open hood KIA RIO 2017 Features and Functions Guide
[x] Cancel search | Manufacturer: KIA, Model Year: 2017, Model line: RIO, Model: KIA RIO 2017Pages: 46, PDF Size: 3.43 MB
Page 11 of 46

9
The ISG system is disabled when: •A seat belt is unfastened •The hood or a door is opened •Battery condition is poor •The front or rear defroster is turned on •Engine coolant temperature is low
•The outside ambient temperature is too low/high •Emission control devices activate •The vehicle is on a steep slope
QUICK TIPS
Idle, Stop and Go System Video To view a video on your mobile device, snap this QR Code or visit the listed website .
Refer to page 2 for more information .
www.KuTechVideos.com/ub13/2017
QR CODE
B
(Buttons located on left side of Driver’s Panel)
(Type B Cluster)
A
Idle, Stop and Go (ISG) System*
The ISG system helps reduce fuel consumption by automatically shutting down
the engine when the vehicle is at a standstill .
When the ISG system is ON and the vehicle is at a standstill the engine will
stop, and the green AUTO STOP indicator on the instrument cluster A will
illuminate and the message Auto Stop will appear in the LCD screen* .
The engine will restart when the brake pedal is released or the shift lever is
moved from D (Drive) to the R (Reverse) position or to Sport mode . When engine
restarts, the green AUTO STOP indicator on the instrument cluster will turn off .
To deactivate the ISG System, press the ISG OFF button B . If you press again,
the system will be activated .
REMINDERS:
•ISG is active by default at vehicle start-up . When ignition is cycled, ISG will turn ON again
•Under certain conditions, the engine will restart automatically
• If the AUTO STOP indicator is illuminated yellow, please contact an authorized Kia dealer
For more information on Idle, Stop and Go System, refer to your Owner’s Manual or contact your local dealership.
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS. *IF EQUIPPED
DRIVER'S PANEL
Page 33 of 46

31
(Lever located on the driver’s floor near door sill)
B
C
D
(Lever located near floor below Driver’s Panel)
(Latch located inside hood)
A
Hood Release Lever and Latch
Opening the Hood:
1 . Pull the Hood Release Lever A to unlatch
the Hood
2 . In the front of the vehicle, lift the Hood
slightly, push the secondary Latch B to
the left inside of the hood’s center and lift
the hood
3 . Pull out the support rod from the Hood and
set into place to hold the Hood open
Fuel Door Release Lever
Lift the lever C upwards to release
the fuel door .
Trunk Release Lever
(4-door model)
Lift the lever D upwards to unlock
the trunk lid .
Sunvisor
Use the Sunvisor to shield direct light through the front or side
windows . Slide the Sunvisor out and adjust as needed .
REMINDERS:
•Sunvisor may not shield all direct light
• The Sunvisor may impair visibility if not adjusted properly . Do not operate the vehicle if Sunvisor is impairing your visibility
• Be aware of seating position when adjusting or swinging Sunvisor around to or from the front or side windows .
REMINDER: Open the Hood only after turning the engine off, on a flat surface, with the gear shift in P (Park) position and setting the parking brake .
Closing the Hood:
Lower the Hood about halfway and then press down to securely lock
in place .
REMINDER: While lowering and closing, keep hands away from under the Hood .
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS. *IF EQUIPPED
OTHER KEY FEATURES