wipers Lexus CT200h 2012 (in English) User Guide

240
2-3. Operating the lights and windshield wipers
CT200h_OM_OM76067E_(EE)
Fog lights can be used when
Vehicles with a rear fog light only
The front position lights are turned on.
Vehicles with a front and rear fog light
Front fog lights: The front position lights are turned on.
Rear fog lights: The front fog lights are turned on.
NOTICE
To prevent 12-volt battery discharge
Do not leave the lights on longer than necessary when the hybrid system is
off.
Front and rear fog light switch (if equipped)
Turns the front and
rear fog lights off
Turns the front fog
lights on
Turns both front and
rear fog lights on
Releasing the switch ring
returns it to .
Operating the switch ring
again turns only the rear fog
lights off.

241
2-3. Operating the lights and windshield wipers
2
When driving
CT200h_OM_OM76067E_(EE)
Windshield wipers and washer
Intermittent windshield wipers with interval adjuster (if
equipped)
The wiper operation is selected by moving the lever as follows.
When intermittent windshield wiper operation is selected, wiper
intervals can be also adjusted.
Intermittent windshield
wiper operation
Low speed windshield
wiper operation
High speed windshield
wiper operation
Temporary operation
Increases the intermittent
windshield wiper fre-
quency
Decreases the intermittent
windshield wiper fre-
quency

242
2-3. Operating the lights and windshield wipers
CT200h_OM_OM76067E_(EE)
Washer/wiper dual opera-
tion
The wipers will automati-
cally operate a couple of
times after the washer
squirts.

243
2-3. Operating the lights and windshield wipers
2
When driving
CT200h_OM_OM76067E_(EE)
Rain-sensing windshield wipers (if equipped)
When “AUTO” is selected, the wipers will operate automati-
cally when the sensor detects falling rain. The system automati-
cally adjusts wiper timing in accordance with rain volume and
vehicle speed.
When “AUTO” is selected, the sensor sensitivity can be adjusted
as follows by turning the switch ring:
Rain-sensing wiper opera-
tion
Low speed wiper operation
High speed wiper opera-
tion
Temporary operation

244
2-3. Operating the lights and windshield wipers
CT200h_OM_OM76067E_(EE)
The windshield wipers and washer can be operated when
The “POWER” switch is in ON mode.
Increases the sensitivity
Decreases the sensitivity
Washer/wiper dual opera-
tion
The wipers will automati-
cally operate a couple of
times after the washer
squirts.

245
2-3. Operating the lights and windshield wipers
2
When driving
CT200h_OM_OM76067E_(EE)
Raindrop sensor (vehicles with rain-sensing windshield wipers)
If the wiper switch is turned to the “AUTO” position while the
“POWER” switch is in ON mode, the wipers will operate once to show
that AUTO mode is activated.
If the temperature of the raindrop sensor is 90 C (194 F) or higher, or -
15 C (5 F) or lower, automatic operation may not occur. In this case,
operate the wipers in any mode other than “AUTO”.
If no windshield washer fluid sprays
Check that the washer nozzles are not blocked if there is washer fluid in the
washer fluid tank.
CAUTION
Caution regarding the use of windshield wipers in “AUTO” mode (vehicles
with rain-sensing windshield wipers)
The windshield wipers may operate unexpectedly if the sensor is touched or
the windshield is subject to vibration in “AUTO” mode. Take care that your
fingers etc. do not become caught in the windshield wipers.
The raindrop sensor judges the amount
of raindrops.
An optical sensor is adopted. It may not
operate properly when sunlight from
the rising or setting of the sun intermit-
tently strikes the windshield, or if bugs
etc. are present on the windshield.

246
2-3. Operating the lights and windshield wipers
CT200h_OM_OM76067E_(EE)
NOTICE
When the windshield is dry
Do not use the wipers, as they may damage the windshield.
When the washer fluid tank is empty
Do not operate the switch continually as the washer fluid pump may over-
heat.
When a nozzle becomes blocked
In this case, contact any authorized Lexus dealer or repairer, or another duly
qualified and equipped professional.
Do not try to clear it with a pin or other object. The nozzle will be damaged.
To prevent 12-volt battery discharge
Do not leave the wipers on longer than necessary when the hybrid system is
off.

247
2-3. Operating the lights and windshield wipers
2
When driving
CT200h_OM_OM76067E_(EE)
Rear window wiper and washer
: If equipped
The rear window wiper and washer can be operated when
The “POWER” switch is in ON mode.
The wiper operation is selected by moving the lever as follows:
Intermittent window wiper
operation
Normal window wiper
operation
Washer/wiper dual opera-
tion
Washer/wiper dual opera-
tion

248
2-3. Operating the lights and windshield wipers
CT200h_OM_OM76067E_(EE)
NOTICE
When the rear window is dry
Do not use the wiper, as it may damage the rear window.
When the washer fluid tank is empty
Do not operate the switch continually as the washer fluid pump may over-
heat.

249
2-3. Operating the lights and windshield wipers
2
When driving
CT200h_OM_OM76067E_(EE)
Headlight cleaner switch
: If equipped
The headlight cleaners can be operated when
The “POWER” switch is in ON mode and the headlight switch is turned on.
Windshield washer linked operation
Only for the first time when the windshield washer is operated with the
“POWER” switch in ON mode and the headlights on, the headlight cleaners
will operate once.
(P. 241)
NOTICE
When the washer fluid tank is empty
Do not press the switch continually as the washer fluid pump may overheat.
Washer fluid can be sprayed on the headlights.
Press the switch to clean the
headlights.