back door Lexus CT200h 2013 (in English) User Guide
[x] Cancel search | Manufacturer: LEXUS, Model Year: 2013, Model line: CT200h, Model: Lexus CT200h 2013Pages: 688
Page 139 of 688
1393-2. Opening, closing and locking the doors
3
Operation of each component
CT200h_OM_OM76102E_(EE)
Raise the back door while pushing
up the back door opener switch.
Lower the back door using the back
door handle, and make sure to push
the back door down from the out-
side to close it.
Luggage compartment light
The luggage compartment light turns on when the back door is opened with the
luggage compartment light switch on.
Opening the back door from outside the vehicle
When closing the back door
Off
On
When the power switch is turned off, the
light will go off automatically after 20
minutes.1
2
Page 140 of 688
1403-2. Opening, closing and locking the doors
CT200h_OM_OM76102E_(EE)
If the back door opener is inoperative
The back door can be unlocked from the inside.
Lift the center deck board and remove the
cover (if equipped), and then push up the
lever in the hole.
WA R N I N G
Caution while driving
Keep the back door closed while driving.
If the back door is left open, it may hit near-by objects while driving or lug-
gage may be unexpectedly thrown out, causing an accident.
In addition, exhaust gases may enter the vehicle, causing death or a serious
health hazard. Make sure to close the back door before driving.
Before driving the vehicle, make sure that the back door is fully closed. If the
back door is not fully closed, it may open unexpectedly while driving, causing
an accident.
Never let anyone sit in the luggage compartment. In the event of sudden brak-
ing, sudden swerving or a collision, they are susceptible to death or serious
injury.
When children are in the vehicle
Observe the following precautions.
Failure to do so may result in death or serious injury.
Do not allow children to play in the luggage compartment.
If a child is accidentally locked in the luggage compartment, they could have
heat exhaustion or other injuries.
Do not allow a child to open or close the back door.
Doing so may cause the back door to move unexpectedly, or cause the child’s
hands, head, or neck to be caught by the closing back door.
Page 141 of 688
1413-2. Opening, closing and locking the doors
3
Operation of each component
CT200h_OM_OM76102E_(EE)
WA R N I N G
Operating the back door
Observe the following precautions.
Failure to do so may cause parts of the body to be caught, resulting in death or
serious injury.
Remove any heavy loads, such as snow and ice, from the back door before
opening it. Failure to do so may cause the back door to suddenly shut again
after it is opened.
When opening or closing the back door, thoroughly check to make sure the
surrounding area is safe.
If anyone is in the vicinity, make sure they are safe and let them know that the
back door is about to open or close.
Use caution when opening or closing the back door in windy weather as it
may move abruptly in strong wind.
Do not pull on the back door damper stay to close the back door, and do not
hang on the back door damper stay.
Doing so may cause hands to be caught or the back door damper stay to break,
causing an accident.
If a bicycle carrier or similar heavy object is attached to the back door, it may
suddenly shut again after being opened, causing someone’s hands, head or
neck to be caught and injured. When installing an accessory part to the back
door, using a genuine Lexus part is recommended.
The back door may suddenly shut if it is
not opened fully. It is more difficult to
open or close the back door on an incline
than on a level surface, so beware of the
back door unexpectedly opening or clos-
ing by itself. Make sure that the back door
is fully open and secure before using the
luggage compartment.
When closing the back door, take extra
care to prevent your fingers etc. from
being caught.
When closing the back door, make sure to
press it lightly on its outer surface. If the
back door handle is used to fully close the
back door, it may result in hands or arms
being caught.
Page 142 of 688
1423-2. Opening, closing and locking the doors
CT200h_OM_OM76102E_(EE)
NOTICE
Back door damper stays
The back door is equipped with damper stays that hold the back door in place.
Observe the following precautions.
Failure to do so may cause damage to the back door damper stay, resulting in
malfunction.
Do not attach any foreign objects, such as
stickers, plastic sheets, or adhesives to the
damper stay rod.
Do not touch the damper stay rod with
gloves or other fabric items.
