warning KIA STONIC 2018 Manual PDF

Sliding the sunroof
To open the sunroof, push the sunroof
control lever backward.
To close the sunroof, push the sunroof control lever forward.
To open the sunroof automatically:
Pull the sunroof control lever backward
to the second detent position and then
release it. The sunroof will slide to the recommended open position (about
5 cm before the maximum slide open
position).
To stop the sunroof sliding at any point,
push the sunroof control lever momen‐ tarily.
To close the sunroof automatically:
Push the sunroof control lever forward
to the second detent position and then release it. The sunroof will automatical‐
ly close all the way.
To stop the sunroof sliding at any point,
push the sunroof control lever momen‐
tarily.
NOTICE
To reduce wind noise while driving, it
is recommended that you drive with
the sunroof slightly closed (stop the
sunroof about 5cm(2in.) before the
maximum slide open position).
WARNING
Make sure heads, other body partsor other objects are safely out of theway before closing the window toavoid injuries or vehicle damage.Objects less than 4 mm (0.16 inch) indiameter caught between the sun‐roof glass and the front windowchannel may not be detected by the
(Continued)
(Continued)
automatic reverse window and thewindow will not stop and reverse di‐rection.
Automatic reversal
If an object or part of the body is de‐
tected while the sunroof is closing au‐ tomatically, it will reverse the direction,
and then stop.
Features of your vehicle
4-34

The auto reverse function does not
work if a tiny obstacle is between the sliding glass and the sunroof sash. You
should always check that all passengers
and objects are away from the sunroof
before closing it.
WARNING
•Never try pinching any part ofyour body intentionally to activatethe Automatic reversal function.
•The Automatic reversal functionmay not work if something getscaught just before the sunrooffully closes.
Tilting the sunroof
To open the sunroof, push the sunroof
control lever upward until the sunroof moves to the desired position.
To close the sunroof, push the sunroof
lever forward until the sunroof moves
to the desired position.
WARNING
•Make sure heads, other body partsor other objects are safely out ofthe way before closing the sunroofto avoid injuries or vehicle damage.
(Continued)
(Continued)
•Never adjust the sunroof or sun‐shade while driving. This maycause loss of vehicle control re‐sulting in an accident.
•To avoid serious injury or death, donot extend your head, arms orbody outside the sunroof whiledriving.
CAUTION
•Periodically remove any dirt thatmay accumulate on the guide rail.
•If you try to open the sunroofwhen the temperature is belowfreezing or when the sunroof iscovered with snow or ice, the glassor the motor could be damaged.
•While using sunroof for a longtime, a dust between sunroof androof panel can make a noise.Open the sunroof and remove reg‐ularly the dust using clean cloth.
•The sunroof is made to slide to‐gether with sunshade. Do notleave the sunshade closed whilethe sunroof is open.

4-35
4
Features of your vehicle

STEERING WHEEL
Electric power steering
Power steering uses the motor to as‐sist you in steering the vehicle. If the
engine is off or if the power steering
system becomes inoperative, the vehi‐ cle may still be steered, but it will re‐
quire increased steering effort.
The motor driven power steering is
controlled by the power steering con‐ trol unit which senses the steering
wheel torque, steering wheel position
and vehicle speed to command the mo‐ tor.
The steering wheel becomes heavier as
the vehicle’s speed increases and be‐
comes lighter as the vehicle’s speed de‐ creases for better control of the steer‐
ing wheel.
Should you notice any change in the ef‐
fort required to steer during normal ve‐ hicle operation, have the system
checked by a professional workshop.
Kia recommends to visit an authorized Kia dealer/service partner.NOTICE
The following symptoms may occur
during normal vehicle operation:
•The EPS warning light does not il‐
luminate.
•The steering effort is high imme‐
diately after turning the ignition
switch on. This happens as the
system performs the EPS system
diagnostics. When the diagnostics
is completed, the steering wheel
will return to its normal condition.
•A click noise may be heard from
the EPS relay after the ignition
switch is turned to the ON or LOCK
position.
•Motor noise may be heard when
the vehicle is at a stop or at a low
driving speed.
(Continued)
(Continued)
•If the Electric Power Steering Sys‐
tem does not operate normally,
the warning light will illuminate on
the instrument cluster. The steer‐
ing wheel may become difficult to
control or operate abnormally. In
this case, have the system inspec‐
ted by a professional workshop.
Kia recommends to visit an au‐
thorized Kia dealer/service part‐
ner.
•The steering effort increases if
the steering wheel is rotated con‐
tinuously when the vehicle is not
in motion. However, after a few
minutes, it will return to its normal
conditions.
•When you operate the steering
wheel in low temperature, abnor‐
mal noise could occur. If tempera‐
ture rises, the noise will disappear.
This is a normal condition.
(Continued)

4-37
4
Features of your vehicle

(Continued)
•When the charging system warn‐
ing light comes on or the voltage is
low (When the alternator (or bat‐
tery) does not operate normally or
it malfunctions), the steering
wheel may get heavy and become
difficult to control operate abnor‐
mally.
Tilt & telescopic steering (if
equipped)
A tilt and telescopic steering wheel al‐
lows you to adjust the steering wheel before you drive.
You can also raise it to give your legs
more room when you exit and enter
the vehicle.
The steering wheel should be posi‐ tioned so that it is comfortable for you
to drive, while permitting you to see
the instrument panel warning lights and gauges.
WARNING
•Never adjust the angle of thesteering wheel while driving. Youmay lose steering control andcause severe personal injury,death or accidents.
•After adjusting, push the steeringwheel both up and down to be cer‐tain it is locked in position.
To change the steering wheel angle,
pull down the lock release lever (1), ad‐ just the steering wheel to the desired
angle (2) and height (3, if equipped),
then pull up the lock-release lever to lock the steering wheel in place. Be sure
to adjust the steering wheel to the de‐
sired position before driving.
Features of your vehicle
4-38

