buttons Lancia Ypsilon 2012 Owner handbook (in English)

ANTI-PINCH SAFETY DEVICE
The sun roof has an anti-pinch safety system
capable of detecting the presence of an obstacle
whilst the roof is closing: if this happens, the
system intervenes and the movement of the glass
is immediately reversed.
EMERGENCY OPERATION
If the control buttons fail to operate, the sun roof
can be moved manually proceeding as described
below:
❒remove the protective cap located on the
internal lining, between the two sun blinds fig.
54;
❒take the Allen key provided and located in the
tool box in the luggage compartment or,
depending on the version, inside the glove
compartment;❒introduce the key provided into housing A fig.
54 and turn it clockwise to open the roof or
anticlockwise to close the roof.
INITIALISATION PROCEDURE
Following an automatic motion malfunction while
opening/closing or an emergency manoeuvre
(see description in the previous paragraph), the
automatic operation of the sun roof must be
initialised again.
Proceed as follows:
❒Press button B in closed position;
❒hold down button B: after approximately 10
seconds the roof moves jerkily to closing
position. Once the operation has ended (roof
closed) release button B;
❒turn the ignition key to STOP and keep it there
for 10 seconds;
❒turn the ignition key to MAR position;
❒Press button B in closed position;
❒hold down button B until the roof is completely
closed: the initialisation procedure has ended;
❒press button B again within 3 seconds from the
conclusion of the initialisation procedure;
fig. 54
L0F0299
74GETTING TO
KNOW YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

ELECTRIC WINDOWSThese operate when the ignition key is turned to
MAR and for about three minutes after turning
the key to STOP or removing it if one of the front
doors is open.
The control buttons are located in the door panels
(for versions/markets, where provided) (the driver
side door panel can be used to operate all the
windows).
An anti-crush device operates when the front and
rear windows are raised (for versions/markets,
where provided).
WARNING
Improper use of the electric windows
can be dangerous. Before and during
operation, always check that passengers are
not exposed to the risk of being injured
either directly by the moving windows or
through objects getting caught or struck by
them. When leaving the car, always remove
the ignition key to avoid the risk of injury
of people still on board due to accidental
operation of the electric windows.CONTROLS
Driver side front door
A fig. 57: opening/closing front left window;
"continuous automatic" operation during window
opening/closing stage;
B: opening/closing front right window;
"continuous automatic" operation during window
opening/closing stage (for versions/markets,
where provided);
C: enabling/disabling of rear door electric window
controls
D: opening/closing rear left window (for
versions/markets, where provided); "continuous
automatic" operation during window opening/
closing stage
fig. 57
L0F0162
78GETTING TO
KNOW YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

E: opening/closing rear right window (for
versions/markets, where provided); "continuous
automatic" operation during window opening/
closing stage.
Push the buttons to open/close the desired
window. When one of the two buttons is pressed
briefly, the window moves in stages; if the button
is held down, "continuous automatic" operation
is activated both for closing and opening.
If the control button is pressed again, the window
will stop in the desired position. If the button is
held down for several seconds, the window raises
or lowers automatically (only with ignition key
in MAR position).
Front and rear passenger doors
(for versions/markets, where provided)
On the passenger side front door control panel,
and on some versions also on the rear doors,
buttons are provided to control the associated
windows.
Anti-crush safety device
The car is equipped with an anti-crush function
for the raising of the front and rear windows. This
safety system detects the presence of an obstacle
during the window closing travel and intervenes
by stopping and reversing the window travel,
depending on its position.
This device is also useful if the windows are
activated accidentally by children on board the
car.The anti-crush safety function is active both
during the manual and the automatic operation of
the window. When the anti-crush system is
activated the window travel is immediately
interrupted and then reversed. The window
cannot be operated in any way during this
operation.
IMPORTANT If the anti-crush protection
intervenes 3 consecutive times within 1 minute or
is faulty, the automatic closing operation of the
window is inhibited, only allowing it in steps
of half a second; the button is released for the
subsequent manoeuvre. In order to restore the
correct operation of the system, the relevant
window must be lowered.
IMPORTANT With ignition key at STOP or
removed, the electric windows remain active for
about 3 minutes and are deactivated when a door
is opened.
IMPORTANT Where the anti-crush function is
present, pressing button
on the remote control
for more than 2 seconds opens the windows for as
long as the button is pressed. Pressing the
button for more than 2 seconds closes the
windows.
The system conforms to the 2000/4/EC
standard concerning the safety of
passengers leaning out of the passenger
compartment.
79GETTING TO
KNOW YOUR CARSAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

