maintenance KIA Rio 2005 2.G Service Manual

7-51 Finish Damage Repair
Deep scratches or stone chips in the painted surface
must be repaired promptly. Exposed metal will quickly
rust and may develop into a major repair expense.Bright-Metal Maintenance To remove road tar and insects, use a tar remover,
not a scraper or other sharp object.
 To protect the surfaces of bright-metal parts from
corrosion, apply a coating of wax or chrome
preservative and rub to a high luster.
 During winter weather or in coastal areas, cover the
bright metal parts with a heavier coating of wax or
preservative. If necessary, coat the parts with non-
corrosive petroleum jelly or other protective
compound.
✻ ✻
NOTICE
If your vehicle is damaged and requires any metal
repair or replacement, be sure the body shop
applies anti-corrosion materials to the parts
repaired or replaced.
Underbody MaintenanceCorrosive materials used for ice and snow removal or
dust control may collect on the underbody. If these
materials are not removed, accelerated rusting can
occur on underbody parts, such as the fuel lines, frame,
floor pan and exhaust system, even though they have
been treated with rust protection.
Thoroughly flush the vehicle underbody and wheel
openings with lukewarm or cold water once a month
and especially at the end of each winter. Pay special
attention to these areas because it is difficult to see all
the mud and dirt. The lower edges of doors, rocker
panels, and frame members have drain holes that
should not be allowed to clog with dirt; trapped water
in these areas can cause rusting. It will do more harm
than good to wet down the road grime without
removing it.
RIO ENG CNA 7-2.qxd 7/29/05 5:18 PM Page 51

Maintenance7-52
Interior CareInterior General PrecautionsPrevent caustic solutions such as perfume and cosmetic
oil from contacting the dashboard; they may cause
damage or discoloration. If they do contact the
dashboard, wipe them off immediately.
Upholstery and Interior Trim Cleaning
Vinyl
First, remove dust and loose dirt from vinyl with a
whisk broom or vacuum cleaner. Then, clean vinyl
surfaces with a vinyl cleaner.
Fabric
First, remove dust and loose dirt from fabric with a
whisk broom or vacuum cleaner. Then, clean with a
mild soap solution recommended for upholstery or
carpets. Remove fresh spots immediately with a fabric
spot cleaner. If a fresh spot do not receive immediate
attention, the fabric may be stained and its color can be
affected. Also, its fire-resistant properties may be
reduced if the material is not properly maintained.
Aluminum Wheel MaintenanceThe aluminum wheels are coated with a clear
protective finish.
 Do not use any abrasive cleaner, polishing
compound, solvent, or wire brushes on aluminum
wheels. They may scratch or damage the finish.
 Use only a mild soap or neutral detergent, and rinse
thoroughly with water. Also, be sure to clean the
wheels after driving on salted roads. This helps
prevent corrosion.
 Avoid washing the wheels with high-speed car wash
brushes.
CAUTION
After washing the vehicle, test the brakes while
driving slowly to see if they have been affected
by water.
RIO ENG CNA 7-2.qxd 7/29/05 5:18 PM Page 52

Interior Care ....................................................................7-52
Interior Features ..............................................................4-40
Interior Lights .................................................................3-65K
eyless Entry System......................................................3-3
Keys ..................................................................................3-2
Label Information ..........................................................5-13
Lighting ...........................................................................4-33
Lubricant Specifications .................................................7-47
Lubricants and Fluids......................................................7-26
Luggage Net ....................................................................3-68M
aintenance Schedule ...................................................7-5
Maintenance Services .......................................................7-3
Manual Transaxle ..............................................................4-7
Mirrors ............................................................................3-62
O
verheating .....................................................................6-2
Overloading.....................................................................5-13
Owner Maintenance ........................................................7-10
Parking Brake ................................................................7-21
Power Outlet ...................................................................3-70
Power Steering.......................................................4-22, 7-22
R
ear Hatch .....................................................................3-54
Rear Window Defroster ..................................................4-38
Road Warning ...................................................................6-2
Roof Rack .......................................................................3-69
Safety Belts ....................................................................3-20
Seats ................................................................................3-11
Special Driving Conditions...............................................5-7
Specifications ................................................................... 8-2
Starting the Engine............................................................4-4
Steering Wheel ................................................................3-62
Suggestions for Economical Operation ............................5-6
Sunglass Holder ..............................................................3-67Tilt Steering ...................................................................4-22
Tires and Wheels.............................................................7-34
Tonneau Cover ................................................................3-71
Towing ............................................................................6-14
Trailer Towing.................................................................5-12
Trunk Lid ........................................................................3-55V
ehicle Break-In Process ................................................1-3
W
arnings and Indicators ...............................................4-27
Windows ...........................................................................3-8
Index9-2
RIO ENG CNA 9.qxd 7/29/05 5:19 PM Page 9-2