engine KIA STONIC 2018 Owner's Manual

• Lock the doors by pressing thelock button on the smart key.
After completion of the steps
above, the hazard warning lights
will operate once to indicate thatthe system is armed.
If any door (and tailgate) or en‐
gine hood remains open, the haz‐
ard warning lights won't operate
and theft-alarm will not arm. Af‐
ter this, if all doors (and tailgate)
and engine hood are closed, thehazard warning lights blink once.
Using the transmitter
Park the vehicle and stop the engine.
Arm the system as described below. 1. Turn off the engine and remove the ignition key from the ignition
switch.
2. Make sure that all doors (and tail‐ gate), the engine hood are closed
and latched. 3. Lock the doors by pressing the lock
button on the transmitter.
After completion of the steps
above, the hazard warning lights
will blink once to indicate that the
system is armed.
If any door (and tailgate) or engine
hood remains open, the hazard
warning lights won't operate and
theft-alarm will not arm. After this,if all doors (and tailgate) and engine
hood are closed, the hazard warn‐
ing lights blink once.
•
Do not arm the system until all pas‐sengers have left the vehicle. If thesystem is armed while a passenger(s)remains in the vehicle, the alarm maybe activated when the remaining pas‐senger(s) leave the vehicle. If anydoor, tailgate or engine hood isopened within 30 seconds after en‐tering the armed stage, the systemis disarmed to prevent unnecessaryalarm.
Theft-alarm stage
The alarm will be activated if any of the
following occurs while the system is armed. • A door is opened without using the transmitter (or smart key). • The tailgate is opened without using
the transmitter (or smart key).
• The engine hood is opened.
The horn will sound and the hazard
warning lights will blink continuously for approximately 30 seconds. To turn
off the system, unlock the doors with
the transmitter (or smart key).
Disarmed stage
The system will be disarmed when:
Transmitter
- The door unlock button is pressed.
- The engine is started.
- The ignition switch is in the L

After pressing the unlock button, if any
door (or tailgate) is not opened within 30 seconds, the system will be re‐
armed.
NOTICE
nNon-immobilizer system
•Avoid trying to start the engine
while the alarm is activated. The
vehicle starting motor is disabled
during the theft-alarm stage.
If the system is not disarmed with
the transmitter, insert the key in‐
to the ignition switch, turn the ig‐
nition switch to the ON position
and wait for 30 seconds. Then the
system will be disarmed.
•If you lose your keys, Kia recom‐
mends to visit an authorized Kia
dealer/service partner.
NOTICE
nImmobilizer system
(Continued)
(Continued)
•If the system is not disarmed with
the transmitter, insert the key in‐
to the ignition switch and start the
engine. Then the system will be
disarmed.
•If you lose your keys, Kia recom‐
mends to visit an authorized Kia
dealer/service partner.
CAUTION
Do not change, alter or adjust thetheft-alarm system because it couldcause the theft-alarm system tomalfunction. Have the system serv‐iced by a professional workshop. Kiarecommends to visit an authorizedKia dealer/service partner.Malfunctions caused by improper al‐terations, adjustments or modifica‐tions to the theft-alarm system arenot covered by your vehicle manu‐facturer warranty.

4-15
4
Features of your vehicle

(Continued)
juries or vehicle damage. If an objectless than 4 mm (0.16 in.) in diameteris caught between the window glassand the upper window channel, theautomatic reverse window may notdetect the resistance and will notstop and reverse direction.
WARNING
The automatic reverse featuredoesn't active while resetting powerwindow system.Make sure body parts or other ob‐jects are safely out of the way be‐fore closing the windows to avoid in‐juries or vehicle damage.
Power window lock button (if
equipped)
• The driver can disable the power win‐dow switches on the rear passenger
doors by pressing the power window lock button located on the driver’s
door to the LOCK position (pressed).
•
When the power window lock buttonis in the LOCK position (pressed), thedriver’s master control can operateall power windows. Also, the frontpassenger’s control can operate thefront passenger’s power window.
CAUTION
•To prevent possible damage to thepower window system, do notopen or close two windows ormore at the same time. This willalso ensure the longevity of thefuse.
•Never try to operate the mainswitch on the driver's door and theindividual door window switch inopposite directions at the sametime. If this is done, the windowwill stop and cannot be opened orclosed.
WARNING
nWindows
•NEVER leave the ignition key in thevehicle with unsupervised children,when the engine is running.
(Continued)
Features of your vehicle
4-26

