warning KIA Sorento 2006 1.G User Guide

Rear height of front seat cushion
Move the rear portion of the control
knob up to raise or down to lower the
rear part of the seat cushion.Height of front seat cushion
To raise or lower the seat cushion
totally, pull up and push down on the
center of the corresponding switch.KNOWING YOUR VEHICLE3-18
S2BLA340E
S2BLA340D
WARNING
To minimize the risk of possible
severe personal injury in the
event of a collision, both the dri-
ver's and passenger's seat-
backs should be in a normal
seating position while the car is
in motion. The protection pro-
vided by the vehicle’s restraint
system may be reduced signifi-
cantly when the seatbacks are
reclined. All parts of the
restraint system are designed
to absorb energy in an accident
and this can best be accom-
plished if the seatback is in a
normal seating position and the
seatbelt is in close proximity to
the occupant.
BL-ENG (CAN)-3.qxd 7/28/05 5:52 PM Page 18

If your vehicle is equipped with the
headrest swing feature, the front
headrests may be adjusted forward
to four positions by pulling it forward.
To adjust the headrest backwards,
pull it forward and release it.KNOWING YOUR VEHICLE3-20
WARNING
- Headrests
 To reduce the risk of head and
neck injuries, don’t operate
the vehicle with the headrest
removed or improperly posi-
tioned.
 For best protection, adjust the
headrest so its center is as
high as your ears.
 Do not adjust the driver’s
headrest while driving.
BL-ENG (CAN)-3.qxd 7/28/05 5:52 PM Page 20

REAR SEAT
Split Folding Rear Seat
The rear seatbacks fold forward to
provide additional cargo space and to
provide access to the cargo area.
To fold the rear seatback(s) down,
press the lock release button locat-
ed on top of the seatbacks, then fold
the seatback forward and down.
To raise the seatback, lift and push it
firmly until it clicks into place.
When you return the seatback to its
upright position, reposition the rear
safety belts so that they can be used
by rear seat passengers.
KNOWING YOUR VEHICLE
3-21
S2BLB301A
WARNING- Rear Seatback
 The rear seatback must be
securely latched. If not, pas-
sengers and objects could be
thrown forward resulting in
serious injury or death in the
event of a sudden stop or col-
lision.
 Luggage and other cargo
should be laid flat in the cargo
area. If objects are large,
heavy, or must be piled, they
must be secured. Under no
circumstances should cargo
be piled higher than the seat-
backs. Failure to follow these
warnings could result in seri-
ous injury or death in the
event of a sudden stop, colli-
sion or rollover.
(Continued)
(Continued)
 No passenger should ride in
the cargo area or sit or lie on
folded seatbacks while the
vehicle is moving. All passen-
gers must be in seats and
restrained properly while rid-
ing.
 When resetting the seatback
to the upright position, make
sure it is securely latched by
pushing it forward and back-
wards.
 To avoid the possibility of
burns, do not remove the car-
pet in the cargo area.
Emission controls beneath
this floor generate high
exhaust temperatures.
BL-ENG (CAN)-3.qxd 7/28/05 5:52 PM Page 21

Center Armrest
This armrest is located in the center
of the rear seatback. Pull the armrest
down using the strap provided on the
armrest.
KNOWING YOUR VEHICLE3-24
S2BLB301F
CAUTION
Do not remove the floor carpet
in your vehicle. Emission con-
trol system components cause
high exhaust temperatures
under the floor.
WARNING
- Cargo
Cargo should always be
secured to prevent it from shift-
ing and causing injury to the
vehicle occupants.
BL-ENG (CAN)-3.qxd 7/28/05 5:52 PM Page 24

