power steering KIA STONIC 2018 User Guide

• Use your air conditioning sparingly.The air conditioning system is oper‐
ated by engine power so your fuel economy is reduced when you use it.
• Open windows at high speeds can re‐ duce fuel economy.
• Fuel economy is less in crosswinds and headwinds. To help offset some
of this loss, slow down when driving
in these conditions.
Keeping a vehicle in good operating
condition is important both for econo‐
my and safety. Therefore, have the system serviced by a professional
workshop.
Kia recommends to visit an authorized
Kia dealer/service partner.
WARNING
nEngine off during motion
Never turn the engine off to coastdown hills or anytime the vehicle isin motion. The power steering andpower brakes will not function prop‐erly without the engine running. In‐stead, keep the engine on and down‐
(Continued)
(Continued)
shift to an appropriate gear for en‐gine braking effect. In addition, turn‐ing off the ignition while drivingcould engage the steering wheel lockresulting in loss of vehicle steeringwhich could cause serious injury ordeath.

6-77
6
Driving your vehicle

Components of the Tire Mobility Kit (TMK)1. Speed restriction label
2. Sealant bottle and label with speedrestriction
3. Filling hose from sealant bottle to wheel
4. Connectors and cable for the power outlet direct connection
5. Holder for the sealant bottle
6. Compressor
7. On/off switch
8. Pressure gauge for displaying the tire inflation pressure
9. Button for reducing tire inflation pressure
Connectors, cable and connection hose are stored in the compressor housing.
WARNING
Before using the Tire Mobility Kit,follow the instructions on the seal‐ant bottle.Remove the label with the speed re‐striction from the sealant bottle andapply it to the steering wheel.
(Continued)
What to do in an emergency
7-22

(Continued)
Please note the expiry date on thesealant bottle.
Using the Tire Mobility Kit
1. Detach the speed restriction label(1) from the sealant bottle (2), and
place it in a highly visible place in‐
side the vehicle such as on the
steering wheel to remind the driver
not to drive too fast.
2. Filling the sealant Strictly follow the specified sequence, otherwise
the sealant may escape under high pressure.
3. Shake the sealant bottle.
4. Connect the filling hose (3) onto the connector of the sealant bottle (A).
5. Ensure that the button (9) on the compressor is not pressed.
6. Unscrew the valve cap from the valve of the defective wheel and
screw the filling hose (3) of the
sealant bottle onto the valve.
7. Insert the sealant bottle into the housing of the compressor so that
the bottle is upright (B).
8. Ensure that the compressor is switched off, position 0.
9. Connect between compressor and the vehicle power outlet using the
cable and connectors.
NOTICE
Only use the front passenger side
power outlet.
10. With the ignition switched on or en‐ gine start/stop button position on:
Switch on the compressor and let it
run for approximately 3 minutes to
fill the sealant. The inflation pres‐
sure of the tire after filling is unim‐
portant.
11. Switch off the compressor.

7-23
7
What to do in an emergency

Removable towing hook (if
equipped)
0:#%
'SPOU
1. Open the tailgate, and remove thetowing hook from the tool case.
2. Remove the hole cover pressing the upper (front) part of the cover on
the bumper.
3. Install the towing hook by turning it clockwise into the hole until it is
fully secured.
4. Remove the towing hook and install the cover after use.
Emergency towing
0:#%
'SPOU
0:#%
3FBS
If towing is necessary, we recommendyou to have it done by an authorizedKia dealer or a commercial tow truckservice. If towing service is not available in an
emergency, your vehicle may be tem‐ porarily towed using a cable or chain
secured to the emergency towing hook
under the front (or rear) of the vehicle. Use extreme caution when towing the
vehicle. A driver must be in the vehicle
to steer it and operate the brakes.
Towing in this manner may be done on‐ ly on hard-surfaced roads for a short
distance and at low speed. Also, the
wheels, axles, power train, steering and brakes must all be in good condition. • Do not use the tow hooks to pull a vehicle out of mud, sand or other
conditions from which the vehicle
cannot be driven out under its own
power.
• Avoid towing a vehicle heavier than the vehicle doing the towing.
• The drivers of both vehicles should communicate with each other fre‐
quently.
CAUTION
•Attach a towing strap to the towhook.
(Continued)

7-27
7
What to do in an emergency

• Press the brake pedal with moreforce than normal since you will have
reduced brake performance.
• More steering effort will be required because the power steering system
will be disabled.
• If you are driving down a long hill, the brakes may overheat and brake per‐
formance will be reduced. Stop often
and let the brakes cool off.
CAUTION
nAutomatic transaxle
•If the car is being towed with allfour wheels on the ground, it canbe towed only from the front. Besure that the transaxle is in neu‐tral. Be sure the steering is un‐locked by placing the ignitionswitch in the ACC position. A drivermust be in the towed vehicle tooperate the steering and brakes.
•To avoid serious damage to theautomatic transaxle, limit the ve‐hicle speed to 15 km/h (10 mph)and drive less than 1.5 km (1 mile)when towing.
(Continued)
(Continued)
•Before towing, check the auto‐matic transaxle for fluid leaks un‐der your vehicle. If the automatictransaxle fluid is leaking, flatbedequipment or a towing dolly mustbe used.

7-29
7
What to do in an emergency