fuse chart KIA Rio 2005 2.G Owner's Manual

Electrical Circuit ProtectionFusesA vehicle’s electrical system is protected from
electrical overload damage by fuses.
This vehicle has two fuse panels, one located in the
driver’s side kick panel, the other in the engine
compartment near the battery. A fuse panel chart is
provided later in this section.
If any of your vehicle’s lights, accessories, or controls
do not work, check the appropriate circuit fuse. If a
fuse has blown, the element inside the fuse will be
melted.
Always replace a blown fuse with one of the same
rating.
If the replacement fuse blows out, this indicates an
electrical problem. Avoid using the system involved
and immediately consult an Authorized Kia Dealer.
Two kinds of fuses are used: standard for lower
amperage rating, and main for higher amperage
ratings.
6-7
Standard
Normal
NormalBlown
Blown Main fuse
AS2B06003
RIO ENG CNA 6.qxd 7/29/05 5:15 PM Page 7

Fuse Replacement
If the electrical system does not work, first check the
driver’s side fuse panel.
1. Turn the ignition switch and all other switches off.
2. Pull the suspected fuse straight out. Use the
removal tool provided on the main fuse box in the
engine compartment. Refer to the fuse panel chart
on the fuse panel cover to identify the likely
problem fuse or electrical circuit.3. Check the removed fuse; replace if it is blown.
Spare fuses are provided in the passenger
compartment fuse panel, and in the engine
compartment fuse panel cover.
4. Push in a new fuse of the same rating, and make
sure it fits tightly in the clips.
If it fits loosely, consult an Authorized Kia Dealer.
If you do not have a spare, use a fuse of the same
rating from a circuit you may not need for operating
the vehicle, such as the CIGAR or AUDIO fuse.In Case Of An Emergency6-8
WARNING -Fuse Replacement
 Never replace a fuse with anything but
another fuse of the same type and rating.
 A higher capacity fuse could cause damage
and possibly a fire.
 Never install a wire in place of the proper
fuse - even as a temporary repair. It may
cause extensive wiring damage and possibly
a fire.
 Do not use a screwdriver or any other metal
object to remove fuses because it may cause
a short circuit and damage the system.
1B3106003A
RIO ENG CNA 6.qxd 7/29/05 5:15 PM Page 8