ELECTRICAL
11
REPAIR REV: 05/99 Refit
12.Fit new fuse.
13.Position instrument panel to fascia cowl area
and reconnect immobiliser warning light leads,
gearbox oil temperature lead, heated rear screen
leads, alarm LED plug lead, main harness
multi-plugs and speedometer cable,
14.Secure instrument panel to fascia cowl with 4
screws
See INSTRUMENTS, Repair,
Instrument panel.
15.Fit steering wheelSee STEERING, Repair,
Steering wheel.
16.Reconnect battery negative lead.
17.Fit battery access cover.
18.Fit LH front seat cushion.GENERATOR
Service repair no - 86.10.02
Remove
1.Disconnect battery.
2.Remove drive belt
See Auxiliary drive belt.
3.Unscrew 3 fixings, remove heat shield from rear
of generator, and disconnect electrical leads
from generator.
4.Remove generator bottom fixing bolt.
5.Remove long through bolt from top fixing and lift
generator from engine.
Refit
6.Fit generator to engine mounting bracket and
secure with top and bottom fixing bolts.
7.Connect electrical leads.
8.Fit heat shield.
9.Fit drive belt
See Auxiliary drive belt; Refit.
10.Reconnect battery.
ELECTRICAL
19
REPAIR INSTRUMENT ILLUMINATION - BULB RENEWAL
Service repair no - 86.45.49 - Speedometer
Service repair no - 86.45.51 - Temperature gauge
Service repair no - 86.45.52 - Fuel gauge
Remove
1.Disconnect battery.
2.Remove 4 screws retaining instrument panel.
3.Ease panel forward and disconnect
speedometer cable to improve access to
illumination bulbs.
4.Twist bulb holder and pull from socket.
5.Pull bulb from holder.
Refit
6.Fit new bulb and refit holder.
7.Reconnect speedometer cable and fit instrument
panel.
8.Reconnect battery.STARTER SWITCH
Service repair no - 86.65.03
Remove
1.Remove instrument panel
See INSTRUMENTS,
Repair, Instrument panel.
2.Remove steering column nacelleSee
STEERING, Repair, Steering column nacelle.
3.Note position of harness leads on back of starter
switch and disconnect lukars. If fitted, remove
alarm system passive coil from switch
See
Passive coil.
4.Remove single screw and withdraw starter
switch from steering column lock.
Refit
5.Fit new switch in steering column lock.
6.Connect harness leads to starter switch.
7.If applicable, fit alarm system passive coil
See
Passive coil.
8.Fit steering column nacelleSee STEERING,
Repair, Steering column nacelle.
9.Fit instrument panelSee INSTRUMENTS,
Repair, Instrument panel.