HOOD
Opening the hood
0:##
1. Pull the release lever to unlatch thehood. The hood should pop open
slightly.
WARNING
Open the hood after turning off theengine on a flat surface, shifting theshift lever to the P(Park) position forautomatic transaxle and to the 1st(First) gear or R (Reverse) for man‐ual transaxle, and setting the park‐ing brake.
0:#%
2. Go to the front of the vehicle, raise the hood slightly, push the secon‐
dary latch (1) inside of the hood
center and lift the hood (2).
0:#%
3. Pull the support rod from the hood.
4. Hold the hood open with the sup‐ port rod.
WARNING
nHot parts
Grasp the support rod in the areawrapped in rubber. The rubber willhelp prevent you from being burnedby hot metal when the engine is hot.
Hood open warning (if equipped)
0:##
The warning message will appear on
the LCD display when hood is open.
The warning chime will operate when the vehicle is being driven at or above
3 km/h (2 mph) with the hood open.
Features of your vehicle
4-28

Closing the hood
1. Before closing the hood, check thefollowing:• All filler caps in engine compart‐ ment must be correctly installed.
• Gloves, rags or any other com‐ bustible material must be re‐
moved from the engine compart‐ment.
2. Return the support rod to its clip to prevent it from rattling.
3. Lower the hood until it is about 30 cm above the closed position and
let it drop. Make sure that it locks
into place.
4. Check that the hood has engaged properly. If the hood can be raised
slightly, it is not properly engaged.
Open it again and close it with a lit‐
tle more force.WARNING
•Before closing the hood, ensurethat all obstructions are removedfrom the hood opening. Closing thehood with an obstruction presentin the hood opening may result inproperty damage or severe per‐sonal injury.
•Do not leave gloves, rags or anyother combustible material in theengine compartment. Doing somay cause a heat-induced fire.
WARNING
•Always double check to be surethat the hood is firmly latched be‐fore driving away. If it is not latch‐ed, the hood could fly open whilethe vehicle is being driven, causinga total loss of visibility, whichmight result in an accident.
(Continued)
(Continued)
•The support rod must be insertedcompletely into the hole providedin the hood whenever you inspectthe engine compartment. This willprevent the hood from falling andpossibly injuring you.
•Do not move the vehicle with thehood raised. The view will beblocked and the hood could fall orbe damaged.

4-29
4
Features of your vehicle

FUEL FILLER LID
Opening the fuel filler lid
0:##
The fuel-filler lid must be opened from
inside the vehicle by pulling up on the fuel-filler lid opener located on the
front floor area on the driver’s seat.
NOTICE
If the fuel filler lid will not open be‐
cause ice has formed around it, tap
lightly or push on the lid to break the
ice and release the lid. Do not pry on
the lid. If necessary, spray around
the lid with an approved de-icer fluid
(do not use radiator anti-freeze) or
move the vehicle to a warm place
and allow the ice to melt.
0:#%
1. Stop the engine. 2. To open the fuel filler lid, pull up the
fuel filler lid opener.
3. Pull the fuel filler lid (1) out to fully open.
4. To remove the cap, turn the fuel tank cap (2) counterclockwise.
5. Refuel as needed.
Closing the fuel filler lid
1. To install the cap, turn it clockwise until it L

(Continued)
•Do not use cellular phones whilerefueling. Electric current and/orelectronic interference from cellu‐lar phones can potentially ignitefuel vapors causing a fire.
•When refueling, always shut theengine off. Sparks produced byelectrical components related tothe engine can ignite fuel vaporscausing a fire. Once refueling iscomplete, check to make sure thefiller cap and filler door are secure‐ly closed, before starting the en‐gine.
•DO NOT use matches or a lighterand DO NOT SMOKE or leave a litcigarette in your vehicle while at agas station especially during refu‐eling. Automotive fuel is highlyflammable and can, when ignited,result in fire.
•If a fire breaks out during refuel‐ing, leave the vicinity of the vehi‐cle, and immediately contact themanager of the gas station andthen contact the local fire depart‐ment. Follow any safety instruc‐tions they provide.
CAUTION
•Make sure to refuel your vehicleaccording to the L

