transmitter Lexus ES300 1999 Owner's Manuals (in English)

SECTION 1 ± 1
7
INSTRUMENTS AND CONTROLS
Keys and doors
Keys7
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . .
Engine immobiliser system 12
. . . . . . . . . . . . . . . . . . . . . .
Wireless remote control transmitter 15
. . . . . . . . . . . . . . .
Doors 21
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . .
KEYS
11L025-2

KEYS AND DOORS
9
Since a transponder chip is not built in this flat key,
you cannot start the engine with this key. Use this
key to release the lock in case you accidentally lock
your keys and wireless transmitter inside the
vehicle or trunk.
Insert your flat key in its key case as shown. We
recommend that you always carry this with you for
emergency use. Do not leave it in your vehicle.
NOTICE
Do not let the key case become bent as the key
may fall out or become bent also.
The flat key is designed for emergency useonly.

KEYS AND DOORS
15
For vehicles sold in Canada
This device complies with RSS±210 of Industry
Canada.
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must accept any
interference, including interference that may
cause undesired operation of the device.
WIRELESS REMOTE CONTROL TRANSMITTER
11E007

KEYS AND DOORS
16This transmitter has 4 functions.
1
Locking the doors
2Unlocking the doors
3Unlocking the trunk lid
4Sounding an alarm
When you operate a button on the transmitter, push it
slowly and surely.
The operational range of the wireless remote control is
approximately 1 meter (3 ft.). The effective range may
vary with different conditions.
If you lose the transmitter, contact your Lexus dealer as
soon as possible to avoid the possibility of theft, or an
accident. You can use up to 4 wireless remote control transmitters
for the same vehicle. Contact your Lexus dealer for
detailed information.
The wireless remote control transmitter is an
electronic component. Observe the following
instructions in order not to cause damage to the
transmitter.

Do not leave the transmitter on places where the
temperature becomes high such as on the
dashboard.
 Do not disassemble it.
 Avoid knocking it hard against other objects or
dropping it.
 Avoid putting it in water.

KEYS AND DOORS
17
Locking/Unlocking the doors
When you push the ºLOCKº button on the
transmitter, all the doors can be locked from outside
the vehicle.
At this time, the parking, tail, side marker and license
plate lights flash 1 time sounding 1 beep. However,
when you push the ºLOCKº button with any door not
closed securely, the buzzer sounds for 10 seconds or
until all the doors are closed securely. If the key is in the
ignition switch or any of the doors are open, locking
cannot be done.
Make sure all the doors are locked when you leave the
vehicle.
When you push the ºUNLOCKº button, the driver's
door is unlocked. Pushing that button once again
within 3 seconds from the first push, all other doors
also unlock.
At this time, two beeps sound. Together with the
activation of unlocking, the interior light comes on for 15
seconds if the interior light switch is in ºDOORº position.
However, this function does not work when the ignition
key is in the ºONº position. For further information, see
ºInterior lightsº on page 70.
You have 30 seconds to open a door after using the
wireless remote unlock feature. If a door is not opened
by then, all the doors will be automatically locked again.
If the ºLOCKº or ºUNLOCKº switch is kept pressed in, the

KEYS AND DOORS
19
Unlocking the trunk lid
11E002±2
When you keep the button pushed for about 1
second, you can unlock the trunk lid. One beep
sounds.
If the key is in the ignition switch, the trunk lid cannot be
unlocked with the transmitter.Sounding an alarm
11E003±3