MIRRORS
Inside rearview mirror
Adjust the rearview mirror to center onthe view through the rear window.
Make this adjustment before you start
driving.
WARNING
nRear visibility
Do not place objects in the rear seator cargo area which would interferewith your vision through the rearwindow.
WARNING
Do not adjust the rearview mirrorwhile the vehicle is moving. Thiscould result in loss of control, and anaccident which could cause death,serious injury or property damage.
WARNING
Do not modify the inside mirror anddo not install a wide mirror. It couldresult in injury, during an accident ordeployment of the air bag.
Day/night rearview mirror (if
equipped)
Make this adjustment before you start
driving and while the day/night lever is in the day position (1). Pull the day/night lever toward you (2)
to reduce the glare from the headlights
of the vehicles behind you during night driving.
Remember that you lose some rear‐
view clarity in the night position.
❈ (1) : Day, (2) : Night

4-41
4
Features of your vehicle

Electrochromic mirror (ECM) (if
equipped)
The electric rearview mirror automati‐
cally controls the glare from the head‐ lights of the vehicles behind you in
nighttime or low light driving condi‐
tions. The sensor (3) mounted in the mirror senses the light level around the
vehicle, and automatically controls the
headlight glare from the vehicles be‐ hind you.
When the engine is running, the glare is
automatically controlled by the sensor
mounted in the rearview mirror. Whenever the shift lever is shifted into
reverse (R), the mirror will automatical‐
ly go to the brightest setting in order
to improve the drivers view behind the vehicle.
CAUTION
When cleaning the mirror, use a pa‐per towel or similar material damp‐ened with glass cleaner. Do notspray glass cleaner directly on themirror. It may cause the liquid clean‐er to enter the mirror housing.
To operate the electric rearview mirror:
• The mirror defaults to the ON posi‐ tion whenever the ignition switch is
turned on.
• Press the ON/OFF button (1) to turn the automatic dimming function off.
The mirror indicator light (2) will turn
off.
Press the ON/OFF button (1) to turn
the automatic dimming function on.
The mirror indicator light (2) will illu‐ minate.
Outside rearview mirror
Be sure to adjust mirror angles before
driving. Your vehicle is equipped with both left-
hand and right-hand outside rearview
mirrors. The mirrors can be adjusted
remotely with the remote switch. The mirror heads can be folded back to pre‐
vent damage during an automatic car
wash or when passing in a narrow street.
WARNING
nRearview mirrors
•The outside rearview mirror isconvex. Objects seen in the mirrorare closer than they appear.
•Use your interior rearview mirroror direct observation to determinethe actual distance of followingvehicles when changing lanes.
CAUTION
Do not scrape ice off the mirror face;this may damage the surface of theglass. If ice should restrict move‐ment of the mirror, do not force themirror for adjustment. To remove
(Continued)
Features of your vehicle
4-42

(Continued)
ice, use a deicer spray, or a spongeor soft cloth with very warm water.
CAUTION
If the mirror is jammed with ice, donot adjust the mirror by force. Usean approved spray de-icer (not radi‐ator antifreeze) to release the fro‐zen mechanism or move the vehicleto a warm place and allow the ice tomelt.
WARNING
Do not adjust or fold the outsiderearview mirrors while the vehicle ismoving. This could result in loss ofcontrol, and an accident which couldcause death, serious injury or prop‐erty damage.
Remote control
Electric type
The electric remote control mirror
switch allows you to adjust the position of the left and right outside rearview
mirrors. To adjust the position of either
mirror, the ignition switch should be in the ACC position.
To adjust the position of either mirror,
press the R or L button (1) to select the
right side mirror or the left side mirror, then press a corresponding point (
)
on the mirror adjustment control to po‐
sition the selected mirror up, down, left or right. After adjustment, press the R or L but‐
ton again to prevent the inadvertent
adjustment.
CAUTION
•The mirrors stop moving whenthey reach the maximum adjustingangles, but the motor continues tooperate while the switch is press‐ed. Do not press the switch longerthan necessary, the motor may bedamaged.
•Do not attempt to adjust the out‐side rearview mirror by hand. Do‐ing so may damage the parts.

4-43
4
Features of your vehicle

INSTRUMENT CLUSTER
0:#0:#$
5ZQF
"
5ZQF
#
1. Tachometer
2. Speedometer
3. Engine coolant temperature gauge
4. Fuel gauge
5. Warning and indicator lights
6. LCD display
❈ The actual cluster in the vehicle
may differ from the illustration.
For more details, refer to L

0:#0:#
5ZQF
$
5ZQF
%
1. Tachometer
2. Speedometer
3. Engine coolant temperature gauge
4. Fuel gauge
5. Warning and indicator lights
6. LCD display
❈ The actual cluster in the vehicle
may differ from the illustration.
For more details, refer to L

WARNING
Never adjust the instrument clusterwhile driving. This could result in lossof control and lead to an accidentthat may cause death, serious in‐jury, or property damage.
The brightness of the instrument panel
illumination is changed by pressing the illumination control button (L