUTION
• The right outside rearview
mirror is convex. Objects seen in
the mirror are closer than they
appear.
• When changing lanes, use your
interior rearview mirror or
direct observation to determine
the actual distance of following
vehicles behind you.
✻
NOTICE
Do not spill fuel on the exterior
surfaces of the vehicle. Any type of
fuel on painted surfaces may
damage the paint and creates a fire
hazard.
MS-CNA-Eng 3.QXD 7/25/2005 5:17 PM Page 58

3-59
ELECTRIC REMOTE
CONTROLThis switch, located on the armrest of the
driver’s door, controls the adjustments for
both right and left outside mirrors. To
adjust the position of either mirror:
1. Move the selector switch to the right
or left to activate the adjusting
mechanism for the corresponding
mirror.
2. Adjust the mirror angle by depressing
the mirror adjustment control switch
in the desired direction.
MMSA3052
✻
NOTICE
Do not scrape ice off the mirror
face; this may damage the surface
of the glass. If ice should restrict
movement of the mirror, do not
force the mirror to adjust it.
To remove ice, use a de-icer spray,
or a sponge or soft cloth with very
warm water.
✻
NOTICE
The mirrors stop moving when
they reach the maximum adjusting
angles, but the motor continues to
operate while the switch is
depressed. Do not depress the
switch longer than necessary or the
motor may be damaged.
MS-CNA-Eng 3.QXD 7/25/2005 5:17 PM Page 59

OUTSIDE REARVIEW
MIRROR HEATER
(IF EQUIPPED)The outside rearview mirror heater is
actuated in conjunction with the rear
window defroster. To heat the outside
rearview mirror glass, push the switch
for the rear window defroster.
The rearview mirror glass will be heated
for defrosting or defogging and will give
you improved rear vision in inclement
weather conditions. Push the switch
again to turn the heater off.
The outside rearview mirror heater
automatically turns itself off after 20
minutes.
Day/Night Rearview MirrorAdjust the rearview mirror to center on
the view through the rear window. Make
this adjustment before you start driving
and while the day/night lever is in the
day position.Pull the day/night lever toward you to
reduce glare from the headlights of
vehicles behind you during night driving.
Remember that you lose some rearview
clarity in the night position.
KNOWING YOUR VEHICLE
3-60
MMSA3053
Day/Night lever
CAUTION
Do not allow objects in the rear seat
to interfere with your line of vision
through the rear window.
MS-CNA-Eng 3.QXD 7/25/2005 5:17 PM Page 60

Electric type (if equipped)The electric day/night rearview mirror
automatically controls the glare from the
headlights of the car behind you. Adjust
the rearview mirror to the desired
position.Type APress the “O” button to turn the
automatic- dimming function off. The
mirror indicator light will turn off.
Press the “I” button to turn the
automatic- dimming function on, The
mirror indicator light will illuminate.
Type BWhen the ignition switch is ON, the
automatic-dimming function will turn on
automatically.
Press the ON/OFF button (
➀) to turn the
automatic-dimming function off. The
mirror indicator light will turn off.
Press the ON/OFF button (➀) once again
to turn the automatic-dimming function
on. The mirror indicator light will
illuminate.
3-61
CAUTION
Do not place objects in the rear
seat or cargo area which would
interfere with your vision out the
rear window.✻
NOTICE
When cleaning the mirror, use a
paper towel or similar material
dampened with glass cleaner. Do
not spray glass cleaner directly on
the mirror as that may cause the
liquid cleaner to enter the mirror
housing.
Type A
Type B
➀
MMSA3075/1KMA3084
MS-CNA-Eng 3.QXD 7/25/2005 5:17 PM Page 61