SWITCHES
30The automatic light control sensor is on top of the
driver's side instrument panel.
Do not place anything on the instrument panel, and/or do
not affix anything on the windshield to block this sensor.
When the headlights come on, the lights automatically
turn off about 30 seconds after any of the doors is
opened and closed with the ignition key turned to the
ºACCº or ºLOCKº position. To turn them on again, turn
the ignition key to the ºONº position, or turn the headlight
switch off
and then twist the knob until the first or second
clickstop. If you are going to park for over one week,
make sure the headlight switch is off.
When the headlight switch is on with all the doors locked,
pushing the ºLOCKº button on the wireless remote
control transmitter turns off the headlights.
Daytime Running Light System
The headlights turn on at reduced intensity when the
parking brake is released with the engine started, even
with the light switch in the ºOFFº position. They will not
go off until the ignition switch is turned off.
To turn on the other exterior lights and instrument panel
lights, twist the knob to the first clickstop.
Twist the knob to the second clickstop to turn on the
headlights to full intensity for driving at night.
When setting the knob to the third clickstop (ºAUTOº),
the headlights will automatically adjust to full intensity
and/or turn on the other lights depending on the darkness of the surroundings. Likewise, as the
surroundings be
come brighter, the headlights will turn to
reduced intensity, ultimately turning off the other lights.
NOTICE
To prevent the battery from being discharged, do not leave the lights on longer than necessarywhen the engine is not running.

INTERIOR EQUIPMENT
83
The
HomeLink
 has 3 buttons and can be
programmed to operate 3 separate devices.
Prepare the HomeLink
 for programming by
erasing all codes or the memorized data
programmed by the former owner. Follow the
procedure in º(c) Erasing the garage door opener
memoryº.
1. Decide which one of the 3 buttons you want to
program. Push and hold down the button for about 20
seconds until the indicator light begins to flash. While
holding this button, follow steps º2º and º3º. 2. Bring the hand held garage door opener within about
25 mm (1 in.) of the button being programmed and push
the button on the hand held garage door opener. The
signal from the hand held garage door opener is sent to
the vehicle's opener.
3. When the frequency and code is registered, the
indicator light flashes rapidly. At this point, you can
release both buttons.
4. To program the remaining buttons, repeat steps º1º
through º3º.
If you want to replace an existing program with a new
program, select the button you want to
program. Follow
the procedure from step 1.
If the transmitter has a ºrolling code featureº, it is
necessary to program the in±garage receiver after
programming HomeLink
.
1. Locate the ºtrainingº or ºlearningº button on the
in±garage receiver and push and release this
button. Location of the button may vary by the
garage door opener manufacturer.
2. Firmly push and release the trained HomeLink

button 2 times (some garage door manufacturer
may require you to push the HomeLink button up
to 3 times) to complete the process.
The garage door should now operate when the
HomeLink
 button is pushed.

INTERIOR EQUIPMENT
84Do not use the HomeLink
 universal transmitter with
any garage door opener that lacks the safety stop and
reverse feature as required by Federal Safety
Standards. This includes any garage door opener
model manufactured before April 1, 1982.
CAUTION
When programming or operating the garage door
opener, make sure there is no one around the moving
door. It is dangerous if someone is caught.
(b) Operating the garage door opener
Push the appropriate button to activate the garage door
opener. The indicator light comes on. The garage door
opener continues to send the signal for up to 20 seconds
as long as the button is pushed.
(c) Erasing the garage door opener memory
Push and hold down the 2 outside buttons for about 20
seconds until the indicator light flashes. All memorized
data will be erased. FCC ID: CB2V94800
CANADA: 1763 102 264
This device complies with FCC Rules part 15.
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference that may be received,
including interference that may cause undesired
operation. WARNING: This transmitter has
been tested and complies with FCC and
DOC/MDC rules. Changes or modifications
not expressly approved by the partly
responsible for compliance could void the
user's authority to operate the device.

EXTERIOR EQUIPMENT
98
TRUNK LID
15E017
To unlock the trunk lid, insert the master key and
turn it clockwise.
To close the trunk lid, lower it and press down on it. After
closing the trunk lid, try pulling it up to make sure it is
securely closed.
The trunk lid can be unlocked using the wireless remote
control transmitter. For details, see page 19.
CAUTION
Keep the trunk lid closed while driving. This not only
keeps the luggage from being thrown out, but also
prevents exhaust gases from entering the vehicle.