stop start Lexus ES300 1999 Owner's Manuals (in English)

HOW TO USE THIS MANUAL
iv
HOW TO USE THIS MANUAL
The contents of this manual are explained briefly on
this page to help you make the best use of the
manual. Please read this page and the rest of the
Owner's Manual carefully to make sure you fully
understand the operation of your vehicle.
This will help you enjoy safe and comfortable
driving.
TABLE OF CONTENTS
The table of contents and the pictorial index provide
easy reference to the appropriate pages.
BASIC OPERATION ± QUICK REFERENCE
Operation of basic equipment is briefly explained in an
easily understandable way for quick reference.
SECTION 1 ± INSTRUMENTS AND
CONTROLS
The vehicle's equipment is divided into the 7 groups
listed below. Use of the equipment is explained,
including any points you should pay particular attention
to.
1. Keys and doors
2. Switches
3. Gauges, meters and service reminder indicators
4. Interior equipment5. Exterior equipment
6. Comfort adjustment
7. Theft deterrent
SECTION 2 ± AIR CONDITIONING AND AUDIO
The features of the vehicle's air conditioning and audio
are explained in detail. Be sure to read this section so
that you can make full use of them.
SECTION 3 ± STARTING AND DRIVING
Starting the engine, driving, stopping, operation of
features affecting vehicle handling, hints on vehicle
safety and safe driving techniques are all explained.
Please read everything in this section, and remember ±
drive safely!
SECTION 4 ± IN CASE OF AN EMERGENCY
This
section explains what to do in the event of an urgent
situation such as the engine not starting or getting a flat
tire, etc. If such a problem occurs, check the contents
of this Owner's Manual and follow the instructions given.
SECTION 5 ± MAINTENANCE
This section explains the importance of regular
maintenance. Regular and periodic inspection and
maintenance of your Lexus will help to keep your vehicle
in its best condition.
SECTION 6 ± SERVICE PROCEDURES AND

KEYS AND DOORS
10
11L021-1
When using a key containing a transponder chip,observe the following precautions:
When starting the engine, do not use the keywith a key ring resting on the key grip and donot press the key ring against the key grip.Otherwise the engine may not start, or maystop soon after it starts.

KEYS AND DOORS
11
11E016
When starting the engine, do not use the keywith other transponder keys around (includingkeys of other vehicles) and do not press otherkey plates against the key grip. Otherwise theengine may not start, or may stop soon after itstarts. If this happens, remove the key onceand then insert it again after taking off other
transponder keys (including keys of othervehicles) from the ring or while gripping orcovering them with your hand to start theengine.

SWITCHES
30The automatic light control sensor is on top of the
driver's side instrument panel.
Do not place anything on the instrument panel, and/or do
not affix anything on the windshield to block this sensor.
When the headlights come on, the lights automatically
turn off about 30 seconds after any of the doors is
opened and closed with the ignition key turned to the
ºACCº or ºLOCKº position. To turn them on again, turn
the ignition key to the ºONº position, or turn the headlight
switch off
and then twist the knob until the first or second
clickstop. If you are going to park for over one week,
make sure the headlight switch is off.
When the headlight switch is on with all the doors locked,
pushing the ºLOCKº button on the wireless remote
control transmitter turns off the headlights.
Daytime Running Light System
The headlights turn on at reduced intensity when the
parking brake is released with the engine started, even
with the light switch in the ºOFFº position. They will not
go off until the ignition switch is turned off.
To turn on the other exterior lights and instrument panel
lights, twist the knob to the first clickstop.
Twist the knob to the second clickstop to turn on the
headlights to full intensity for driving at night.
When setting the knob to the third clickstop (ºAUTOº),
the headlights will automatically adjust to full intensity
and/or turn on the other lights depending on the darkness of the surroundings. Likewise, as the
surroundings be
come brighter, the headlights will turn to
reduced intensity, ultimately turning off the other lights.
NOTICE
To prevent the battery from being discharged, do not leave the lights on longer than necessarywhen the engine is not running.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
58(n) Low fuel level Fill up tank.
warning light
(o) Key reminder buzzer Remove key.
(a) Brake System Warning Light
This light has the following two functions:
Parking brake reminder
If this light is on, make sure the parking brake is fully
released. The light should go off.
Low brake fluid level warning
If this light comes on and stays on while you are driving,
slow down and pull off the road. Then stop the vehicle
carefully. Remember that stopping distance and pedal
effort may be increased. There may be a problem
somewhere in the brake system. Check the fluid level
of the see±through reservoir.
To make sure the parking brake has not caused the
warning light to come on, check to see that the parking
brake is fully released.
If the brake fluid level is low ...
At a safe place, test your brakes by starting and
stopping.
 If you judge that the brakes still work adequately, drive
cautiously to your nearest dealer or shop for repairs.
 If the brakes are not working, have the vehicle towed
in for repairs. (For towing information, see page 337.)