❒close all the doors and the luggage
compartment;
❒Press the
button on the remote control;
❒press thebutton on the remote control.
EXTENDING THE LUGGAGE
COMPARTMENT
See the descriptions in “Removing the parcel
shelf” and “Folding back the seats” paragraphs
for how to expand the luggage compartment.
Removing the parcel shelf
Proceed as follows:
❒free the ends of the two parcel shelf mounting
links A fig. 61 by removing the eyelets B from
the mounting pins;❒free the pins C fig. 62 outside the shelf then
remove the parcel shelf D by sliding it outwards;
❒after removal, the parcel shelf can be loaded
sideways into the luggage compartment or
placed between the front seat backrests and the
folded-back rear seat cushions (with the luggage
compartment completely expanded).
Folding back the seats
Proceed as follows:
❒raise the head restraints to the maximum
height, press both buttons A fig. 63 and B to the
side of the two supports, then remove the head
restraints by sliding them upwards;
❒move the seat belts to the side, making sure that
they are correctly extended and not twisted;
❒press release button A fig. 64 to fold the left or
the right backrest section then lay the backrest
on the cushion.
fig. 61
L0F0194
C
D
fig. 62
L0F0195
82GETTING TO
KNOW YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

HEADLIGHTSLIGHT BEAM DIRECTION
The correct alignment of the headlights is
important for the comfort and safety of not only
the driver but all other road users. This is also
covered by a specific rule of the highway code.
The headlights must be correctly aimed to
guarantee the best visibility conditions for all
drivers while travelling with headlights on.
Contact a Lancia Dealership to have the
headlights properly adjusted.
Check beam alignment every time the load or its
distribution changes.
IMPORTANT When the gas discharge (Xenon)
headlamps (for versions/markets, where provided)
are switched on, normally parabolas and light
beam move vertically for about 2 seconds until
headlamp alignment has stabilised.
HEADLAMP ALIGNMENT CORRECTOR
This device works with the ignition key in the
MAR position and the dipped headlights on.
Headlight alignment adjustment
Press the
or
buttons to adjust fig. 69. The
instrument panel display shows the position in
relation to the adjustment set.
Position 0 - one or two persons on the front seats
Position1-4personsPosition2-4persons + load in the luggage
compartment
Position 3 - driver + maximum admissible load all
stored in the luggage compartment.
IMPORTANT Check alignment every time the
load carried changes.
IMPORTANT If the car is equipped with (Xenon)
gas discharge headlights, the headlight alignment
is controlled electronically, as a consequence the
and
buttons are not present.
FOG LIGHT ALIGNMENT
(for versions/markets, where provided)
Contact a Lancia Dealership to have the
headlights properly adjusted.
fig. 69
L0F0224
87GETTING TO
KNOW YOUR CARSAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX

