airbag off LAND ROVER DISCOVERY 1995 Service Repair Manual
[x] Cancel search | Manufacturer: LAND ROVER, Model Year: 1995, Model line: DISCOVERY, Model: LAND ROVER DISCOVERY 1995Pages: 976, PDF Size: 14.57 MB
Page 339 of 976
19FUEL SYSTEM
2
REPAIR ENGAGEMENT (ON/OFF) SWITCH
Service repair no - 19.75.30
Switch Replacement
Remove
1.Disconnect battery negative lead.
2.Carefully release auxiliary switch panel from
fascia.
3.Disconnect multiplug from switch.
4.Depress retaining lugs on switch, remove switch
from panel.
Bulb replacement
5.Position switch to facilitate removal of bulb.
6.Rotate bulb holder 90°and withdraw it from
switch.CRUISE CONTROL SWITCH
Service repair no - 19.75.36
Remove
1.Disconnect battery negative lead.
2. Models fitted with airbags:Remove driver's
airbag module.
See SUPPLEMENTARY
RESTRAINT SYSTEM, Repair, Driver's
Airbag Module
3. Models without airbags:Turn steering wheel
through 90°. Remove 2 Torx screws securing
pad to steering wheel and remove steering
wheel pad.
4.Disconnect cruise control switch multiplug from
main harness.
Page 638 of 976
75SUPPLEMENTARY RESTRAINT SYSTEM
2
DESCRIPTION AND OPERATION OPERATION
The airbag supplementary restraint system (SRS) is a
safety device which, when used in conjunction with
the seat belt, is designed to protect the driver and
front passenger.
Two different SRS systems are fitted to Discovery.
The Distributed SRS which has two crash sensors
located in the engine compartment on the chassis
longitudinals and the Single Point Sensing (SPS) SRS
which has a single crash sensor located in the Airbag
diagnostic control unit.
The change from distributed SRS to SPS SRS
occurred at VINs198222and528977.
Distributed SRS
In the event of a frontal impact, when the airbag
diagnostic control unit and one of the airbag crash
sensors senses the impact, the diagnostic control unit
fires igniters. This in turn ignites tablets of sodium
azide which generate a large amount of Nitrogen gas
leading to airbag inflation in approximately 30
milli-seconds.SPS SRS
In the event of a frontal impact, when the airbag
diagnostic control unit senses the impact, the
diagnostic control unit fires igniters. This in turn ignites
tablets of sodium azide which generate a large
amount of Nitrogen gas leading to airbag inflation in
approximately 30 milli-seconds.
All Models
When fully deployed the airbag offers additional
protection to the front seat occupant. As an occupant
moves into the airbag it immediately discharges the
gas to provide progressive occupant deceleration and
reduce risk of injuries. The whole process is
completed in approximately 0.3 seconds.
WARNING: All the airbag system
components, including the wiring harness,
MUST be renewed after the airbags have
deployed.
Page 641 of 976
SUPPLEMENTARY RESTRAINT SYSTEM
5
DESCRIPTION AND OPERATION
7.Do not use electrical test equipment on the
airbag harness or connectors. Tampering with or
disconnecting the harness could result in
accidental firing of the airbag or make the
system inoperative, which may result in serious
injury.
8. An airbag system fault can only be
diagnosed using TestBook.
9.The airbag module contains Sodium Azide which
is poisonous and extremely flammable. Contact
with water, acid or heavy metals may produce
harmful or explosive compounds. Do not
dismantle, incinerate or bring into contact with
electricity.VEHICLE RECOVERY
Towing - airbag not deployed
Normal towing procedures are unlikely to cause an
airbag to deploy. However, as a precaution switch the
ignition off and then disconnect both battery leads.
Disconnect the negative '-' lead first.
Towing - airbag deployed
Once the driver's airbag has been deployed the
vehicle must have a front suspended tow. However,
as a precaution switch the ignition off and then
disconnect both battery leads. Disconnect the
negative '-' lead first.
Page 646 of 976
SUPPLEMENTARY RESTRAINT SYSTEM
1
REPAIR SYSTEM PRECAUTIONS
CAUTION: Before and during any removal
operations within the SRS section, note
routing and position of all harnesses to aid
correct refitting and to avoid accidentally trapping
cables.
CAUTION: During refitting of any item
within the SRS section, always ensure
connectors are fully engaged and latched
before proceeding to the next stage of the
operation.DRIVER'S AIRBAG MODULE
Service repair no - 76.74.01
WARNING: All the airbag system
components, including the wiring harness,
MUST be renewed after the airbags have
deployed.
Remove
1.Turn steering wheel 90Ê from horizontal.
2.Switch off ignition.
3.Disconnect battery negative '-' and then the
positive '+' lead.
CAUTION: Always disconnect both leads.
4.Release 2 turnbuckles and remove dash lower
panel.
Page 654 of 976
SUPPLEMENTARY RESTRAINT SYSTEM
9
REPAIR PASSENGER'S AIRBAG MODULE
Service repair no - 76.74.02
WARNING: All the airbag system
components, including the wiring harness,
MUST be renewed after the airbags have
deployed.
Remove
1.Switch off ignition.
2.Disconnect battery negative lead and then
positive lead.
3.Open glovebox and disconnect harness
connector from airbag module.
4.Use special socket and long extension, remove
2 torx head screws securing front of airbag
module to fascia panel.
5.Use special socket, remove 2 torx head screws
securing rear of airbag module to fascia panel.
6.Release airbag module from fascia panel.
CAUTION: Do not allow the airbag module
to hang by the airbag harness.
7.Carefully and without pulling on connector
remove airbag module.
CAUTION: Store the airbag module in
accordance with the storage procedures
described in Description and Operation.
NOTE: If airbag module is to be replaced
the serial number must be recorded in the
vehicle service record.
Refit
8.Reverse removal procedure.
9.Tighten airbag module securing screws to
8Nm
(6 lbf ft).
CAUTION: Take care not to cross thread
screws.
10.Check Supplementary Restraint System using
Testbook.
Page 821 of 976
ELECTRICAL
1
REPAIR FUSE BOX - INTERIOR
Right Hand Drive shown
The interior fusebox is fitted below the steering column, behind the trim panel. It comprises of three integral units.
'A'Main fusebox,'B'Satellite 2,'C'Satellite 1.
A label in the fusebox cover shows the circuits protected, the fuse rating and their locations. Access is by
releasing the fixing screws and lowering the panel.
'A' Main fusebox
1. Stop lights, direction indicators
2. LH side light
3. Radio/cassette/CD player
4. RH headlight main beam
5. LH headlight main beam
6. Cigar lighter
7. Airbag SRS
8. RH side lights
9. Rear fog guard lights
10. RH headlight dipped beam
11. LH headlight dipped beam
12. Multi-function unit
13. Ignition feed for Multi-function unit
14. Instruments, reversing lights
15. Air conditioning, windows
16. Washers & wipers - front
17. Starter, glow plug
18. Wash/wipe - rear, mirrors, cruise control
'B' Satellite 2
1. Electric windows - front
2. Electric windows - rear
3. Anti-lock braking
4. Central door locking
5. Electric sun roof
6. Trailer lights
'C' Satellite 1
1. Anti-theft alarm
2. Headlight washers
3. Engine management
4. Anti-lock brakes
5. Anti-theft alarm
6. Rear air conditioning, heater
'D' Spare fuses (5 off)