run flat KIA RIO 2017 Features and Functions Guide

31
(Lever located on the driver’s floor near door sill)
B
C
D
(Lever located near floor below Driver’s Panel)
(Latch located inside hood)
A
Hood Release Lever and Latch
Opening the Hood:
1 . Pull the Hood Release Lever A to unlatch
the Hood
2 . In the front of the vehicle, lift the Hood
slightly, push the secondary Latch B to
the left inside of the hood’s center and lift
the hood
3 . Pull out the support rod from the Hood and
set into place to hold the Hood open
Fuel Door Release Lever
Lift the lever C upwards to release
the fuel door .
Trunk Release Lever
(4-door model)
Lift the lever D upwards to unlock
the trunk lid .
Sunvisor
Use the Sunvisor to shield direct light through the front or side
windows . Slide the Sunvisor out and adjust as needed .
REMINDERS:
•Sunvisor may not shield all direct light
• The Sunvisor may impair visibility if not adjusted properly . Do not operate the vehicle if Sunvisor is impairing your visibility
• Be aware of seating position when adjusting or swinging Sunvisor around to or from the front or side windows .
REMINDER: Open the Hood only after turning the engine off, on a flat surface, with the gear shift in P (Park) position and setting the parking brake .
Closing the Hood:
Lower the Hood about halfway and then press down to securely lock
in place .
REMINDER: While lowering and closing, keep hands away from under the Hood .
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS. *IF EQUIPPED
OTHER KEY FEATURES