ESP Lexus ES300 2002 s (in English) User Guide

COMFORT ADJUSTMENT
11 2
Front seat belt pretensioners
The driver and front passenger’s seat belt pretensioners
are designed to be activated in response to a severe
frontal impact.
When the airbag sensor detects the shock of a severe frontal
impact, the front seat belts are quickly drawn back in by the
retractors so that the belts snugly restrain the front seat
occupants.
The front seat belt pretensioners are activated even with no
passenger in the front seat.
This indicator comes on when the ignition key is turned to
the “ON” position. It goes off after about 6 seconds. This
means the front seat belt pretensioners are operating
properly.
This warning light system monitors the airbag sensor
assembly, front airbag sensors, side and curtain shield airbag
sensor assemblies, curtain shield airbag sensor assemblies,
driver’s seat position sensor, driver’s seat belt buckle switch,
front seat belt pretensioner assemblies, inflators, warning light,
interconnecting wiring and power sources. (For details, see
“Service reminder indicators and warning buzzers” on page 48
for instructions.)

COMFORT ADJUSTMENT
11 5
In the following cases, contact your Lexus dealer as soon as
possible:
The front of the vehicle (shaded in the illustration) was
involved in an accident that was not severe enough to cause
the front seat belt pretensioners to operate.
 Either front seat belt pretensioner assembly or surrounding
area is scratched, cracked, or otherwise damaged.
SRS AIRBAGS
The SRS (Supplemental Restraint System) airbags are
designed to provide further protection for the driver, front
passenger and rear outside passengers in addition to the
primary safety protection provided by the seat belts.
SRS front airbags
In response to a severe fr ontal impact, the SRS front
airbags work together with the seat belts to help reduce
injury by inflating. The SRS front airbags help to reduce
injuries mainly to the driver’s or front passenger’s head or
chest caused by directly hitting the steering wheel or
dashboard.
The front passenger airbag is activated even with no
passenger in the front seat.

COMFORT ADJUSTMENT
11 6Your vehicle is equipped with a crash sensing and diagnostic
module, which will record the use of the seat belt restraint
system by the
driver and front passenger when the SRS front
airbags are inflated.
Be sure to wear your seat belt properly.
CAUTION
The driver or front passenger who is too close to the
steering wheel or dashboard during airbag deployment
can be killed or seriously injured. Lexus strongly
recommends that:
 The driver sit as far back as possible from the
steering wheel while still maintaining control of the
vehicle.
 The front passenger sit as far back as possible from
the dashboard.
 All vehicle occupants be properly restrained using
the available seat belts.
SRS side airbags
In response to a severe side impact, the SRS side airbags
for the driver or front passenger work together with the
seat belts to help reduce injury by inflating. The SRS side
airbags help to reduce injuries mainly to the driver’s or
front passenger’s chest.
The SRS side airbag on the passenger seat is activated even
with no passenger in the front seat.
Your vehicle is equipped with a crash sensing and diagnostic
module, which will record the use of the seat belt restraint
system by the driver and front passenger when the SRS side
airbags are inflated.
Be sure to wear your seat belt properly.

COMFORT ADJUSTMENT
11 7
CAUTION
SRS side airbags inflate with considerable force. To
avoid potential death or serious injury when they inflate,
the driver and front passenger must:
 Wear their seat belts properly.
 Remain properly seated with their back upright and
against the seat at all times.
SRS curtain shield airbags for front and rear outside
occupants
In response to a severe side impact, the SRS curtain
shield airbag on either side works together with the seat
belts by inflating. The SRS curtain shield airbags help to
reduce injuries mainly to the driver’s head, front
passenger’s head and rear outside passenger’s head.
The SRS curtain shield airbag is activated even with no
passenger in the front seat or rear seat.
Your vehicle is equipped with a crash sensing and diagnostic
module, which will record the use of the seat belt restraint
system by the driver and front passenger when the SRS
curtain shield airbags are inflated.
Be sure to wear your seat belt properly.

COMFORT ADJUSTMENT
11 9
The SRS front airbag system is designed to activate in
response to a severe frontal impact within the shaded area
between the arrows in the illustration.
The SRS front airbags will deploy if the severity of the impact
is above the designed threshold level, comparable to an
approximate 25 km/h (15 mph) collision when impacting
straight into a fixed barrier that does not move or deform.
If the severity of the impact is below the above threshold level,
the SRS front airbags may not deploy.However, this threshold velocity will be considerably higher if
the vehicle strikes an object, such as a parked vehicle or sign
pole, which can move or deform on impact, or if it is involved
in an underride collision (e.g. a collision in which the nose of
the vehicle “underrides”, or goes under, the bed of a truck,
etc.).
It is possible that in some collisions at the lower zone of airbag
sensor
detection and activation the SRS airbags and seat belt
pretensioners will not operate all together.
For the safety of all occupants, always wear your seat belts
properly.

