service LEXUS ES300 2005 Repair Manual
[x] Cancel search | Manufacturer: LEXUS, Model Year: 2005, Model line: ES300, Model: LEXUS ES300 2005Pages: 969, PDF Size: 24.08 MB
Page 960 of 969

RESET MEMORY FUNCTION ± TC002-03 Revised May 5, 2003
Page 2 of 3
SPECIAL SERVICE TOOLS (SSTs)PART NUMBERQUANTITY
Lexus Diagnostic Tester Kit*010012701
CAN Interface Module Kit*010027441
12 Megabyte Diagnostic Tester Program Card
with version 12.01a Software (or later)*01002593-0051
* Essential SSTs.
NOTE:
Additional Diagnostic Tester Kits, CAN Interface Modules, Program Cards or other
SSTs may be ordered by calling SPX/OTC at 1-800-933-8335.
1. Connect the Lexus Diagnostic Tester to the vehicle.
2. Reset the ECM (PCM). Refer to the procedures below.
DO YOU WISH TO
RESET THE ECM?
[YES] to CONTINUE
[NO] to EXIT
2: CUSTOMIZE
3: ECU REPROGRAMFUNCTION SELECT FOR
NORTH AMERICA
B
*APPLICATION SELECT*
A
1: DIAGNOSISDIAGNOSTIC MENU
ENGINE
C
DO NOT USE THIS
FUNCTION UNLESS
INSTRUCTED BY
REPAIR MANUAL.RESET MEMORY
E
RESET MEMORY
NOTICE
D
[YES]
F
1: OBD/MOBD
3: CARB OBD II
4: BREAK±OUT BOX
5: NVH
6: AUTOPROBE
7: 02 RPM CHECK
8: SNAPSHOT REVIEW
9: SETUP
0: GAS ANALYSIS2: ENHANCED OBD II1: DATA LIST
2: DTC INFO
3: ACTIVE TEST
4: SNAPSHOT
5: SYSTEM CHECK
6: RESET MEMORY
7: MONITOR STATUS
8: CHECK MODE
6: RESET MEMORY
ONLY USE AFTER
REPLACING THE ENGINE,
AUTO TRANS, OR ECM
ON CERTAIN VEHICLES.EXECUTING THIS
FUNCTION WILL RESET
THE LEARNED VALUES
IN THE ECM.RESET MEMORY
RESETTING COMPLETE
PRESS
[ENTER]
3. Start the engine and warm it up to normal operating temperatures before test±driving.
4. Perform a thorough test drive with several accelerations from a stop with ªlight
throttleº application until proper transmission shifting is verified.
Required
SSTs
Reset
Procedure 1
Page 962 of 969

Lexus Supports ASE CertificationPage 1 of 6
Title:
ECM CALIBRATION: SHIFT FEELING
ENHANCEMENT
Models:
'02 ± '03 ES 300 & '04 ± '05 ES 330
Technical Service
Information Bulletin
August 4, 2003
TC004-03
REVISION NOTICE:
April 1, 2005: 2004 ± 2005 model year ES 330 vehicles have been added to
Applicable Vehicles. Introduction and Note have been updated on page 1.
Calibration Identification Chart has been updated to include ES 330 calibration IDs.
August 6, 2003: There has been a change in Warranty Time.
Previous versions of this TSIB should be discarded.
To improve the transmission shift feeling during specific operating modes, the Engine
Control Module (SAE term: Powertrain Control Module/PCM) calibration has been
revised. These improvements include:
Reduced downshift lag when accelerating at speeds from 10 to 20 mph.
Less gear hunting when driving on/off accelerator pedal at 20 to 30 mph
(for example: during heavy rush±hour traffic).
Improved response rate during heavy acceleration from a stop.
NOTE:
Version 12.01a or later Diagnostic Tester software is required to perform
this procedure.
Before proceeding, verify the ECM (PCM) calibration has NOT been updated by
checking for the Authorized Modifications Label (shown in step 1 of the
Repair Procedure).
Harsh ATM shifting may result if any Repair Procedure steps are omitted
(specifically steps 2 and 4 of ªFlash Reprogram ECMº on page 6).
2002 ± 2003 model year ES 300 vehicles.
2004 ± 2005 model year ES 330 vehicles.
OP CODEDESCRIPTIONTIMEOFPT1T2
EG5017Recalibrate ECM Engine & Transmission0.9
89666±3325#
89666±3344#
89661±33B3#
89661±33A4#
2699
Applicable Warranty*:
This repair is covered under the Lexus Federal Emissions Warranty. This warranty is
in effect for 96 months or 80,000 miles, whichever occurs first, from the vehicle's
in-service date.
* Warranty application is limited to correction of a problem based upon a customer's specific complaint.
TRANSMISSION & CLUTCH
Introduction
Applicable
Vehicles
Warranty
Information
Page 963 of 969

ECM CALIBRATION: SHIFTING ENHANCEMENT ± TC004-03 Revised August 4, 2003
Page 2 of 6
PREVIOUS PART NUMBERCURRENT PART NUMBERPART NAMEQTY
N/A00451±00001±LBLAuthorized Modifications Label1
NOTE:
Authorized Modification Labels may be ordered in packages of 25 from the Materials
Distribution Center (MDC) through Dealer Daily Dealer Support Materials System or by
calling the MDC at 1±800±622±2033.
SPECIAL SERVICE TOOLS (SSTs)PART NUMBERQTYDRW**
CAN Interface Module Kit*0100274418
Lexus Diagnostic Tester Kit*0100127018
12 Megabyte Diagnostic Tester Program Card
with version 12.01a Software (or later)*01002593-005
(Component of 01001270)1
* Essential SSTs.
** Refers to drawer number in SST Storage System.
NOTE:
Additional Diagnostic Tester Kits, CAN Interface Modules, Program Cards, or other
SSTs may be ordered by calling SPX/OTC at 1-800-933-8335. Parts
Information
Required
SSTs