STEERING WHEEL
Electric power steering
Power steering uses the motor to as‐sist you in steering the vehicle. If the
engine is off or if the power steering
system becomes inoperative, the vehi‐ cle may still be steered, but it will re‐
quire increased steering effort.
The motor driven power steering is
controlled by the power steering con‐ trol unit which senses the steering
wheel torque, steering wheel position
and vehicle speed to command the mo‐ tor.
The steering wheel becomes heavier as
the vehicle’s speed increases and be‐
comes lighter as the vehicle’s speed de‐ creases for better control of the steer‐
ing wheel.
Should you notice any change in the ef‐
fort required to steer during normal ve‐ hicle operation, have the system
checked by a professional workshop.
Kia recommends to visit an authorized Kia dealer/service partner.NOTICE
The following symptoms may occur
during normal vehicle operation:
•The EPS warning light does not il‐
luminate.
•The steering effort is high imme‐
diately after turning the ignition
switch on. This happens as the
system performs the EPS system
diagnostics. When the diagnostics
is completed, the steering wheel
will return to its normal condition.
•A click noise may be heard from
the EPS relay after the ignition
switch is turned to the ON or LOCK
position.
•Motor noise may be heard when
the vehicle is at a stop or at a low
driving speed.
(Continued)
(Continued)
•If the Electric Power Steering Sys‐
tem does not operate normally,
the warning light will illuminate on
the instrument cluster. The steer‐
ing wheel may become difficult to
control or operate abnormally. In
this case, have the system inspec‐
ted by a professional workshop.
Kia recommends to visit an au‐
thorized Kia dealer/service part‐
ner.
•The steering effort increases if
the steering wheel is rotated con‐
tinuously when the vehicle is not
in motion. However, after a few
minutes, it will return to its normal
conditions.
•When you operate the steering
wheel in low temperature, abnor‐
mal noise could occur. If tempera‐
ture rises, the noise will disappear.
This is a normal condition.
(Continued)

4-37
4
Features of your vehicle

Electrochromic mirror (ECM) (if
equipped)
The electric rearview mirror automati‐
cally controls the glare from the head‐ lights of the vehicles behind you in
nighttime or low light driving condi‐
tions. The sensor (3) mounted in the mirror senses the light level around the
vehicle, and automatically controls the
headlight glare from the vehicles be‐ hind you.
When the engine is running, the glare is
automatically controlled by the sensor
mounted in the rearview mirror. Whenever the shift lever is shifted into
reverse (R), the mirror will automatical‐
ly go to the brightest setting in order
to improve the drivers view behind the vehicle.
CAUTION
When cleaning the mirror, use a pa‐per towel or similar material damp‐ened with glass cleaner. Do notspray glass cleaner directly on themirror. It may cause the liquid clean‐er to enter the mirror housing.
To operate the electric rearview mirror:
• The mirror defaults to the ON posi‐ tion whenever the ignition switch is
turned on.
• Press the ON/OFF button (1) to turn the automatic dimming function off.
The mirror indicator light (2) will turn
off.
Press the ON/OFF button (1) to turn
the automatic dimming function on.
The mirror indicator light (2) will illu‐ minate.
Outside rearview mirror
Be sure to adjust mirror angles before
driving. Your vehicle is equipped with both left-
hand and right-hand outside rearview
mirrors. The mirrors can be adjusted
remotely with the remote switch. The mirror heads can be folded back to pre‐
vent damage during an automatic car
wash or when passing in a narrow street.
WARNING
nRearview mirrors
•The outside rearview mirror isconvex. Objects seen in the mirrorare closer than they appear.
•Use your interior rearview mirroror direct observation to determinethe actual distance of followingvehicles when changing lanes.
CAUTION
Do not scrape ice off the mirror face;this may damage the surface of theglass. If ice should restrict move‐ment of the mirror, do not force themirror for adjustment. To remove
(Continued)
Features of your vehicle
4-42

Folding the outside rearview mirror
Electric Type (if equipped)
To fold the outside rearview mirror, de‐
press the button.
To unfold it, depress the button again.
CAUTION
The electric type outside rearviewmirror operates even though the ig‐nition switch is in the OFF position.However, to prevent unnecessarybattery discharge, do not adjust themirrors longer than necessary whilethe engine is not running.
CAUTION
In case it is an electric type outsiderearview mirror, don’t fold it byhand. It could cause motor failure.
0:##
Manual type
To fold outside rearview mirror, grasp
the housing of mirror and then fold it toward the rear of the vehicle.
Features of your vehicle
4-44