oil dipstick Lexus GS300 2019 Owner's Manual

378
GS350_300_OM_OM30G96U_(U)6-3. Do-it-yourself maintenance
Engine compartment
GS350
Fuse boxes (
P. 414)
Battery (P. 392)
Engine oil level dipstick (P. 383)
Engine coolant reservoir (P. 388)
Engine oil filler cap ( P. 385) Brake fluid reservoir
(P. 391)
Washer fluid tank ( P. 394)
Electric cooling fans
Condenser ( P. 390)
Radiator ( P. 390)1
2
3
4
5
6
7
8
9
10

GS350_300_OM_OM30G96U_(U)
3796-3. Do-it-yourself maintenance
6
Maintenance and care
GS300
Fuse boxes (P. 414)
Battery (P. 392)
Intercooler coolant reservoir (P. 388)
Engine oil level dipstick (P. 383)
Engine oil filler cap ( P. 385) Engine coolant reservoir
(P. 388)
Brake fluid reservoir (P. 391)
Washer fluid tank ( P. 394)
Condenser ( P. 390)
Electric cooling fans
Radiator ( P. 390)1
2
3
4
5
6
7
8
9
10
11

380
GS350_300_OM_OM30G96U_(U)6-3. Do-it-yourself maintenance
GS F
Fuse boxes (
P. 414)
Battery (P. 392)
Engine oil level dipstick (P. 383)
Engine coolant reservoir (P. 388)
Engine oil filler cap ( P. 385) Brake fluid reservoir
(P. 391)
Washer fluid tank ( P. 394)
Electric cooling fans
Condenser ( P. 390)
Radiator ( P. 390)1
2
3
4
5
6
7
8
9
10

GS350_300_OM_OM30G96U_(U)
3836-3. Do-it-yourself maintenance
6
Maintenance and care
With the engine at operating temperature and turned off, check the oil level on
the dipstick.
■Checking the engine oil
Park the vehicle on level ground. Afte r warming up the engine and turning
it off, wait more than 5 minutes for the oil to drain back into the bottom of
the engine.
Holding a rag under the end, pull the dipstick out.
Wipe the dipstick clean.
Engine oil
1
2
GS350GS300
GS F
3

384
GS350_300_OM_OM30G96U_(U)6-3. Do-it-yourself maintenance
Reinsert the dipstick fully.
Holding a rag under the end, pull the dipstick out and check the oil level.
Low
Normal
Excessive
The shape of the dipstick may differ depending on the type of vehicle or engine.
Wipe the dipstick and reinsert it fully.
4
5
1
2
3
Flat dipstickNon-flat dipstick
6

GS350_300_OM_OM30G96U_(U)
3856-3. Do-it-yourself maintenance
6
Maintenance and care
■Adding engine oil
If the oil level is below or near the low level mark, add engine oil of the same
type as that already in the engine.
Make sure to check the oil type and prepare the items needed before adding
oil.
Remove the oil filler cap by turning it counterclockwise.
Add engine oil slowly, checking the dipstick.
Install the oil filler cap by turning it clockwise.
GS350GS300
GS F
Engine oil selection P. 526, 528
Oil quantity (Low  Full) 1.6 qt. (1.5 L, 1.3 Imp.qt.)
Items Clean funnel
1
2
3

GS350_300_OM_OM30G96U_(U)
3876-3. Do-it-yourself maintenance
6
Maintenance and care
NOTICE
■To prevent serious engine damage
Check the oil level on a regular basis.
■When replacing the engine oil
●Be careful not to spill engine oil on the vehicle components.
●Avoid overfilling, or the engine could be damaged.
●Check the oil level on the dipstick every time you refill the vehicle.
●Be sure the engine oil filler cap is properly tightened.

526
GS350_300_OM_OM30G96U_(U)8-1. Specifications
GS350/GS300
*: The engine oil capacity is a reference quantity to be used when changing the engine
oil. Warm up and turn off the engine, wait more than 5 minutes, and check the oil level
on the dipstick.
■Engine oil selection
“Toyota Genuine Motor Oil” is used in your Lexus vehicle. Use Lexus
approved “Toyota Genuine Motor Oil” or equivalent to satisfy the following
grade and viscosity.
Oil grade: ILSAC GF-5 multigrade engine oil
Lubrication system
GS350GS3002WDAWD
Oil capacity
(Drain and refill 
reference
*)
With filter
Without filter
6.0 qt.
(5.7 L, 5.0 Imp.qt.)
5.8 qt.
(5.5 L, 4.8 Imp.qt.)6.8 qt.
(6.4 L, 5.6 Imp.qt.)
6.3 qt.
(6.0 L, 5.3 Imp.qt.)4.9 qt.
(4.6 L, 4.0 Imp.qt.)
4.5 qt.
(4.3 L, 3.8 Imp.qt.)

GS350_300_OM_OM30G96U_(U)
5278-1. Specifications
8
Vehicle specifications
Recommended viscosity: SAE 0W-20
SAE 0W-20 is the best choice for
good fuel economy and good start-
ing in cold weather.
If SAE 0W-20 is not available, SAE
5W-20 oil may be used. However, it
must be replaced with SAE 0W-20
at the next oil change.
Oil viscosity (0W-20 is explained here as an example):• The 0W in 0W-20 indicates the characteristic of the oil which allows cold startability. Oils with a lower value be fore the W allow for easier starting of
the engine in cold weather.
• The 20 in 0W-20 indicates the viscos ity characteristic of the oil when the
oil is at high temperature. An oil with a higher viscosity (one with a higher
value) may be better suited if the vehicle is operated at high speeds, or
under extreme lo ad conditions.
How to read oil container label:
The International Lubricant Specifi-
cation Advisory Committee
(ILSAC) Certification Mark is added
to some oil containers to help you
select the oil you should use.
GS F
*: The engine oil capacity is a reference quantity to be used when changing the engine oil. Warm up and turn off the engine, wait more than 5 minutes, and check the oil level
on the dipstick.
Outside temperature
Oil capacity
(Drain and refill — reference*)
With filter
Without filter9.3 qt. (8.8 L, 7.7 Imp.qt.)
8.3 qt. (7.9 L, 7.0 Imp.qt.)