SAFETY BELTSPre-tensioner Seat Belt
Your vehicle is equipped with driver’s
and front passenger’s pre-tensioner
safety belts. The purpose of the pre-
tensioner is to pull the safety belt
snugly against the occupant’s body in
certain frontal collisions.
The pre-tensioner safety belts will
activate, along with the airbags, when
a frontal collision is severe enough.When the vehicle stops suddenly, or
if the occupant tries to lean forward
too quickly, the seat belt retractor will
lock into position. However, in certain
frontal collisions, the pre-tensioner
will also activate and pull the seat belt
into tighter contact against the occu-
pant’s body.The safety belt pre-tensioner system
consists mainly of the following com-
ponents.
Their locations are shown in the illus-
tration.
1. SRS airbag warning light.
2. Seat belt pre-tensioner assembly.
3. SRS control module.
KNOWING YOUR VEHICLE
3-25
SBS403100
S2BLD312
2
3
1
Passenger’s
side airbag
Driver’s side airbag
WARNING
To obtain maximum benefit
from a pre-tensioner, safety belt
must be worn correctly.
BL-ENG (CAN)-3.qxd 7/28/05 5:52 PM Page 25

Safety Belt Restraint System
KNOWING YOUR VEHICLE3-26
CAUTION
 When the pre-tensioner safety
belts are activated, a loud
noise may be heard and fine
powder, which may appear to
be smoke, may be visible in the
passenger compartment. The
powder is not toxic.
 The powder may cause skin
irritation and should not be
breathed for prolonged peri-
ods. Wash your hands and face
thoroughly after an accident in
which such powder has been
released.
 If the pre-tensioner seat belt is
not working properly, the airbag
warning light will illuminate,
since both devices are on the
same electrical circuit. If the
SRS airbag warning light does
not blink when the ignition key
is turned to “ON” or “ACC”, or if
it remains illuminated for more
than 6 seconds, or if it illumi-
nates while the vehicle is being
driven, please have an author-
ized Kia dealer inspect the sys-
tem as soon as possible.
WARNING- Pretentioner Repair or
Replacement
 Pre-tensioners are designed
to operate once. After activa-
tion, pre-tensioner safety
belts must be replaced.
 Do not attempt to inspect,
repair or replace the pre-ten-
sioner safety belts yourself.
You can permanently damage
the system.
WARNING
- Safety Belts
To minimize the risk of serious
or fatal injury in an accident, the
driver and all passengers
should use the appropriate
safety restraints for their age
and size. The presence of
airbags does not change the
need to be properly restrained
by a safety belt or size-appro-
priate child restraint. In fact,
airbags can work properly when
passengers are correctly
restrained in the vehicle. Be
sure you are familiar with the
information in this section,
including the information on
infant and child restraints.
Read the safety warnings on the
sun visors.
BL-ENG (CAN)-3.qxd 7/28/05 5:52 PM Page 26

Safety belts provide the best restraint
when:
The seatback is upright
The occupant is sitting upright (not
slouched)
The lap belt is snug across the hips
The shoulder belt is snug across
the chest
The knees are straight forward
To help you remember to fasten your
safety belt, a warning light will come
on and a chime will sound. See
Safety Belt Warning Light and Chime
on page 3-29.KNOWING YOUR VEHICLE3-28
WARNING - After a Collision
 Lap/shoulder belt assemblies
may be stretched or damaged
when subjected to the stress
and forces of a collision.
 The entire restraint system
should be inspected following
any collision. All belts, retrac-
tors, anchors and hardware
damaged by a collision
should be replaced before the
vehicle is operated again.
WARNING
- Cargo Area
Passengers should never be
allowed to ride in the cargo area
of a vehicle. No safety belts are
provided for the cargo area.
Persons riding in the vehicle
without a fastened safety belt
are much more likely to suffer
serious bodily injury or death
during an accident.
WARNING
- Twisted Belts
A twisted or jammed safety belt
cannot restrain you properly. If
you cannot untwist or unjam
the safety belt, see your Kia
dealer immediately. Never drive
or ride with a twisted or jammed
safety belt.
WARNING
- Belt Use
Safety belts must be used cor-
rectly to work properly in an
accident. Each seating position
in your vehicle has a specific
safety belt assembly that
includes a buckle and tongue
designed to be used together.
For greatest effectiveness, fol-
low these guidelines in using
safety belts:
 Use the shoulder portion of
the safety belt on the outside
shoulder only. Never wear the
shoulder portion under the
arm.
 Never swing the safety belt
around your neck to fit over
the inside shoulder.
 Never wear the shoulder por-
tion of the safety belt across
the neck or face.
(Continued)
BL-ENG (CAN)-3.qxd 7/28/05 5:52 PM Page 28