Do not attach any accessories other than
genuine Lexus parts to the back door.
Do not place your hand on the damper
stay or apply lateral forces to it.Damper
Page 143 of 688
143
3 3-2. Opening, closing and locking the doors
Operation of each component
CT200h_OM_OM76102E_(EE)
Smart entry & start system
Locks and unlocks the doors (vehicles with entry function) (P. 132)
Locks and unlocks the back door (vehicles with entry function) (P.
138)
Starts and stops the hybrid system (P. 196)
Antenna location
The following operations can be performed simply by carrying the elec-
tronic key (including the card key) on your person, for example in your
pocket. The driver should always carry the electronic key.
Antennas outside the cabin (vehicles with
entry function)
Antennas inside the cabin
Antenna inside the luggage compartment
Antenna outside the luggage compart-
ment
(vehicles with entry function)1
2
3
4
Page 144 of 688
1443-2. Opening, closing and locking the doors
CT200h_OM_OM76102E_(EE)
Effective range (areas within which the electronic key is detected)
Alarms and warning messages
A combination of exterior and interior alarms as well as warning messages
shown on the multi-information display are used to prevent theft of the vehicle
and accidents resulting from erroneous operation. Take appropriate measures in
response to any warning message on the multi-information display. (P. 575)
The following table describes circumstances and correction procedures when
only alarms are sounded.When locking or unlocking the doors
(vehicles with entry function)
The system can be operated when the
electronic key is within about 0.7 m
(2.3 ft.) of either of the outside front
and back door handles. (Only the doors
detecting the key can be operated.)
When starting the hybrid system or
changing power switch modes
The system can be operated when the
electronic key is inside the vehicle.
AlarmSituationCorrection procedure
Exterior alarm
sounds once for 5
seconds (vehicles
with entry func-
tion)
An attempt was made to lock
the vehicle while a door was
open.Close all of the doors
and lock the doors again.
Interior alarm pings
repeatedly
The power switch was turned
to ACCESSORY mode while
the driver’s door was open
(The driver’s door was
opened when the power
switch was in ACCESSORY
mode).
Turn the power switch
off and close the driver’s
door.
Page 146 of 688
1463-2. Opening, closing and locking the doors
CT200h_OM_OM76102E_(EE)
Note for the entry function
Even when the electronic key is within the effective range (detection areas), the
system may not operate properly in the following cases:
• The electronic key is too close to the window or outside door handle, near
the ground, or in a high place when the doors are locked or unlocked.
• The electronic key is near the ground or in a high place, or too close to the
rear bumper center when the back door is opened.
• The electronic key is on the instrument panel, luggage room, floor, or in the
door pockets or glove box when the hybrid system is started or power switch
modes are changed.
Do not leave the electronic key on top of the instrument panel or near the door
pockets when exiting the vehicle. Depending on the radio wave reception con-
ditions, it may be detected by the antenna outside the cabin and the door will
become lockable from the outside, possibly trapping the electronic key inside
the vehicle.
As long as the electronic key is within the effective range, the doors may be
locked or unlocked by anyone.
Even if the electronic key is not inside the vehicle, it may be possible to start
the hybrid system if the electronic key is near the window.
The doors may unlock if a large amount of water splashes on the door handle,
such as in the rain or in a car wash when the electronic key is within the effec-
tive range. (The door will automatically be locked after approximately 30 sec-
onds if the doors are not opened and closed.)
If the wireless remote control is used to lock the doors when the electronic key
is near the vehicle, there is a possibility that the door may not be unlocked by
the entry function. (Use the wireless remote control to unlock the doors.)
Touching the door lock sensor while wearing gloves may delay or prevent lock
operation. Remove the gloves and touch the lock sensor again.
If the door handle becomes wet while the electronic key is within the effective
range, the door may lock and unlock repeatedly. Place the key in a position 2 m
(6 ft.) or more separate from the vehicle while the vehicle is being washed.
(Take care to ensure that the key is not stolen.)