TABLE OF CONTENTS
INTRODUCTION.....................................................255
TIPS ......................................................................255
TECHNICAL CHARACTERISTICS .......................258
Speakers for Basic Audio specification....................258
Speakers for 360° HI-FI MUSIC specification ........258
QUICK GUIDE ........................................................260
General functions ...................................................261
Radio functions ......................................................262
CD functions ..........................................................263
Media Player functions (only withBlue&Me™) ...264
STEERING WHEEL CONTROLS ..........................265
INTRODUCTION.....................................................267
FUNCTIONS AND ADJUSTMENTS ........................269
SWITCHING ON THE CAR RADIO ......................269
SWITCHING OFF THE CAR RADIO.....................270
SELECTING THE RADIO FUNCTIONS ...............270
SELECTING CD FUNCTION ................................270
AUDIO SOURCE MEMORY FUNCTION ...............270
VOLUME ADJUSTMENT ......................................270
MUTE/PAUSE FUNCTION....................................271
AUDIO SETTINGS ................................................271
TONE ADJUSTMENT (bass/treble) .......................272
BALANCE ADJUSTMENT.....................................272
FADER ADJUSTMENT ..........................................273
LOUDNESS FUNCTION .......................................273
EQ FUNCTION .....................................................273
USER EQ SETTINGS FUNCTION ........................274
MENU....................................................................275
AF SWITCHING function .....................................276
TRAFFIC INFORMATION function ......................277REGIONAL MODE function .................................278
MP3 DISPLAY function ........................................279
SPEED VOLUME function ...................................280
RADIO ON VOLUME function .............................281
SPEECH VOLUME function .................................282
AUX OFFSET function .........................................282
RADIO OFF function ............................................282
SYSTEM RESET function......................................283
PHONE SET-UP ....................................................283
ANTI-THEFT PROTECTION ................................283
RADIO (TUNER) .....................................................286
INTRODUCTION...................................................286
FREQUENCY BAND SELECTION ........................286
PRESET BUTTONS...............................................287
STORING THE LAST STATION LISTENED TO...287
AUTOMATIC TUNING ..........................................287
MANUAL TUNING ................................................287
AUTOSTORE FUNCTION ....................................288
EMERGENCY ALARM RECEPTION ....................289
EON FUNCTION (Enhanced Other Network) ........289
STEREOPHONIC BROADCASTERS .....................289
CD PLAYER ............................................................290
INTRODUCTION...................................................290
SELECTING THE CD PLAYER ............................290
LOADING/EJECTING A CD..................................290
DISPLAY INFORMATION .....................................291
TRACK SELECTION (forward/back) ....................291
TRACK FAST FORWARD/REWIND ......................292
PAUSE FUNCTION ...............................................292
CD MP3 PLAYER ....................................................293
253
SOUND-SYSTEM

General functionsButton Functions Method
On short button press
Off short button press
Volume adjustment LH/RH knob rotation
FM ASFM1, FM2, FM Autostore radio source
selectionshort cyclical button press
AMMW1, MW2 radio source selection short cyclical button press
MEDIACD/Media Player source selection (only with
Blue&Me
™
) / AUX (only with
Blue&Me
™
, for versions/markets, where
provided)short cyclical button press
Volume activation/deactivation
(Mute/Pause)Short button pressAudio adjustments: low tones (BASS), high
tones (TREBLE), RH / LH balance
(BALANCE), front / rear balance (FADER)Menu activation: short button press
Selection of type of adjustment: pressing
or
buttons
Adjustment of values: pressing
or
buttons
MENUAdvanced functions adjustmentMenu activation: short button press
Selection of type of adjustment: pressing
or
buttons
Adjustment of values: pressing
or
buttons.
261
SOUND-SYSTEM

Radio functionsButton Functions Method
Radio station search:
- Automatic search
- Manual searchAutomatic search: pressing
or
buttons
(long press for fast forward)
Manual search: pressing
or
buttons
(long press for fast forward)
123456Store current radio stationLong press on keys for preset/memory from
1to6
Stored station recallBrief press on keys for preset/memory from
1to6
262
SOUND-SYSTEM

CD functionsButton Functions Method
CD ejection Short button pressPlay previous/next track Short press of
or
buttons
Fast forwarding/rewinding CD track Long pressing of
or
buttons
Playing previous/next folder (for CD-MP3) Short press of
or
buttons
263
SOUND-SYSTEM

MUTE/PAUSE FUNCTION
(volume reset)
Press the
button briefly to activate the Mute
function. The volume will gradually decrease and
the words "RADIO Mute" (in radio mode) or
"PAUSE" (in CD mode) will appear on the
display.
Press thebutton again to deactivate the Mute
function. The volume will gradually increase until
it reaches the level previously set.
When the volume level is changed using the
dedicated controls, the Mute function is
deactivated and the volume is adjusted to the new
level selected.
With the Mute function activated, it will be
ignored when there is an incoming traffic alert (if
the TA function is activated), or if an emergency
alarm is received. The function will be reactivated
when the alert is over.AUDIO SETTINGS
The functions in the audio menu differ according
to the activated source: AM/FM/CD/Media Player
(only withBlue&Me™) /AUX (only with
Blue&Me™, for versions/markets, where
provided).
Press the
button briefly to change the Audio
functions.
After thebutton is first pressed, the display will
show the bass level value for the source activated
at that time (e.g. in FM mode the display will
show the wording "FM Bass +2").
Use theor
buttons to scroll the menu
functions. To change the setting of the function
selected use the
or
buttons. The current status
of the selected function appears on the display.
271
SOUND-SYSTEM