fuel filter Lexus ES300 2002 Owner's Manuals (in English)

62L0051
Temperature range anticipated before next oil change
ENGINE
298Oil capacity
Drain and refillWith filter
Without filter
Oil grade
Recommended oil viscosity (SAE):
4.7 L (5.0 qt., 4.1 lmp. qt.)
4.5 L (4.8 qt., 4.0 lmp. qt.)
API grade SJ “EnergyConserving”,
SL “EnergyConserving” or ILSAC multigrade engine oil
COOLING SYSTEM
Capacity
Coolant type
9.2 L (9.7 qt., 8.2 lmp. qt.)
“Toyota Long Life Coolant” or equivalent
With ethyleneglycol type coolant for a proper corrosion
protection of aluminum components
Do not use alcohol type antifreeze or plain water alone.
FUEL
Fuel type
Octane Rating
Only UNLEADED
91 (Research Octane Number 96) or higher
IGNITION SYSTEM

ENGINE
303
Importance of engine oil level check
One of the most important points in proper vehicle
maintenance is to keep the engine oil at the optimum level so
that oil function will not be impaired. Therefore, it is essential
that the oil level be checked regularly. Lexus recommends that
the oil level be checked every time you refuel the vehicle.
NOTICE
Failure to check the oil level regularly could lead to
serious engine trouble due to insufficient oil.
For detailed information on oil level check, see “Checking the
engine oil level” on page 304.
USED ENGINE OIL
CAUTION
 Used engine oil contains potentially harmful
contaminants which m ay cause skin disorders such
as inflammation or skin cancer, so care should be
taken to avoid prolonged and repeated contact with
it. To remove used engine oil from your skin, wash
thoroughly with soap and water.
 Do not leave used oil within the reach of children.
 Dispose of used oil and used oil filters only in a safe
and acceptable manner. Do not dispose of used oil
and used oil filters in household trash, in sewers or
onto the ground. Call your Lexus dealer or a service
station for information concerning recycling or
disposal.

GAS STATION INFORMATION
Fuel selection:
Select premium unleaded gasoline with an Octane Rating
of 91 (Research Octane Number 96) or higher for optimum
engine performance. However, if such premium type
cannot be obtained, you may temporarily use unleaded
gasoline with an Octane Rating as low as 87 (Research
Octane Number 91).
 Fuel tank capacity:
70 L (18.5 gal., 15.4 lmp. gal.)
 Engine oil:
API grade SJ “EnergyConserving”, SL
“EnergyConserving” or ILSAC multigrade engine oil
Recommended oil viscosity SAE 5W30 if normal
temperatures are below 38 C (100 F)
Oil capacity: L (qt., lmp. qt.)
Drain and refill With filter 4.7 (5.0, 4.1)
Without filter 4.5 (4.8, 4.0)
See page 304 for detailed information. 
Engine coolant:
Capacity: 9.2 L (9.7 qt., 8.2 lmp. qt.)
Coolant type “Toyota Long Life Coolant” or equivalent
With ethyleneglycol type coolant for a proper corrosion
protection of aluminum components
Do not use alcohol type antifreeze or plain water alone.
For checking the engine coolant, see page 306 .
 Automatic transaxle:
Fluid type Automatic transmission fluid Type TIV
See page 310 for detailed information.
 Tire information:
See pages 315 through 321 for detailed information.
 Tire pressure:
Tire size: P215/60R16 94V
Tire pressure:
Front 200 kPa (2.0 kgf/cm
2 or bar, 29 psi)
Rear 200 kPa (2.0 kgf/cm2 or bar, 29 psi)
For sustained high speeds above 160 km/h (99 mph), in
countries where such speeds are permitted by law, add 40
kPa (0.4 kgf/cm
2 or bar, 6 psi) to the front tires and rear tires,
but never exceed the maximum cold tire pressure molded
on the tire sidewall.