GAUGES, METERS AND SERVICE REMINDER INDICATORS
60If the brake fluid level is correct ...
Have
the warning system checked by your Lexus dealer.
(b) Seat Belt Reminder Light and Buzzer
Once the ignition key is turned to ºONº or ºSTARTº, the
reminder light and buzzer come on if the driver's seat
belt is not fastened. Unless the driver fastens the belt,
the light stays on and the buzzer stops after about 4 to
8 seconds.
(c) SRS Warning Light
The indicator comes on when the ignition key is
turned to the ºACCº or ºONº position. It goes off
after about 6 seconds. This means the SRS is
operating properly.
The SRS warning light system monitors the airbag
sensor assemblies, front airbag sensors, inflators, seat
belt pretensioners, warning light, interconnecting wiring
and power sources.
If either of the following conditions occurs, this indicates
a malfunction somewhere in the parts monitored by the
warning light system. Contact your Lexus dealer as
soon as possible to service the vehicle.
The light does not come on as described above.
 The light stays on or flashes.
 The light comes on or starts flashing while driving.
If the light stays on, it indicates that the driver and front
passenger airbags fail. If the light flashes, the side
airbags and/or seat belt pretensioners fail.

COMFORT ADJUSTMENT
192
CAUTION
Do not start the vehicle while the adjustments are
being made.
 Take care not to select the wrong button, or the seat
could strike the rear passenger or hit your body
against the steering wheel. If this happens, you can
stop the movement by pressing another driving
position memory switch, or depressing the brake
pedal.

THEFT DETERRENT
195
If you lock them with wireless remote control, the turn
signals flash once.
The flashing indicator light will change to stay on when
all the doors, trunk and hood are closed and locked.
3. After 30 seconds, the indicator starts flashing
and the system is set.
Cancelling the system
When
you unlock any door or trunk using an ignition
key or wireless remote control, the system is
cancelled.
If you unlock any door or trunk with wireless remote
control, the turn signals flash twice.
Activating the system
The alarm sounds for 60 seconds if any of the following
are operated:

Unlocking any door or trunk without using an ignition
key or wireless remote control.

Opening the hood forcibly.

Reconnecting the battery.
If any door is unlocked and the ignition key is not in the
ignition switch during the alarm sounding, its door is
automatically locked. To stop the alarm: Use either of the following methods.


Unlock the door or trunk using an ignition key or
wireless remote control.

Turn the ignition switch on.
Testing the system
1. Open all the windows.
2. Set the system as described above.
The front doors should be locked with the ignition key or
wireless remote control. Be sure to wait until the
indicator light starts flashing.
3. Unlock one of the doors from the inside.
The system should activate the alarm.
4. Unlock any of the doors with a key or the wireless
remote control to cancel the system.
5. Repeat this operation for the other doors and
hood.
When testing the hood, also check that the system is
activated when the battery terminal is disconnected and
then reconnected.
If the system does not work properly, have it checked by
your Lexus dealer.

AIR CONDITIONING AND AUDIO
226When you insert a cassette tape, the exposed tape
should be to the right.
The player will automatically start when you insert a
cassette tape. At this time, ºTAPEº appears on the
display.
If a metal or chrome equivalent cassette
tape is put in the
cassette player, the player will automatically adapt to it
and ºMETALº appears on the display.
To stop or eject the cassette tape, push the ºEJECTº
button.
Auto±reverse feature: After the cassette player
reaches the end of a tape, it automatically reverses and
begins to play the other side, regardless of whether the
cassette was playing or fast forwarding.
20E023±1

STARTING AND DRIVING
270
(d) Backing up
31E010

1Brake pedal 2ºRº (Reverse) position
1. Bring the vehicle to a complete stop.
2. With the brake pedal held down with your foot, shift
the selector lever to the ºRº position.
NOTICE
Never shift into reverse while the vehicle ismoving.