engine coolant Lexus ES300 1992 Gauges, Meters And Warning Lights

GAUGES, METERS AND WARNING LIGHTS
24
FUEL GAUGE
Low fuel level warning light
The gauge is displayed when the ignition switch is on and
indicates the approximate quantity of fuel remaining in the
tank.
It is a good idea to keep the tank over 1/4 full.
This fuel gauge has a non-return type needle. Therefore, the
needle will remain at the indicated fuel level position
regardless of the position of the ignition switch.
If the fuel level approaches “E” or the low fuel level warning light
comes on, the fuel tank should be filled as soon as possible.
Otherwise it may cause engine misfire and damage to the
catalytic converter.
See the inside back cover for fuel capacity and recommended
fuel selection.
ENGINE TEMPERATURE GAUGE
Overheating
Normal range
The gauge indicates the engine coolant temperature when
the ignition switch is on. The engine operating
temperature will vary with changes in weather and engine
load.
If the needle points to the red zone or higher, stop your vehicle
and allow the engine to cool.
Your vehicle may overheat during severe operating conditions,
such as:

Driving up a long hill on a hot day.

Reducing speed or stopping after high speed driving.

Idling for a long period with the air conditioner on in
stop-and-go traffic.

Towing a trailer.

Lugging the engine by driving slowly in a high gear.

GAUGES, METERS AND WARNING LIGHTS
25
NOTICE:

Do not remove the thermostat in the engine cooling
system as this may cause the engine to overheat. The
thermostat is designed to control the flow of coolant
to keep the temperature of the engine within the
specified operating range.

Do not continue driving with an overheated engine.
See “If your vehicle overheats” on page 126.
TACHOMETER
The tachometer indicates engine speed in thousands of
rpm (revolutions per minute). Use it while driving to select
correct shift points and to prevent engine overrevving.Driving with the engine running too fast causes excessive
engine wear and poor fuel economy. Remember, in most
cases the slower the engine speed, the greater the fuel
economy.
NOTICE:
Do not let the indicator needle get into the red zone. This
may cause severe engine damage.
ODOMETER AND TRIP METER
Odometer and trip meter
“ODO / TRIP” buttonResetting button
This meter displays the odometer and two trip meters. To
change the mode indication, push the “ODO/TRIP”
button. Each time you push the button, the mode changes
in order from the odometer to trip meter A to trip meter B,
then back to the odometer, etc.