Engine Lexus ES300 2000 s (in English) User Guide

KEYS AND DOORS
9
11L003a
Since a transponder chip is not built in this flat key,
you cannot start the engine with this key. Use this
key to release the lock in case you accidentally lock
your keys inside the vehicle or trunk.
Insert your flat key in its key case as shown. We
recommend that you always carry this with you for
emergency use. Do not leave it in your vehicle.NOTICE
Do not let the key case become bent as the keymay fall out or become bent also.
The flat key is designed for emergency useonly.

KEYS AND DOORS
10
11E021
When using a key containing a transponder chip,observe the following precautions:
When starting the engine, do not use the keywith a key ring resting on the key grip and donot press the key ring against the key grip.Otherwise the engine may not start, or maystop soon after it starts.

KEYS AND DOORS
11
11E022
When starting the engine, do not use the keywith other transponder keys around (includingkeys of other vehicles) and do not press otherkey plates against the key grip. Otherwise theengine may not start, or may stop soon after itstarts. If this happens, remove the key onceand then insert it again after taking off other
transponder keys (including keys of othervehicles) from the ring or while gripping orcovering them with your hand to start theengine.

KEYS AND DOORS
12
11E035
Do not bend the key grip.
Do not cover the key grip with any material thatcuts off electromagnetic waves.
Do not knock the key hard against otherobjects.
Do not leave the key exposed to hightemperatures for a long period, such as on the
dashboard and hood under the direct sunlight.
Do not put the key in water or wash it in an
ultrasonic washer.
Do not use the key with electromagneticmaterials.
ENGINE IMMOBILISER SYSTEM

KEYS AND DOORS
13
11E042
The engine immobiliser system is a theft prevention
system. When you insert the key in the ignition
switch, the transponder chip in the key's head
transmits an electronic code to the vehicle. The
engine will start, only when the electronic code in
the chip corresponds to the registered ID code for
the vehicle.
The system is automatically set when the key is
removed from the ignition switch. At this time, the
security indicator light flashes. When you insert the key
in the ignition switch, the security indicator light goes out
and the system is canceled automatically, which
enables the engine to start.
For your Lexus dealer to make you a new key with
built±in transponder chip, your dealer will need your key
number and master key. However, there is a limit to the
number of additional keys your Lexus dealer can make
for you. If you make your own duplicate key, you will not be
able to cancel the system or start the engine.
For vehicles sold in U.S.A.
FCC ID: MOZ RI±4ETY MADE IN JAPAN
This device complies with Part 15 of the FCC
Rules.
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.

SWITCHES
33
The automatic light control sensor is on top of the
driver's side instrument panel.
Do not place anything on the instrument panel, and/or do
not affix anything on the windshield to block this sensor.
When the headlights come on, the lights automatically
turn off about 30 seconds after any of the doors is
opened and closed with the ignition key turned to the
ªACCº or ªLOCKº position. To turn them on again, turn
the ignition key to the ªONº position, or turn the headlight
switch off
and then twist the knob until the first or second
clickstop. If you are going to park for over one week,
make sure the headlight switch is off. Daytime Running Light System
The headlights turn on at reduced intensity when the
parking brake is released with the engine started, even
with the light switch in the ªOFFº position. They will not
go off until the ignition switch is turned off.
To turn on the other exterior lights and instrument panel
lights, twist the knob to the first clickstop.
Twist the knob to the second clickstop to turn on the
headlights to full intensity for driving at night.
When setting the knob to the third clickstop (ªAUTOº),
the headlights will automatically adjust to full intensity
and/or turn on the other lights depending on the
darkness of the surroundings. Likewise, as the
surroundings
become brighter, the headlights will turn to
reduced intensity, ultimately turning off the other lights.
NOTICE
To prevent the battery from being discharged, do not leave the lights on longer than necessarywhen the engine is not running.

SWITCHES
49
To turn on the emergency flashers, push the switch.
All the turn signal lights will flash. The emergency
flashers
will work with the engine running or off and with
or without the ignition key.
Turn on the emergency flashers to warn other drivers if
you must stop your vehicle where it might be a traffic
hazard.
Always pull your vehicle as far off the road as possible.
The turn signal light switch will not work when the
emergency flashers are in operation.
NOTICE
To prevent the battery from being discharged, do not leave the switch on longer than necessarywhen the engine is not running.
SEAT HEATER SWITCHES
12E042

SWITCHES
52
NOTICE
Do not put unevenly weighted objects on theseat and do not stick sharp objects (needles,nails, etc.) into the seat.
When cleaning the seats, do not use organicsubstances (paint thinner, benzine, alcohol,gasoline, etc.). They may damage the heaterand seat surface.
To prevent the battery from being discharged,turn the switches on when the engine isrunning.

SECTION 1 ± 3
54
INSTRUMENTS AND CONTROLS
Gauges, meters and service reminder
indicators
Fuel gauge54
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Engine coolant temperature gauge 56
. . . . . . . . . . . . . . .
Tachometer 58
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Odometer and trip meter 58
. . . . . . . . . . . . . . . . . . . . . . . .
Service reminder indicators and warning buzzers 60 . . .
Instrument panel light control 69
. . . . . . . . . . . . . . . . . . . .
FUEL GAUGE
13E020

GAUGES, METERS AND SERVICE REMINDER INDICATORS
56
ENGINE COOLANT
TEMPERATURE GAUGE
13E018

Normal range
The gauge indicates the engine coolant temperature
when the ignition switch is on. The engine operating
temperature will vary with changes in weather and
engine load.
If the needle points to the red zone or higher, stop your
vehicle and allow the engine to cool.