COMFORT ADJUSTMENT
125
Do not sit on the edge of the seat or lean over the
dashboard when the vehicle is in use, since the front
airbags inflate with considerable speed and force.
Otherwise, you may be killed or seriously injured. Sit
up straight and well back in the seat, and always use
your seat belt properly. Do not lean against the front door when the vehicle
is in use, since the side airbag and curtain shield
airbag inflate with considerable speed and force.
Otherwise, you may be killed or seriously injured.
Special care should be taken especially when you
have a small child in the vehicle.
 Sit up straight and well back in the seat, distributing
your weight evenly in the seat. Do not apply
excessive weight to the outer side of the front seats
on vehicles with side airbags.

COMFORT ADJUSTMENT
126
Do not get your head closer to the area where the side
airbag and curtain shield airbag inflate. These
airbags inflate with considerable speed and force.
Otherwise, you may be killed or seriously injured.
Special care should be taken especially when you
have a small child in the vehicle.
 Do not allow a child to kneel on the passenger seat
facing the passenger’s side door. The side airbag
and curtain shield airbag inflate with considerable
speed and force; the child may be killed or seriously
injured. Do not allow a child to stand up or to kneel on the
front passenger seat, since the front airbag inflates
with considerable speed and force. Otherwise, the
child may be killed or seriously injured.
 Do not hold a child on your lap or in your arms. Use
a child restraint system in the rear seat. For
instructions concerning the installation of a child
restraint system, see “Child restraint” on page 131.

AIR CONDITIONING
161
(a) Climate control
SETTING OPERATION automatic control
1. Push the “AUTO” button.
An indicator light will illuminate to show that the automatic
operation mode has been selected.
Air flow quantity, switching of the diffusers, onoff of the air
conditioning and switching of the air intake between
RECIRCULATED AIR and OUTSIDE AIR are automatically
adjusted. The operation status is shown by each indicator.
When one of the manual control buttons is depressed while
operating in automatic mode, the operation corresponding to
the button depressed is set. Other conditions continue to be
adjusted automatically.
Push the “OFF” button to turn the air conditioning system off.
2. Use the “TEMP” or “PASSENGER TEMP” button to set
the desired temperature.
The “TEMP” or “PASSENGER TEMP” button is used to set the
desired temperature. The temperature will be controlled on the
driver and passenger sides simultaneously or individually.
“TEMP” button—Changes the temperature on the driver and
passenger sides simultaneously or the driver side only.
“PASSENGER TEMP” button—Changes the temperature on
the passenger side only.
“DUAL” button— Changes the mode of the temperature
setting.
The indicator on the “DUAL” button has two modes:
 With the indicator on— For individual temperature setting
 With the indicator off— For simultaneous temperature
setting

AUDIO
177
(c) Automatic sound levelizer
When the audio sound becomes difficult to be heard due to
road noise, wind noise, etc. during driving, the system adjusts
to the optimum volume and tone quality according to the noise
level. While the automatic sound levelizer is on, “ASL” appears
on the display.
(d) Your radio antennas
The wire antenna is mounted inside the rear window.
NOTICE

When cleaning the inside of the rear window, be
careful not to scratch or damage the wire antenna.
 Putting a window tint (especially, conductive or
metallic type) on the rear window may affect the
reception of radio or mobile telephone. For the
installation of the window tint, consult with your
Lexus dealer.
(e) Your cassette player
When you insert a cassette, the exposed tape should face to
the right.
NOTICE
Do not oil any part of the cassette player, and do not
insert anything except a cassette tape into the slot.
(f) Your compact disc player
When you insert a disc, gently push it in with the label face up.
(The player will automatically eject a disc if the label face is
down.) The compact disc player will play from track 1 through
the end of the disc. Then it will play from track 1 again. On
models with the compact disc auto changer, next disc will be
played from track 1.
NOTICE
 Never try to disassemble or oil any part of the
compact disc player. Do not insert anything except
a compact disc into the slot.
 Do not insert a disc upon another one.
The player is intended for use with 12 cm (4.7 in.) discs only.

AUDIO
182(c) Automatic program selection
“RPT” button: The repeat feature automatically replays the
current program.
Push
the “RPT” button while the program is playing. When the
program ends, it will automatically be rewound and replayed.
Push the button again to turn off the repeat feature.
There must be at least 3 seconds of blank space between
programs for the repeat feature to work correctly.
“SKIP” button: The skip feature allows you to fast forward
past long stretches of blank tape. This is especially useful at
the end of cassettes.
Push the “SKIP” button. The player will automatically skip any
blank portions of 15 seconds or more and play the next
program. To cancel it, push the button once again.
“Automatic program selection” button: The automatic
program selection feature allows you to program your cassette
player to skip forward or backward to locate the song you want
to hear. You can skip up to 9 programs at a time.
Push this button on the upper side to skip forward. “FF” and
the number will appear on the display . Push the button until the
number you want to skip appears on the display. After that, the
player will automatically skip forward.
When the end of the tape is reached, the player automatically
reverses sides and resumes normal play.