Safety Belt Warning Light and
Chime
Type A
As a reminder to the driver and pas-
senger, safety belt warning light will
illuminate for approximately 6 sec-
onds each time you turn the ignition
switch ON regardless of belt fasten-
ing.
If the driver's safety belt is not fas-
tened when the ignition key is turned
ON, the safety belt warning chime will
sound for approximately 6 seconds.
KNOWING YOUR VEHICLE
3-29
(Continued)
 Wear the lap portion as low as
possible. Be sure that the lap
belt fits snugly around the
hips. never wear a lap belt or
lap portion of a lap/shoulder
belt over your waist; it should
always go over the stronger
area of your hips.
 Never use a single safety belt
for more than one person.
 The seatbacks should always
remain in a comfortable,
upright position when the
vehicle is moving.
(Continued)
 Inspect the safety belts peri-
odically for excessive wear or
damage. Pull out each belt
fully and look for fraying, cuts,
burns or other damage. Pull
the safety belt out and let it
retract a number of times.
Make sure that the lap/shoul-
der belts return smoothly and
easily into the retractor.
 Check the latches to make
sure they latch and release
without interference or delay.
 Never close the doors on any
part of the lap or shoulder
belt.
 Any belt not in good condition
or in good working order
should be promptly replaced.
CAUTION
Never close the doors on any part
of the lap or shoulder belt. It can
damage the safety belt or buckle
which could increase the risk of
injury in case of an accident.
WARNING- Safety Belt Care
 A damaged belt may not give
you the protection you need in
an accident.
(Continued)
W-29
BL-ENG (CAN)-3.qxd 7/28/05 5:52 PM Page 29

Type B
As a reminder to the driver and pas-
senger, safety belt warning light will
blink for approximately 6 seconds
each time you turn the ignition switch
ON regardless of belt fastening.
If the driver's safety belt is unfastened
after the ignition switch is ON, the
safety belt warning light will blink for
approximately 6 seconds.
If the driver's safety belt is not fas-
tened when the ignition key is turned
ON, the safety belt warning chime will
sound for approximately 6 seconds.Front and Rear Outboard
Lap/Shoulder Belt
To fasten the lap/shoulder belt:
1. Grasp the buckle and tongue plate.
2. Slowly pull the lap/shoulder belt
out from the retractor.3. Insert the tongue plate into the
open end of the buckle until an
audible “click”is heard, indicating
the belt is locked in the buckle.KNOWING YOUR VEHICLE3-30
S2BLA371
S2BLA372
BL-ENG (CAN)-3.qxd 7/28/05 5:52 PM Page 30

3 Point Rear Center Belt
(If equipped)
To fasten the rear center belt
1. Slowly pull the tongue plates out
from the retractor.
KNOWING YOUR VEHICLE3-32
S2BLB302Z
WARNING -
Safety Belts
 The seatbacks should always
remain in a comfortable,
upright position while the
vehicle is in motion. The safe-
ty belt system will provide the
most protection with the seat-
backs in an upright position.
 Never wear the shoulder por-
tion of the safety belt under
the outside arm or behind the
back.
 Never wear the shoulder por-
tion of the safety belt across
the neck or face.
 Wear the lap portion of the
safety belt as low as possible.
Be sure the lap belt fits snug-
ly around the hips. Never wear
the lap belt over your waist.
 Make sure the safety belts are
not twisted while in use.
(Continued)
(Continued)
 Never use a single belt to
restrain more than one person
at a time.
Failure to follow these warnings
will increase the chance and
severity of injury in an accident.
BL-ENG (CAN)-3.qxd 7/28/05 5:52 PM Page 32