If the electronic key is inside the vehicle and a door handle becomes wet during
a car wash, a message may be shown on the multi-information display and a
buzzer will sound outside the vehicle. To turn off the alarm, lock all the doors.
The lock sensor may not work properly if it comes into contact with ice, snow,
mud, etc. Clean the lock sensor and attempt to operate it again, or use the lock
sensor on the lower part of the door handle.
Page 182 of 688
1823-5. Opening, closing the windows and moon roof
CT200h_OM_OM76102E_(EE)
The moon roof can be operated when
The power switch is in ON mode.
Operating the moon roof after turning the hybrid system off
The moon roof can be operated for approximately 45 seconds even after the
power switch is turned to ACCESSORY mode or turned off. It cannot, however,
be operated once either front door is opened.
Jam protection function
If an object is detected between the moon roof and the frame while the moon roof
is closing or tilting down, travel is stopped and the moon roof opens slightly.
Sunshade
The sunshade can be opened and closed manually. However, the sunshade will
open automatically to slightly before the fully open position when the moon roof
is opened.
When the moon roof does not close normally
Perform the following procedure:
If the moon roof closes but then re-opens slightly
Stop the vehicle.
Press and hold the “CLOSE” switch.
*1
The moon roof will close, reopen and pause for approximately 10 sec-
onds.
*2 Then it will close again and tilt down. Finally it will be adjusted
slightly and then stop.
Check to make sure that the moon roof completely stops and then release the
switch.
If the moon roof tilts down but then tilts back up
Stop the vehicle.
Press and hold the “DOWN” switch.
*1
The moon roof will close, reopen and pause for approximately 10 seconds in
the tilt up position.
*2 Then it will close again and tilt down. Finally it will be
adjusted slightly and then stop.
Check to make sure that the moon roof has completely stopped and then
release the switch.
*1: If the switch is released at the incorrect time, the procedure will have to be
performed again from the beginning.
*2: If the switch is released after the above mentioned 10 second pause, auto-
matic operation will be disabled. In that case, press and hold the “CLOSE”
or “DOWN” switch, and the moon roof will close, be adjusted slightly and
then stop. Check to make sure that the moon roof has completely stopped
and then release the switch.
If the moon roof does not fully close even after performing the above procedure
correctly, have the vehicle inspected by any authorized Lexus dealer or repairer,
or another duly qualified and equipped professional.
1
2
3
1
2
3
Page 214 of 688
2144-3. Operating the lights and wipers
CT200h_OM_OM76102E_(EE)
Daytime running light system
To make your vehicle more visible to other drivers, the front position lights turn
on automatically (at an increased intensity) whenever the hybrid system is started
and the parking brake is released. Daytime running lights are not designed for
use at night.
Headlight control sensor
Automatic light off system
When the light switch is in the or position: The headlights turn off
automatically if the power switch is turned to ACCESSORY mode or OFF.
When the light switch is in the position: The headlights and all lights turn
off automatically if the power switch is turned to ACCESSORY mode or OFF.
To turn the lights on again, turn the power switch to ON mode, or turn the light
switch off once and then back to the
or position.
Automatic headlight leveling system (if equipped)
The level of the headlights is automatically adjusted according to the number of
passengers and the loading condition of the vehicle to ensure that the headlights
do not interfere with other road users.
Light reminder buzzer (if equipped)
A buzzer sounds when the power switch is turned off or turned to ACCESSORY
mode and the driver’s door is opened while the lights are turned on. The sensor may not function properly if an
object is placed on the sensor, or anything
that blocks the sensor is affixed to the wind-
shield.
Doing so interferes with the sensor detect-
ing the level of ambient light and may cause
the automatic headlight system to malfunc-
tion.
Page 226 of 688
2264-4. Refueling
CT200h_OM_OM76102E_(EE)
Press the opener to open the fuel
filler door.
Turn the fuel tank cap slowly to
open and hang it on the back of
the fuel filler door.
When the fuel filler door cannot be opened by pressing the inside switch
Opening the fuel tank cap
1
2
Remove the cover inside the luggage com-
partment and pull the lever.