alarm Lexus ES300 2000 Owner's Manuals (in English)
[x] Cancel search | Manufacturer: LEXUS, Model Year: 2000, Model line: ES300, Model: Lexus ES300 2000Pages: 501
Page 35 of 501
KEYS AND DOORS
15
1Locking the doors and sounding an alarm
2Indicator light
3Unlocking the trunk lid
4Unlocking the doors
When you operate any button on the key, push it slowly
and surely.
The operational range of the wireless remote control is
approximately 1 meter (3 ft.). The effective range may
vary with different conditions. To activate the wireless
remote control without fail, do it approximately 1 meter
(3 ft.) from your Lexus. In the following cases, the battery in the key may be
discharged. If this is a case, replace it using a special
screwdriver.
The remote control does not work.
The operational range of wireless remote control
becomes extremely short.
The indicator light on the key is dimmed or does not
come on.
For the replacement of the battery, see ªReplacing the
batteryº on page 22. You can also have the battery of the
key replaced by your Lexus dealer.
If you lose the wireless key, contact your Lexus dealer
as soon as possible to avoid the possibility of theft, or an
accident. (See ªIf you lose your keys or lock yourself outº
on page 371.)
You can use up to 4 wireless remote control keys for the
same vehicle. Contact your Lexus dealer for detailed
information.
The wireless remote control key is an electronic
component. Observe the following instructions in
order not to cause damage to the key.
Do not leave the wireless remote control key on
places where the temperature becomes high such as
on the dashboard.
Do not disassemble it.
Avoid knocking it hard against other objects or
Page 36 of 501
KEYS AND DOORS
16dropping it.
Avoid putting it in water.
Locking/Unlocking the doors
When you push the ªLOCKº button on the key
briefly, all the doors can be locked from outside the
vehicle.
At this time, one beep sounds and the parking lights and
tail lights flash once. However, when you push the
ªLOCKº button with any door not closed securely, the
buzzer sounds for 10 seconds. To stop the buzzer, close
all the doors securely or push the ªUNLOCKº button. If
the key is in the ignition switch, locking cannot be done.
Make sure all the doors are locked when you leave the
vehicle. Push the ªLOCKº button once again.
NOTICE
Do not push the ªLOCKº button any longer than 2 to 3 seconds. Pushing the button longeractivates an alarm. For details, see page 19.
When you push the ªUNLOCKº button, the driver's
door is unlocked. Pushing that button once again
within 3 seconds from the first push, all other doors
are also unlocked.
Page 39 of 501
KEYS AND DOORS
19
Unlocking the trunk lid
11E030
When you keep the button pushed for about 1
second, you can unlock the trunk lid. One beep
sounds.
This function does not work when the ignition key is in
the ªONº position.Sounding an alarm
11E024
Page 40 of 501
KEYS AND DOORS
20When you push the ªPANICº button for about 2 to 3
seconds, an alarm sounds to deter any person
trying to break into or damage your vehicle.
If you want to stop the alarm, push any button.
This function does not work when the ignition key is in
the ªONº position.
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
± Reorient or relocate the receiving antenna.
± Increase the separation between the
equipment and receiver.
± Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
± Consult the dealer or an experienced radio /
TV technician for help.
Page 226 of 501
THEFT DETERRENT
206
THEFT DETERRENT SYSTEM
To deter theft of the vehicle, this system is designed
to give an alarm if any of the doors, trunk or hood is
forcibly unlocked or the battery terminal is
disconnected and then reconnected while the
vehicle is locked.
The alarm blows the horn intermittently and flashes the
headlights, tail lights and other exterior lights.
17E003
Setting the system
1. Turn the ignition key to the ªLOCKº position and
remove it.
The indicator light flashes by means of the engine
immobiliser system.
2. Close and lock all the doors, trunk and hood
using an ignition key or wireless remote control.
Page 227 of 501
THEFT DETERRENT
207
If you lock them with wireless remote control, the parking
lights and tail lights flash once.
The flashing indicator light will change to stay on when
all the doors, trunk and hood are closed and locked.
3. After 30 seconds, the indicator starts flashing
and the system is set.
Cancelling the system
When
you unlock any door or trunk using an ignition
key or wireless remote control, the system is
cancelled.
If you unlock any door or trunk with wireless remote
control, the parking lights and tail lights flash twice.
Activating the system
The alarm sounds for 60 seconds if any of the following
are operated:
Unlocking any door or trunk without using an ignition
key or wireless remote control.
Opening the hood forcibly.
Reconnecting the battery.
If any door is unlocked and the ignition key is not in the
ignition switch during the alarm sounding, its door is
automatically locked. To stop the alarm: Use either of the following methods.
Unlock the door or trunk using an ignition key or
wireless remote control.
Turn the ignition switch on.
Testing the system
1. Open all the windows.
2. Set the system as described above.
The front doors should be locked with the ignition key or
wireless remote control. Be sure to wait until the
indicator light starts flashing.
3. Unlock one of the doors from the inside.
The system should activate the alarm.
4. Unlock any of the doors with a key or the wireless
remote control to cancel the system.
5. Repeat this operation for the other doors and
hood.
When testing the hood, also check that the system is
activated when the battery terminal is disconnected and
then reconnected.
If the system does not work properly, have it checked by
your Lexus dealer.
Page 322 of 501
STARTING AND DRIVING
302
VEHICLE SKID CONTROLSYSTEM
The vehicle skid control system helps provide
comprehensive control of the systems such as an
anti±lock brake system, brake assist system,
traction control, engine control, etc. This system
automatically controls the output of the brakes or
engine to help prevent the vehicle from skidding
when cornering on a slippery road surface or abrupt
steering wheel operation occurs.
31E013±1
Slip indicator light
If the vehicle is going to skid during driving, the slip
indicator light flashes and an alarm sounds
intermittently.
The vehicle skid control activates when the vehicle
speed is about more than 15 km/h (9 mph). You may hear a sound in the engine compartment for a
few seconds when the engine is started or just after the
vehicle is started. This means that the vehicle skid
control is in the self±check mode and does not indicate
a malfunction.
Page 325 of 501
STARTING AND DRIVING
305
CAUTION
Do not rely excessively on the vehicle skid control
system. Even if the vehicle skid control system is
operating, it is not that your vehicle is absolutely
safe. Reckless driving will result in an unexpected
accident. Always keep safety driving in mind. If the
slip indicator light flashes, sounding an alarm,
special care should be taken while driving.
Only use tires of specified size. The size,
manufacturer, brand and tread pattern for all 4 tires
should be the same. If you use the tires other than
specified, or different type or size, the vehicle skid
control system may not function correctly. When
replacing the tires or wheels, contact your Lexus
dealer.