check engine light Lexus ES300 1994 Driving Tips

DRIVING TIPS
122
BREAK-IN PERIOD
Drive gently and avoid high speeds.
You need not follow a break-in schedule with your new Lexus.
But following a few simple tips for the first 1600 km (1000 miles)
can add to the future economy and long life of your vehicle:

Do not drive over 88 km / h (55 mph).

Avoid overrevving. Maintain engine speed between 2000
and 4000 rpm.

Avoid full-throttle starts.

Try to avoid hard stops during the first 300 km (200 miles).

Do not drive for a long time at any single speed, either fast
or slow.

Do not tow a trailer during the first 800 km (500 miles)
OPERATION IN FOREIGN
COUNTRIES
If you plan to drive your Lexus in another country ...
First, comply with the vehicle registration laws.
Second, confirm the availability of the correct fuel (unleaded
and minimum octane rating).
TIPS FOR DRIVING IN VARIOUS
CONDITIONS

Always slow down in gusty crosswinds. This will allow you
much better control.

Drive slowly onto curbs and, if possible, at a right angle.
Avoid driving onto high, sharp-edged objects and other road
hazards. Failure to do so can lead to severe tire damage
resulting in tire bursts.

When parking on a hill, turn the front wheels until they touch
the curb so that the vehicle will not roll. Apply the parking
brake, and place the transmission in “P”. If necessary, block
the wheels.

Washing your vehicle or driving through deep water may get
the brakes wet. To see whether they are wet, check that
there is no traffic near you and then press the pedal lightly.
If you do not feel a normal braking force, the brakes are
probably wet. To dry them, drive the vehicle cautiously while
lightly pressing the brake pedal with the parking brake
pulled. If they still do not work safely, pull to the side of the
road and call a Lexus dealer for assistance.
CAUTION:

Before driving off, make sure the parking brake is fully
released and that the parking brake reminder light is
off.

DRIVING TIPS
127
Break-in schedule

Lexus recommends that you do not tow a trailer with a new
vehicle or a vehicle with any new power train component
(engine, transmission, differential, wheel bearing, etc.) for
the first 800 km (500 miles) of driving.
Maintenance

If you tow a trailer, your vehicle will require more frequent
maintenance due to the additional load. Refer to the
maintenance schedule under severe driving conditions
(Schedule A) in Section 5 for specific information.
Pre-towing safety check

Check that your vehicle remains level when a loaded or
unloaded trailer is hitched. Do not drive if the vehicle has an
abnormal nose-up or nose-down condition, and check for
improper tongue load, overload, worn suspension or other
possible causes.

Be sure the trailer cargo is securely loaded so that it can not
shift.
Check that your rear view mirrors conform to any applicable
federal, state / provincial or local regulation. If they do not,
install required rear view mirrors appropriate for towing
purposes.
Trailer towing tips
When towing a trailer, your vehicle will handle differently
than when not towing. The three main causes of
vehicle-trailer accidents are driver error, excessive speed
and improper trailer loading. Keep these in mind when
towing:

Before starting out, check operation of the lights and all
vehicle-trailer connections. After driving a short distance,
stop and recheck the lights and connections. Practice
turning, stopping and backing with a trailer in an area away
from traffic until you get the feel of it.